using a driver-supplied sbuf for printing device discovery
announcements. This helps ensure that messages to the console
will be properly serialized (through sbuf_putbuf) and not be
truncated and interleaved with other messages. The
infrastructure mirrors the existing xpt_announce_periph()
entry point and is opt-in for now. No content or formatting
changes are visible to the operator other than the new coherency.
While here, eliminate the stack usage of the temporary
announcement buffer in some of the drivers. It's moved to the
softc for now, but future work will eliminate it entirely by
making the code flow more linear. Future work will also address
locking so that the sbufs can be dynamically sized.
The scsi_da, scs_cd, scsi_ses, and ata_da drivers are converted
at this point, other drivers can be converted at a later date.
A tunable+sysctl, kern.cam.announce_nosbuf, exists for testing
purposes but will be removed later.
TODO:
Eliminate all of the code duplication and temporary buffers. The
old printf-based methods will be retired, and xpt_announce_periph()
will just be a wrapper that uses a dynamically sized sbuf. This
requires that the register and deregister paths be made malloc-safe,
which they aren't currently.
Sponsored by: Netflix
of our tweaked modes based on it. In practice, this means limiting the
tweaked modes to at most 80x50 based on 80x25, so there are no 90-column,
80x30 or 80x60 modes.
This happens when the the initial mode is is not in the parameter
table. We always detected this case, but assumed that the (necessarily
nonstandard) parameters of the initial mode could be tweaked just as
blindly as the probably-standard parameters of initial modes in the
table.
On 1 laptop system with near-VGA where the initial mode is nonstandard,
this is because the hardware apparently doesn't support 9-bit mode,
but otherwise has standard timing. The initial mode has 8-bit mode
CRTC horizontal parameters similar to those in syscons' 90-column modes
and in EGA modes. Tweaking these values for the 90-column modes has
little effect except to print the extra 10 columns off the screen.
Tweaking from 80x25 to 80x30 requires changing from 400 scan lines to
480. This can probably be made to work, but syscons blindly applies
values based on standard timing. This gives blank output. Tweaking
from 80x25 to 80x50 doesn't change the CRTC timing and works.
This is not fully fleshed out but is sufficient to dump the
SHT_MIPS_ABIFLAGS used in FreeBSD.
Reviewed by: imp
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8241
kit, CK, in the LinuxKPI.
When threads are pinned to a CPU core or when there is only one CPU,
it can happen that a higher priority thread can call the CK
synchronize function while a lower priority thread holds the read
lock. Because the CK's synchronize is a simple wait loop this can lead
to a deadlock situation. To solve this problem use the recently
introduced CK's wait callback function.
When detecting a CK blocking condition figure out the lowest priority
among the blockers and update the calling thread's priority and
yield. If another CPU core is holding the read lock, pin the thread to
the blocked CPU core and update the priority. The calling threads
priority and CPU bindings are restored before return.
If a thread holding a CK read lock is detected to be sleeping, pause()
will be used instead of yield().
MFC after: 1 week
Sponsored by: Mellanox Technologies
CPUs when allocating a LinuxKPI workqueue. This also ensures that the
created taskqueue always have a non-zero number of worker threads.
MFC after: 1 week
Sponsored by: Mellanox Technologies
According to Warner, multiple TRIM BIOs are collapsed into a single CCB with
NULL bp. It is invalid to biotrack() NULL, and results in a fault. So,
don't do that.
Reported by: asomers@
Sponsored by: Dell EMC Isilon
Note that this commit also adds the default riscv settings for all
options since riscv was added to 'make targets' since the last time
this was generated.
Reminded by: emaste
As the uboot disk interface is using common/disk.c API, we also
should use disk_ioctl() call, this will give us chance to read partition
sizes and have feature parity with UEFI and BIOS implementations.
This does also fix arm boot issue on some systems, reported/tested by Ian,
thanks.
Reported by: ian
Reviewed by: ian
Differential Revision: https://reviews.freebsd.org/D10421
The work to make it possible to avoid bcache via using F_NORA modifier did
miss the fact that not all loader platforms are using the bcache, and so
it is possible the modifier is not cleared, as bcache strategy function is
not used.
For fix, we make sure the checks are dont with masked flag.
This patch does fix boot for platforms which do not use bcache.
Reported by: emaste
Reviewed by: emaste
Differential Revision: https://reviews.freebsd.org/D10422
GDB in ports contains all of the functionality as GDB in base
(including kgdb) for these platforms along with additional
functionality. In-tree GDB remains enabled on ARM and sparc64.
GDB in ports does not currently support kernel debugging on arm,
and ports GDB for sparc64 has not been tested (though it does
include sparc64 support).
Reviewed by: bdrewery, emaste, imp
Relnotes: yes
Sponsored by: DARPA / AFRL
Differential Revision: https://reviews.freebsd.org/D10399
The smallest device we can have in the pool is 64MB, since we are trying to
walk all four labels to find the most up to date uberblock, this limit will
also give us good method to check if we even should attempt to probe.
Enforcing the check also will make sure we are not getting wrapped while
calculating the label offset.
Also, after label check, we should verify if we actually got any UB or not.
