That way the radar errors aren't enabled prematurely.
A DFS tester has reported that radar events are reported
during channel scanning, before DFS is actually enabled.
Use the offset into the device tree from fdtp as the phandle instead
of using pointer into the device tree. This will make sure that the
phandle fits into a uint32_t type, even when compiled for 64bit.
Reviewed by: raj, nathanw, marcel
on the largest multi-write size.
From the submitter:
==
I looked further into the magic 88-byte threshold after which the bug
occurs. It turns out that figure included the 24-byte tx_desc, and up
to 64 bytes of beacon frame (header+data).
rum_write_multi doesn't seem happy with writing >64 bytes at a time to
the MAC register. If I break it up into separate calls (e.g. bytes
0-63, then bytes 64-65, written at the appropriate offset) I see the
proper beacon frames being transmitted now.
==
Submitted by: Steven Chamberlain <steven@pyro.eu.org>
MFC after: 3 days
Reading /dev/mem in 64 bit kernel crashes. This is because the page
used to call uiomove_fromphys() from memrw() does not have md.pv_list
initialized correctly.
The fix is to call pmap_page_init() on the page to initialize it.
separation rewrite changes. r196865 was committed to fix a scope
violation problem in the following test scenario:
box-1# ifconfig em0 inet6 2001:db8:1:: prefixlen 64 anycast
box-1# ifconfig em1 inet6 2001:db8:2::1 prefixlen 64
box-2# ifconfig re0 inet6 2001:db8:1::6 prefixlen 64
em0 and re0 are on the same link.
box-2# ping6 2001:db8:1::
PING6(56=40+8+8 bytes) 2001:db8:1::6 --> 2001:db8:1::
the ICMPv6 response should have a source address of em1, which
is 2001:db8:2::1, not the link-local address of em0.
That code is no longer necessary and breaks the IPv6-Ready logo
testing, so revert it now.
Reviewed by: hrs
MFC after: 3 days
long been superseded by the RFC3390 initial CWND sizing.
Also remove the remnants of TCP_METRICS_CWND which used the
TCP hostcache to set the initial CWND in a non-RFC compliant
way.
MFC after: 1 week
- A race condition could happen if two threads were using RAS at the same time
as the code didn't reset RAS_END, the RAS code could believe we were not in
a RAS, when we were in fact.
- Using signed value logic to compare addresses wasn't such a good idea.
Many thanks to Ian to investigate on these issues.
Pointy hat to: cognet
PR: arm/161498
Submitted by: Ian Lepore <freebsd At damnhippie DOT dyndns dot org
MFC after: 1 week
page has been allocated, or we could end up using random values, and bad things
could happen.
PR: arm/161492
Submitted by: Ian Lepore <freebsd AT damnhippie dot dyndns DOT org>
MFC after: 1 week
This fixes a compiler warning at WARNS=6 when including the header files
as follows:
#include <sys/types.h>
#include <netinet/in.h>
#include <netinet/ip_var.h>
#include <netinet/udp.h>
#include <netinet/udp_var.h>
To run a /31 network, participating hosts MUST drop support
for directed broadcasts, and treat the first and last addresses
on subnet as unicast. The broadcast address for the prefix
should be the link local broadcast address, INADDR_BROADCAST.
- Remove ia_net, ia_netmask, ia_netbroadcast from struct in_ifaddr.
- Remove net.inet.ip.subnetsarelocal, I bet no one need it in 2011.
- fix bug when we were not forwarding to a host which matches classful
net address. For example router having 192.168.x.y/16 network attached,
would not forward traffic to 192.168.*.0, which are legal IPs in
CIDR world.
- For compatibility, leave autoguessing of mask based on class.
Reviewed by: andre, bz, rwatson
* Break out the PCI setup override code into a new function.
* Re-apply the PCI overrides on powersave resume. The retry timeout
register isn't currently being saved/resumed by the PCI driver/bus
code.
inlined by Qing Li in his big new-ARP commit. I am going to utilize
them in my newcarp work, and also these functions left declared
in in6_var.h for all the time they were absent.
Reviewed by: bz
