DISKFLAG_CANDELETE. While this change makes this layer consistent
other layers such as UFS and ZFS BIO_DELETE support may not notice
any change made manually via these device sysctls until the device
is reopened via a mount.
Also corrected var order in dadeletemethodsysctl
PR: kern/169801
Reviewed by: pjd (mentor)
Approved by: mav
MFC after: 2 weeks
Factor out USB mouse and keyboard detection logic.
Reject USB keyboards which have mouse alike HID items
in their HID descriptors.
Submitted by: Matthew W
MFC after: 1 week
Currently we use interface indeces as zone IDs for link-local and
interface-local scopes, and since we don't have any tool to configure
zone IDs, there is no need to acquire the afdata lock several times per
packet only to read if_index value.
So, now in6_setscope reads zone IDs for interface-local, link-local and
global scopes without a lock.
Sponsored by: Yandex LLC
MFC after: 2 weeks
resources are partitioned.
- Reduce the number of virtual interfaces reserved for PF4. This leaves
spare room in the source MAC table and allows the driver to setup
filters that rewrite the source MAC address.
- Reduce the number of filters and use the freed up space for the CLIP
(Compressed Local IPv6 addresses) table. This is a prerequisite for
IPv6 TOE support which will follow separately in a series of commits.
MFC after: 1 week
SYNs (or SYN/ACK replies) are dropped due to network congestion, then the
remote end of the connection may act as if options such as window scaling
are enabled but the local end will think they are not. This can result in
very slow data transfers in the case of window scaling disagreements.
The old behavior can be obtained by setting the
net.inet.tcp.rexmit_drop_options sysctl to a non-zero value.
Reviewed by: net@
MFC after: 2 weeks
It stops treating the address on the interface as special by source
address selection rule even when the interface is outgoing interface.
This is desired in some situation.
Requested by: hrs
Reviewed by: IHANet folks including hrs
MFC after: 1 week
Previously CTL would leave individual LUNs enabled in the target
driver, whether or not the port as a whole was enabled. It would
also leave the wildcard LUN enabled indefinitely.
This change means that CTL will enable and disable any active LUNs,
as well as the wildcard LUN, when enabling and disabling a port.
Also, fix a bug that could crop up due to an uninitialized CCB
type.
ctl.c: Before calling ctl_frontend_online(), run through
the LUN list and enable all active LUNs.
After calling ctl_frontend_offline(), run through
the LUN list and disble all active LUNs.
scsi_ctl.c: Before bringing a port online, allocate the
wildcard peripheral for that bus. And after taking
a port offline, invalidate the wildcard peripheral
for that bus.
Make sure that we hold the SIM lock around all
calls to xpt_action() and other transport layer
interfaces that require it.
Use CAM_SIM_{LOCK|UNLOCK} consistently to acquire
and release the SIM lock.
Update a number of outdated comments. Some of
these should have been fixed long ago.
Actually do LUN disbables now. The newer drivers
in the tree work correctly for this as far as I
know.
Initialize the CCB type to CTLFE_CCB_DEFAULT to
avoid a panic due to uninitialized memory.
Submitted by: Chuck Tuffli (partially)
MFC after: 1 week
in devfs if a particular race condition is hit in the device pager
code.
This was a side effect of change 227530 which changed the device
pager interface to call a new destructor routine for the cdev.
That destructor routine, old_dev_pager_dtor(), takes a VM object
handle.
The object handle is cast to a struct cdev *, and passed into
dev_rel().
That works in most cases, except the case in cdev_pager_allocate()
where there is a race condition between two threads allocating an
object backed by the same device. The loser of the race
deallocates its object at the end of the function.
The problem is that before inserting the object into the
dev_pager_object_list, the object's handle is changed from the
struct cdev pointer to the object's own address. This is to avoid
conflicts with the winner of the race, which already inserted an
object in the list with a handle that is a pointer to the same cdev
structure.
The object is then passed to vm_object_deallocate(), and eventually
makes its way down to old_dev_pager_dtor(). That function passes
the handle pointer (which is actually a VM object, not a struct
cdev as usual) into dev_rel(). dev_rel() decrements the reference
count in the assumed struct cdev (which happens to be 0), and
that triggers the assertion in dev_rel() that the reference count
is greater than or equal to 0.
The fix is to add a cdev pointer to the VM object, and use that
pointer when calling the cdev_pg_dtor() routine.
vm_object.h: Add a struct cdev pointer to the VM object
structure.
device_pager.c: In cdev_pager_allocate(), populate the new cdev
pointer.
In dev_pager_dealloc(), use the new cdev pointer
when calling the object's cdev_pg_dtor() routine.
