levels. The root of the problem was that make was attempting to run up
to three concurrent asn1_compile commands to produce the three outputs
that it was declared to produce. The failure was caused when the
asn1_compiles were started out of sync and a later one was truncating
the files that another thread was trying to copy. In reality it is
supposed to be run exactly once and all three outputs are produced in
one pass.
Use the same hack as for the parent's Makefile.inc for the compile_et
multi-output rule.
HAL methods.
This allows the AR8327 code to override it as appropriate.
Tested:
* DB120 - AR8327 and AR9340 on-board switch; only running 'etherswitchcfg'
to check configs. The actual VLAN programming wasn't tested.
The registers (and perhaps the flags) are different for the AR8327, so
I'll stub those out until they're written.
Tested:
* DB120 - both on-chip AR9340 and AR8327 switches.
a single port to setup.
This may end up later being used as part of some logic to program
the PHY for a single port, rather than having to reinitialise them
all at once.
Tested:
* DB120
license, although the former is pretty safe, it wasn't intended to be
used in the version of MIPS boot2/loader upstreamed to FreeBSD.
MFC after: 3 weeks
Sponsored by: DARPA, AFRL
particular interest in (and support for) SRI International and the
University of Cambridge's BERI FPGA soft-core processor. This includes
micro device drivers for the Altera JTAG UART console, memory-mapped
flash, and the Altera SD Card IP core in both boot2 and loader. boot2
can be written to the on-board Intel StrataFlash on the DE4 board, and
loader can be placed in StrataFlash or the SD Card.
Plenty of XXX comments, but works quite well locally in practice and I
am using it daily. Although I had originally ported the ARM version
of boot2, the current version is x86-derived as that proved more
feature-complete. As we don't currently use partitions on our flash
disks, support for that has been commented out relative to x86, but
would be easy to add back. FDT support has not yet been hooked up,
although some skeleton parts have been put in place for that.
This may well be a useful starting point for ports to other 32-bit and
64-bit MIPS-ISA systems.
This merge is synchronised to CheriBSD github commit
e41d74fd719525d4dd7a7ee499114679165eeaf6, but with some additions of
$FreeBSD.
MFC after: 3 weeks
Sponsored by: DARPA, AFRAL
capability.h currently only wraps some of its declarations in __BEGIN_DECLS/__END_DECLS, so cap_enter(), cap_sandboxed(), etc. are usable from C++ code but cap_rights_init(), cap_rights_is_valid() etc. are not. This commit fixes this distinction.
Approved by: rwatson (mentor)
MFC after: 1 week
Sponsored by: DARPA, AFRL
- intercept FIONBIO and FIOASYNC ioctls on netmap file descriptors.
libpcap calls them to set non blocking I/O on the file descriptor,
for netmap this is a no-op because there is no read/write,
but not intercepting would cause fcntl() to return -1
- rate limit and put under netmap.verbose some messages that occur
when threads use concurrently the same file descriptor.
emulated instructions.
- Add helper routines to inject interrupt information for a hardware
exception from the VM exit callback routines.
- Use the new routines to inject GP and UD exceptions for invalid
operations when emulating the xsetbv instruction.
- Don't directly manipulate the entry interrupt info when a user event
is injected. Instead, store the event info in the vmx state and
only apply it during a VM entry if a hardware exception or NMI is
not already pending.
- While here, use HANDLED/UNHANDLED instead of 1/0 in a couple of
routines.
Reviewed by: neel
the non-standard zero capability list terminator. Instead, track
the start and end of the most recently added capability and use that
to adjust the previous capability's next pointer when a capability is
added and to determine the range of config registers belonging to
PCI capability registers.
Reviewed by: neel
Before this patch, curvnet was NULL.
When the VIMAGE kernel option is enabled, this eliminates
kernel panics when USB ethernet devices are plugged in.
PR: 183835
Submitted by: Hiroo Oono <hiroo.ono at gmail dot com>
in x2apic mode. Reads to this MSR are currently ignored but should cause a
general proctection exception to be injected into the vcpu.
All accesses to the corresponding offset in xAPIC mode are ignored.
Also, do not panic the host if there is mismatch between the trigger mode
programmed in the TMR and the actual interrupt being delivered. Instead the
anomaly is logged to aid debugging and to prevent a misbehaving guest from
panicking the host.
This is necessary because if the vlapic is configured in x2apic mode the
vioapic_process_eoi() function is called inside the critical section
established by vm_run().
blocking sockets. The error was not exposed as long as the kernel
suffered from PR kern/185812. Now corrected, these tests pass on
DragonFlyBSD 3.6.0.
PR: kern/185812
Sponsored by: Spectra Logic Corporation
MFC after: 2 weeks
about uss820dci_odevd being unused, by adding it to the part that
handles getting descriptors.
Reported by: loos
Reviewed by: hselasky
MFC after: 3 days
This commit largely restores the lldb source to the upstream r196259
snapshot with the addition of threaded inferior support and a few bug
fixes.
Specific upstream lldb revisions restored include:
SVN git
181387 779e6ac
181703 7bef4e2
182099 b31044e
182650 f2dcf35
182683 0d91b80
183862 15c1774
183929 99447a6
184177 0b2934b
184948 4dc3761
184954 007e7bc
186990 eebd175
Sponsored by: DARPA, AFRL
"Manpages should start a new sentence on a new line. This makes it easier
for translators to track changes." -jhb
Approved by: jhb
MFC after: 3 days
Sponsored by: SupraNet Communications, Inc
tested and is unfinished. However, I've tested my version,
it works okay. As before it is unfinished: timeout aren't
driven by TCP session state. To enable the HASH_ALL mode,
one needs in kernel config:
options FLOWTABLE_HASH_ALL
o Reduce the alignment on flentry to 64 bytes. Without
the FLOWTABLE_HASH_ALL option, twice less memory would
be consumed by flows.
o API to ip_output()/ip6_output() got even more thin: 1 liner.
o Remove unused unions. Simply use fle->f_key[].
o Merge all IPv4 code into flowtable_lookup_ipv4(), and do same
flowtable_lookup_ipv6(). Stop copying data to on stack
sockaddr structures, simply use key[] on stack.
o Move code from flowtable_lookup_common() that actually works
on insertion into flowtable_insert().
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
and CAMBRIA boards that does not use loader to load the kernel. This
is basically how it was done for i386. This way tunables can also be
set. For example in config file:
env "/conf/AVILA.env"
And in AVILA.env:
vfs.unmapped_buf_allowed=0
MFC after: 2 weeks
When the user supplies an invalid number of days provide a useful error message
instead of segfaulting.
PR: bin/186697
Reported by: kaltheat <kaltheat@gmail.com>
Submitted by: oliver <oliver@beefrankly.org> (older version)