PR: 218473
Reported by: Masachika ISHIZUKA
Reviewed by: allanjude
Differential Revision: https://reviews.freebsd.org/D10381
Add early init handler, which comprises various internal
bus optimisations for Armada 38x SoC's. Magic values used
due to undocumented registers.
Submitted by: Marcin Wojtas <mw@semihalf.com>,
Arnaud Ysmal <arnaud.ysmal@stormshield.eu>
Obtained from: Semihalf, Stormshield
Sponsored by: Stormshield
Differential revision: https://reviews.freebsd.org/D10219
Part of PL310 erratum 727915 in pl310_wbinv_range() was
executed uncoditionally for all possible controllers'
revisions. This patch adds appropriate condition, since
extra operations are required only for revisions between
r2p0 and r3p0.
Submitted by: Marcin Wojtas <mw@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: meloun-miracle-cz
Differential revision: https://reviews.freebsd.org/D10221
Introduce machine-dependent part of the arm/pl310 driver for
Armada 38x SoCs. Add prefetch and power savings configuration.
Submitted by: <arnaud.ysmal@stormshield.eu>
Obtained from: Stormshield
Sponsored by: Stormshield
Differential revision: https://reviews.freebsd.org/D10220
Memory space reserved for pmap_kernel_l2dtable_kva and
pmap_kernel_l2ptp_kva has not been taken into account in
original code. All the memory reserved from kernel space by
pmap_alloc_specials() function called in pmap_bootstrap()
should be mapped initially by initarm(). To create initial
mapping initarm() function reserves proper number of l2 page
tables. However the number of the l2 page tables does not take
into account memory for: pmap_kernel_l2ptp_kva,
pmap_kernel_l2dtable_kva, crashdumpmap, etc.
Submitted by: Grzegorz Bernacki <gjb@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: meloun-miracle-cz
Differential revision: https://reviews.freebsd.org/D10217
VM_KMEM_SIZE_MAX allows to limit kmem arena size. In our case this was
necessary, as decreasing size of kmem_arena leaves more space for
kernel_arena.
kernel_arena is pool used for contigmalloc (in effect, DMA) allocations,
which failed on Armada38x. This resulted in 'no memory errors'
(e.g. USB_ERR_NOMEM errors) and failure of whole system. The need for
greater size of kernel_arena probably comes from more peripherals making
use of busdma.
Value used as upper limit is half of the default value
(0x1399a000).
Submitted by: Wojciech Macek <wma@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Differential revision: https://reviews.freebsd.org/D10216
[X86] Remove special handling for 16 bit for A asm constraints.
Our 16 bit support is assembler-only + the terrible hack that is
.code16gcc. Simply using 32 bit registers does the right thing for
the latter.
Fixes PR32681.
This fixes some cases of assembling 16 bit code (i.e. SeaBIOS) that uses
the 'A' inline asm constraint, after r316989.
MFC after: 3 days
X-MFC-With: r316989
Highlights of changes between r3490 and r3520:
- Improve C++ demangling
- Improve compatibility with Binutils tools wrt. error messages
- Handle additional types/sections/etc. in readelf and elfdump
- addr2line, cxxfilt: use setvbuf to set line buffering for filter use
PR: 218395
MFC after: 2 weeks
Relnotes: Yes
Sponsored by: The FreeBSD Foundation
When application reads large directory, calling telldir() for each entry,
like Samba does, it creates exponential performance drop as number of
entries reach tenths to hundreds of thousands. It is caused by full search
through the internal list, that never finds matches in that scenario, but
creates O(n^2) delays. This patch optimizes that search, limiting it to
entries of the same buffer, turning time closer to O(n) in case of linear
directory scan.
PR: 218622
Reviewed by: jhb, jilles
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
Differential Revision: https://reviews.freebsd.org/D10408
in place. To do per-cpu stats, convert all fields that previously were
maintained in the vmmeters that sit in pcpus to counter(9).
- Since some vmmeter stats may be touched at very early stages of boot,
before we have set up UMA and we can do counter_u64_alloc(), provide an
early counter mechanism:
o Leave one spare uint64_t in struct pcpu, named pc_early_dummy_counter.
o Point counter(9) fields of vmmeter to pcpu[0].pc_early_dummy_counter,
so that at early stages of boot, before counters are allocated we already
point to a counter that can be safely written to.
o For sparc64 that required a whole dummy pcpu[MAXCPU] array.
Further related changes:
- Don't include vmmeter.h into pcpu.h.
- vm.stats.vm.v_swappgsout and vm.stats.vm.v_swappgsin changed to 64-bit,
to match kernel representation.
- struct vmmeter hidden under _KERNEL, and only vmstat(1) is an exclusion.
This is based on benno@'s 4-year old patch:
https://lists.freebsd.org/pipermail/freebsd-arch/2013-July/014471.html
Reviewed by: kib, gallatin, marius, lidl
Differential Revision: https://reviews.freebsd.org/D10156
- Report missing includes at the correct location.
- Add initial support for the -@ option emitting a symbol table.
- Add support for running tests with and without -@
- Add support for generating __fixups__ and __local_fixups__
- Attach the to-string transform to the node path.
