not gone yet.
format_config: print correct text when a volume has a preferred plex.
This is still broken, but not quite as badly.
Reported-by: Phil Regnauld <regnauld@ftf.net>
Change a rather silly comment.
/var/log/vinum_history. Also check that any existing history file is
a regular file.
Admonished-by: imp
Allow stopping long-running commands with ^C (well, SIGINTR).
Previously this would stop the program.
directly off the drives.
This command shows a minor problem: it requires that the device nodes
exist, whereas kernel Vinum does not. Thus dumpconfig may show no
configuration for certain drives which are up and happily running.
This is documented in the man page.
routines from foo_watchdog() because foo_watchdog() is called at
interrupt context, and that's a no-no due to the way the USB stack
is currently set up.
What we do now is call the TX end of frame handler manually to clear
the completed transmission, then check the send queue and send off
any frames that are pending.
Also turned off the interrupt pipe stuff in if_aue, since it appears
to tickle a bug in the USB stack that I haven't found yet.
motherboards that use YMF740's. It has a strange subvendor and subdevice
ID and requires a disturbingly long delay after the ac97 codec init.
Cameron hasn't had this driver tested on another 740 yet, so we don't know
if this is a quirk of all 740's, or if its just something about the codec
that Intel used.
Further experimentation showed that some Dell 2450 machines with the
prevention kludge installed still got T_RESERVED traps. CPU interrupt
vector 0x7A was observed to be triggered. This might have been the
bitwise OR of two different vectors sent from each of the IOAPICs at
the same time.
IOAPIC #0: 0x68 --> irq 8: RTC timer interrupt
IOAPIC #1: 0x32 --> irq 18: scsi host adapter or network interface
----
0x7a --> T_RESERVED
Both IOAPICs had ID 0.
Appendix B.3 in the MP spec indicates that the operating system is
responsible for assigning unique IDs to the IOAPICs.
The enclosed patch programs the IOAPIC IDs according to the IOAPIC
entries in the MP table.
Submitted by: tegge
workalike chips (Macronix 98713A/98715 and PNIC II). Timing is somewhat
critical: you need to bring the link as soon as possible after NWAY
is done, and the old one second polling interval was too long. Now
we poll every 10th of a second until NWAY completes (at which point
we return to the 1 second interval again to keep an eye on the link
state).
I tested all the other cards I had on hand to make sure I didn't bust
any of them and they seem to work (including the MII-based 21143 card).
This should fix some autoneg problems with DE500-BA cards and the
built-in 10/100 ethernet on some alpha systems.
(Now before anyone asks why I never noticed this before, the old code
worked just find with the Intel swich I used for testing back in NY.
Apparently not all switches are as picky about the timing.)