Reviewed by: kib
Sponsored by: Spectra Logic Corporation
MFC after: 1 week
This should not matter much when running on bare metal but it makes the guest
more friendly when running inside a virtual machine.
Discussed with: jhb
Obtained from: NetApp
and embeds it into address. Inside the kernel we keep addresses with
embedded zone id only for two scopes: link-local and interface-local.
For other scopes this function is nop in most cases. To reduce an
overhead of locking, first check that address is capable for embedding.
Also, handle the loopback address before acquire the lock.
Sponsored by: Yandex LLC
MFC after: 1 week
This is intended to support reporting FFT results during active channel
scans, for users who would like to fiddle around with writing applications
that do both FFT visualisation _and_ AP scanning.
* add a new ioctl to enable/trigger spectral scan at channel change/reset;
* set do_spectral consistently if it's enabled, so a channel set/reset
will carry forth the correct PHY error configuration so frames
are actually received;
* for NICs that don't do spectral scan, don't bother checking the
spectral scan state on channel change/reset.
Tested:
* AR9280 - STA and scanning;
* AR5416 - STA, ensured that the SS code doesn't panic
Volume Descriptor (section 7.4). In short, upper-case alphanumeric + some
symbols only. While the makefs utility automatically converts the characters,
$LABEL should be consistent in the scripts.
r238966
Bump up the heap size to 1MB. With a few kernel modules, libstand
zalloc and userboot seem to want to use ~600KB of heap space, which
results in a segfault when malloc fails in bhyveload.
r241180
Clarify comment about default number of FICL dictionary cells.
r241153
Allow the number of FICL dictionary cells to be overridden.
Loading a 7.3 ISO with userboot/amd64 takes up 10035 cells,
overflowing the long-standing default of 10000.
Bump userboot's value up to 15000 cells.
Reviewed by: dteske (r238966,241180)
Obtained from: NetApp
- Missing PTE_SYNC in pmap_kremove caused memory corruption
in userland applications
- Fix lack of cache flushes when using special PTEs for zeroing or
copying pages. If there are dirty lines for destination memory
and page later remapped as a non-cached region actual content
might be overwritten by these dirty lines when cache eviction
happens as a result of applying cache eviction policy or because
of wbinv_all call.
- icache sync for new mapping for userland applications.
Tested by: gber
This change was originally intended to account for test kthreads under
the nvmecontrol process, but jhb indicated it may not be safe to
associate kthreads with userland processes and this could have
unintended consequences.
I did not observe any problems with this change, but my testing didn't
exhaust the kinds of corner cases that could cause problems. It is not
that important to account for these test threads under nvmecontrol, so I
am just reverting this change for now.
On a related note, the part of this patch for <= 7.x fails compilation
so reverting this fixes that too.
Suggested by: jhb
Preloaded library could have changed the environment, and
unconditional assingment to the environ undoes the customization.
The binaries needs to be recompiled to get the fix.
Move the common code to set up environ and __progname into the helper.
Note that ia64 possibly not fixed, due to it still using old csu.
Reported and tested by: John Hein <jhein@symmetricom.com>
Reviewed by: kan, scf
Approved by: secteam (simon)
MFC after: 2 weeks
This patch will save CPU time when the XHCI interrupt is
shared with other devices.
Only check event rings when interrupt bits are set.
Otherwise would indicate hiding possible hardware fault(s).
Tested by: sos @
Submitted by: sos @
MFC after: 1 week
It was plagued with style errors and the offsets had been lost.
While here took the time to update the fields according to the
latest ext4 documentation.
Reviewed by: bde
MFC after: 3 days
l2_wbinv_range function implementation causes function
fail to flush caches for chip with RTL number 0x7. I failed
to find official PL310 revision with this RTL number
so further research on this matter required.
Use file name hash as a tree key, handle duplicate keys. Both VOP_LOOKUP
and VOP_READDIR operations utilize same tree for search. Directory
entry offset (cookie) is either file name hash or incremental id in case
of hash collisions (duplicate-cookies). Keep sorted per directory list
of duplicate-cookie entries to facilitate cookie number allocation.
Don't fail if previous VOP_READDIR() offset is no longer valid, start
with next dirent instead. Other file system handle it similarly.
Workaround race prone tn_readdir_last[pn] fields update.
Add tmpfs_dir_destroy() to free all dirents.
Set NFS cookies in tmpfs_dir_getdents(). Return EJUSTRETURN from
tmpfs_dir_getdents() instead of hard coded -1.
Mark directory traversal routines static as they are no longer
used outside of tmpfs_subr.c
