the old one is. Hence we need to evaluate the old one for _FDI since it
has a valid ACPI_HANDLE ivar. This is a minimal fix. Make a note that a
more complete one is to make fdc support the ACPI_HANDLE ivar for its
children.
This and the previous change are MT5 candidates.
concensus seems to be that is best left for doing post-install.
Discussed on: freebsd-current@
Tested with: make release
Approved by: re@
MFC after: 3 days
time the interface counters were zeroed, currently the time if_attach()
was called. It is indentended to be a valid value for RFC2233's
ifCounterDiscontinuityTime and to make it easier for applications to
verify that the interface they find at a given index is the one that was
there last time they looked.
An if_epoch "compatability" macro has not been created as ifi_epoch has
never been a member of struct ifnet.
Approved by: andre, bms, wollman
version, and "make release -DNOPORTS" breaks without it.
Noticed by: scottl
Keep lang/perl5 in the list because it's the default Perl version
for 4.x, and it's still possible to "make release" of HEAD on 4.x.
so that it becomes happy and no longer panics the system
upon getting the very first packet to transmit.
Reported and tested by: Igor Timkin <ivt@gamma.ru>
Reviewed by: rwatson
MFC after: 5 days
syscall can interrupt other thread's syscall in sleepq_catch_signals().
Current, all callers know thread_suspend_check may suspend thread
itself, so we need't to check return_instead for normal suspension
flags (no P_SINGLE_EXIT set).
Tested by: deischen
Reported by: Maarten L. Hekkelman <m.hekkelman@cmbi.kun.nl>
bootable ISO. HP machines (like the rx2600) that (also) have isp(4)
may have a non-standard firmware on the controller. Our isp(4) driver
is not able to work with those and even panics. This makes installing
FreeBSD rather impossible. By adding the ispfw.ko module, we give the
user a chance to upload a certified firmware onto the card and so make
it possible to either use the isp(4) successfully or otherwise avoid
the panic.
do not set the virtual address to the bus address when the bus
doesn't have either of the PCI_RF_DENSE or PCI_RF_BWX flags set.
The TGA driver uses the virtual address to access the registers,
which on some machines can cause a memory management fault. Map
the bus address as K0SEG virtual memory instead. Note that with
some hardware combinations involving the TGA2 adapter this change
merely results that the memory management fault is replaced by a
machine check.
this in my tree for a while and in its disabled state there are no
issues. It isn't enabled yet because some drivers (in acpi) have side
effects in their probe routines that need to be resolved in some
manner before this can be turned on. The consensus at the last
developer's summit was to provide a static method for each driver
class that will return characteristics of the driver, one of which is
if can be reprobed idempotently.
address I've lost, that move the location information to the atttach
routine as well. While one could use devinfo to get this data, that
is difficult and error prone and subject to races for short lived
devices.
Would make a good MT5 candidate.
keyword but without 'logamount' limit the amount of their log messages
by net.inet.ip.fw.verbose_limit sysctl value.
RELENG_5 candidate.
PR: kern/46080
Submitted by: Dan Pelleg
MFC after: 1 week
