It is useful to enter kdb with an escape sequence.
While here move the USB_DEBUG with the others debug options and define
nooptions USB_DEBUG for GENERIC-NODEBUG
Add support for setting pll rate. On RockChip SoC two kind of plls are
supported, integer mode and fractional mode.
The two modes are intended to support more frequencies for the core plls.
While here change the recalc method as it appears that the datasheet is
wrong on the calculation method.
Add the clock definition for the arm clock.
While here remove the indexes in the clock table as we will need clock
with a 0 index (non-exported clocks).
Dumpers may wish to print messages from an initialization hook; this
change ensures that such messages aren't mixed with output from the
generic dump code.
MFC after: 1 week
Add a driver that match on 'rockchip,gpio-bank', this compatible
string is found on almost all RockChip SoC so this driver is compatible
with almost all of the RockChip SoCs.
The only features missing for this driver are :
- Interrupts support
- Debouncing
Add pinctrl driver for RockChip SoCs. This device manage which function
to set on which pin and some other properties like pull up/down, drive
strength etc ...
For now the driver only support RK3328 but it is versatile enough to
add support for other RockChip SoC in the future.
RockChip GRF (General Register Files) is present on almost all RockChip
SoC and is used to control some area of the system like iomuxing, gpio
or usb phy.
We need it to be probed and attached early in the boot process so
subclass syscon_generic and set the pass to BUS_PASS_BUS + BUS_PASS_ORDER_MIDDLE.
This is the first step (after the recent refactoring of some common
code) to supporting the Linuxulator on arm64.
Reviewed by: andrew
Sponsored by: Turing Robotic Industries Inc.
Differential Revision: https://reviews.freebsd.org/D15187
Half of implementations always failed (returned (-1)) and they were
previously used in only one place.
Reviewed by: kib, andrew
Obtained from: CheriBSD
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D15102
opt_compat.h is mentioned in nearly 180 files. In-progress network
driver compabibility improvements may add over 100 more so this is
closer to "just about everywhere" than "only some files" per the
guidance in sys/conf/options.
Keep COMPAT_LINUX32 in opt_compat.h as it is confined to a subset of
sys/compat/linux/*.c. A fake _COMPAT_LINUX option ensure opt_compat.h
is created on all architectures.
Move COMPAT_LINUXKPI to opt_dontuse.h as it is only used to control the
set of compiled files.
Reviewed by: kib, cem, jhb, jtl
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D14941
ARM Coresight is a solution for debug and trace of complex SoC designs.
This includes a collection of drivers for ARM Coresight interconnect
devices within a small Coresight framework.
Supported devices are:
o Embedded Trace Macrocell v4 (ETMv4)
o Funnel
o Dynamic Replicator
o Trace Memory Controller (TMC)
o CPU debug module
Devices are connected to each other internally in SoC and the
configuration of each device endpoints is described in FDT.
Typical trace flow (as found on Qualcomm Snapdragon 410e):
CPU0 -> ETM0 -> funnel1 -> funnel0 -> ETF -> replicator -> ETR -> DRAM
CPU1 -> ETM1 -^
CPU2 -> ETM2 -^
CPU3 -> ETM3 -^
Note that both Embedded Trace FIFO (ETF) and Embedded Trace Router (ETR)
are hardware configurations of TMC.
This is required for upcoming HWPMC tracing support.
This is tested on single-core system only.
Reviewed by: andrew (partially)
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D14618
Make kdb_trap in breakpoint exception handler conditional. If "options KDB"
is not present just panic with message that debugger is not enabled.
PR: 224653
assym is only to be included by other .s files, and should never
actually be assembled by itself.
Reviewed by: imp, bdrewery (earlier)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D14180
This fixes a problem encountered on the Lenovo Thinkpad X220/Yoga 11e where
runtime services would try to inexplicably jump to other parts of memory
where it shouldn't be when attempting to enumerate EFI vars, causing a
panic.
The virtual mapping is enabled by default and can be disabled by setting
efi_disable_vmap in loader.conf(5).
Reviewed by: kib (earlier version)
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D14677
This seems to no be needed on supported hardware as they are cache-coherent,
however this may not be the case on all platforms.
Sponsored by: DARPA, AFRL
band aid until a better solution to find the correct interrupt controller
can be found.
While here fix one place in the GICv3 ITS driver where the offset wasn't
correctly applied.
