fatal trap. Also, reload the GDT register to point to BTX's GDT before
playing around with the segment registers to return to real mode. This is
helpful if the kernel causes a fatal exception before it has setup its own
IDT and fault handlers. For example, if one happens to break mtx_init().
Without these changes BTX would recursively page fault (if paging was not
disabled) or triple fault and reset the CPU (without the GDT reload)
instead of providing a potentially useful register dump.
Reviewed by: rnordier
affect current systems until fsck is modified to use these new
facilities. To try out this change, set the fsck passno to zero
in /etc/fstab to cause the filesystem to be mounted without running
fsck, then run `fsck_ffs -p -B <filesystem>' after the system has
been brought up multiuser to run a background cleanup on <filesystem>.
Note that the <filesystem> in question must have soft updates enabled.
changed. These were taken from the 4.2-RELEASE dist on ftp.freebsd.org.
This will be MFC'd shortly as it is required in RELENG_4 to maintain
compatability with binaries linked against these libraries.
sysctl, net.inet.ip.fw.permanent_rules.
This allows you to install rules that are persistent across flushes,
which is very useful if you want a default set of rules that
maintains your access to remote machines while you're reconfiguring
the other rules.
Reviewed by: Mark Murray <markm@FreeBSD.org>
(as is done in unmount).
Remove a snapshot inode from the superblock list when its last
name goes away rather than when its last reference goes away.
That way it will be properly reclaimed by fsck after a crash
rather than reenabled when the filesystem is mounted.
I was hanging after sending a xfer CTIO and a status CTIO for a non-discon
INQUIRY- the xfer CTIO was returned as completed OK, but the status CTIO
was dropped on the floor. All the fields looked good. I don't know why
it got dropped. But allowing status to go back with data xfer seemed to
work. I also noticed that with a non-disconnecting command that the
firmware handle in the ATIO is zero- this leads me to believe that the
f/w really can only handle one CTIO at a time in the discon case, and
it had no idea what to do with the second (status) CTIO.
CAM_SEND_STATUS. Set a timeout of 2 seconds per CTIO. Make sure
that the 'real' tag value is being checked against- not the
one that also carries the firmware handle.
dependency order (submitted by sobomax), "lprm -" works for remote
printers, mergemaster(8) updates, ftpd(8) updates.
Also make sure ESS Maestro-3/Allegro is mentioned in appropriate
hardware lists (submitted by scottl).