Sponsored by: DARPA, AFRL
Sponsored by: Cavium (Hardware)
one physical page. This is in preparation for limiting it further as this
is needed on some hardware, however testing has shown issues with further
restricting the DMAP and ACPI.
Sponsored by: DARPA, AFRL
Sponsored by: Cavium (Hardware)
only use the first driver, however this may change in the future and
hardware exists with multiple ITS devices.
Sponsored by: DARPA, AFRL
Sponsored by: Cavium (Hardware)
* rk_cru is a cru driver that needs to be subclassed by
the real CRU driver
* rk_clk_pll handle the pll type clock on RockChip SoC, it's only read
only for now.
* rk_clk_composite handle the different composite clock types (with gate,
with mux etc ...)
* rk_clk_gate handle the RockChip gates
* rk_clk_mux handle the RockChip muxes (unused for now)
* Only clocks for supported devices are supported for now, the rest will be
added when driver support comes
* The assigned-clock* property are not handled for now so we rely a lot on the
bootloader to setup some initial values for some clocks.
We can reach that point with IRQs disabled, and calling ast() with IRQs
disabled can lead to a deadlock.
This should fix the freezes on arm64 under load.
Reviewed by: andrew
The conditional compilation support is now centralized in
tcp_fastopen.h and tcp_var.h. This doesn't provide the minimum
theoretical code/data footprint when TCP_RFC7413 is disabled, but
nearly all the TFO code should wind up being removed by the optimizer,
the additional footprint in the syncache entries is a single pointer,
and the additional overhead in the tcpcb is at the end of the
structure.
This enables the TCP_RFC7413 kernel option by default in amd64 and
arm64 GENERIC.
Reviewed by: hiren
MFC after: 1 month
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D14048
new arm64 hardware, e.g. ThunderX2, seems to use this page size so was
failing to attach as the register value read back was incorrect.
While here fix the spelling on shareability.
Sponsored by: DARPA, AFRL
No implementation of fpu_kern_enter() can fail, and it was causing needless
error checking boilerplate and confusion. Change the return code to void to
match reality.
(This trivial change took nine days to land because of the commit hook on
sys/dev/random. Please consider removing the hook or otherwise lowering the
bar -- secteam never seems to have free time to review patches.)
Reported by: Lachlan McIlroy <Lachlan.McIlroy AT isilon.com>
Reviewed by: delphij
Approved by: secteam (delphij)
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D14380
We don't support float in the boot loaders, so don't include
interfaces for float or double in systems headers. In addition, take
the unusual step of spiking double and float to prevent any more
accidental seepage.
Make vm_wait() take the vm_object argument which specifies the domain
set to wait for the min condition pass. If there is no object
associated with the wait, use curthread' policy domainset. The
mechanics of the wait in vm_wait() and vm_wait_domain() is supplied by
the new helper vm_wait_doms(), which directly takes the bitmask of the
domains to wait for passing min condition.
Eliminate pagedaemon_wait(). vm_domain_clear() handles the same
operations.
Eliminate VM_WAIT and VM_WAITPFAULT macros, the direct functions calls
are enough.
Eliminate several control state variables from vm_domain, unneeded
after the vm_wait() conversion.
Scetched and reviewed by: jeff
Tested by: pho
Sponsored by: The FreeBSD Foundation, Mellanox Technologies
Differential revision: https://reviews.freebsd.org/D14384
significant source of cache line contention from vm_page_alloc(). Use
accessors and vm_page_unwire_noq() so that the mechanism can be easily
changed in the future.
Reviewed by: markj
Discussed with: kib, glebius
Tested by: pho (earlier version)
Sponsored by: Netflix, Dell/EMC Isilon
Differential Revision: https://reviews.freebsd.org/D14273
- pmap_enter_object() can be used for mapping of executable pages, so it's
necessary to handle I-cache synchronization within it.
- Fix race in I-cache synchronization in pmap_enter(). The current code firstly
maps given page to target VA and then do I-cache sync on it. This causes
race, because this mapping become visible to other threads, before I-cache
is synced.
Do sync I-cache firstly (by using DMAP VA) and then map it to target VA.
- ARM64 ARM permits implementation of aliased (AIVIVT, VIPT) I-cache, but we
can use different that final VA for flushing it. So we should use full
I-cache flush on affected platforms. For now, and as temporary solution,
use full flush always.
- special fault handling for break-before-make mechanism should be also
applied for instruction translation faults, not only for data translation
faults.
- since arm64_address_translate_...() functions are not atomic,
use these with disabled interrupts.
