itself and its children. Instead of calling times() (as implied by POSIX) this
implementation directly calls getrusage() to get the times because this is more
convenient.
time_t and times will look incorrect on machines with 64bit time_t.
PR: 88788
Submitted by: Keith White <Keith.White -at- site.uottawa.ca>
MFC after: 1 week
shares its low half with pio2_hi. pio2_hi is rounded down although
rounding to nearest would be a tiny bit better, so pio4_hi must be
rounded down too. It was rounded to nearest, which happens to be
different in float precision but the same in double precision.
This fixes about 13.5 million errors of more than 1 ulp in asinf().
The largest error was 2.81 ulps on amd64 and 2.57 ulps on i386 -O1.
Now the largest error is 0.93 ulps on amd65 and 0.67 ulps on i386 -O1.
sqrt(2)/2-1. For log1p(), fixed the approximation to sqrt(2)/2-1.
The end result is to fix an error of 1.293 ulps in
log1pf(0.41421395540 (hex 0x3ed413da))
and an error of 1.783 ulps in
log1p(-0.292893409729003961761) (hex 0x12bec4 00000001)).
The former was the only error of > 1 ulp for log1pf() and the latter
is the only such error that I know of for log1p().
The approximations don't need to be very accurate, but the last 2 need
to be related to the first and be rounded up a little (even more than
1 ulp for sqrt(2)/2-1) for the following implementation-detail reason:
when the arg (x) is not between (the approximations to) sqrt(2)/2-1
and sqrt(2)-1, we commit to using a correction term, but we only
actually use it if 1+x is between sqrt(2)/2 and sqrt(2) according to
the first approximation. Thus we must ensure that
!(sqrt(2)/2-1 < x < sqrt(2)-1) implies !(sqrt(2)/2 < x+1 < sqrt(2)),
where all the sqrt(2)'s are really slightly different approximations
to sqrt(2) and some of the "<"'s are really "<="'s. This was not done.
In log1pf(), the last 2 approximations were rounded up by about 6 ulps
more than needed relative to a good approximation to sqrt(2), but the
actual approximation to sqrt(2) was off by 3 ulps. The approximation
to sqrt(2)-1 ended up being 4 ulps too small, so the algoritm was
broken in 4 cases. The result happened to be broken in 1 case. This
is fixed by using a natural approximation to sqrt(2) and derived
approximations for the others.
In logf(), all the approximations made sense, but the approximation
to sqrt(2)/2-1 was 2 ulps too small (a tiny amount, since we compare
with a granularity of 2**32 ulps), so the algorithm was broken in 2
cases. The result was broken in 1 case. This is fixed by rounding
up the approximation to sqrt(2)/2-1 by 2**32 ulps, so 2**32 cases are
now handled a little differently (still correctly according to my
assertion that the approximations don't need to be very accurate, but
this has not been checked).
through the history in sh.
| Refresh bug reported by Julien Torres:
|
| going from:
| activate -verbose
| to:
| reset -activation
| results in:
| reset -activationverbose"
| instead of:
| reset -activation
|
| This is because we choose to insert "reset -" before the current line,
| and the delete "e -" and insert "ion" in the appropriate place. The
| cleareol code did not handle this case properly; we now cleareol to
| the maximum number of characters of the first difference, the second
| difference and the difference in line length.
on assignment.
Extra precision on i386's broke hi+lo decomposition in the usual way.
It caused all except 1 of the 62343 errors of more than 1 ulp for
log1pf() on i386's with gcc -O [-fno-float-store].
o plug memory leak in adhoc mode: on rx the sender may be the
current master so simply checking against ic_bss is not enough
to identify if the packet comes from an unknown sender; must
also check the mac address
o split neighbor node creation into two routines and fillin state
of nodes faked up on xmit when a beacon or probe response frame
is later received; this ensures important state like the rate set
and advertised capabilities are correct
Obtained from: netbsd
MFC after: 1 week
is caught. Can be assigned to a window manager shortcut to prevent accidents
with touchpads.
PR: bin/89357
Submitted by: Nick Hibma <nick -at- van-laarhoven.org>
MFC after: 1 week
polarity. Some machines route PCI IRQs to an ISA IRQ but fail to include
an interrupt override entry to set the polarity and trigger of the given
ISA IRQ in their MADT table.
PR: usb/74989
Reported by: Julien Gabel jpeg at thilelli dot net
MFC after: 1 week
from sys/sparc64/include/ofw_upa.h to sys/sparc64/pci/ofw_pci.h and
rename them to struct ofw_pci_ranges and OFW_PCI_RANGE_* respectively.
This ranges struct only applies to host-PCI bridges but no to other
bridges found on UPA. At the same time it applies to all host-PCI
bridges regardless of whether the interconnection bus is Fireplane/
Safari, JBus or UPA.
- While here rename the PCI_CS_* macros in sys/sparc64/pci/ofw_pci.h
to OFW_PCI_CS_* in order to be consistent and change this header to
use uintXX_t instead of u_intXX_t.
containing the jailid, path, hostname, ip and the command used to start
the jail.
PR: misc/89883
Submitted by: L. Jason Godsey <lannygodsey -at- yahoo.com>
Reviewed by: phk
MFC after: 1 week
the bridge (PCI bus A or B) we are attaching to rather than registering
both handlers at once when attaching to the first half we encounter.
This is a bit cleaner as it corresponds to which PCI bus error interrupt
actually is assigned to the respective half by the OFW and allows to
collapse both PCI bus error interrupt handlers into one function easily.
- Use the actual RID of the respective interrupt resource as index into
sc_irq_res and also use it when allocating the resource. For now this
is a bit cleaner and will be mandatory later on.
- According to OpenSolaris the spare hardware interrupt is used as the
over-temperature interrupt in systems with Psycho bridges. Unlike as
with the SBus-based workstations I didn't manage to trigger it when
covering the fan outlets of an U60 but better be safe than sorry and
register a handler anyway.
MFC after: 1 month
bug by explaining what the problem is and how the workaround works.
- Fix some cosmetics nits, mainly properly terminate sentences in comments,
which I missed when backporting the style changes to psycho(4) in psycho.c
rev. 1.54 due to lack of corresponding code.
- The "USIIe version of the Sabre bridge" actually is termed "Hummingbird";
name it as such in comments and messages.
according to the highest nonzero bit in a denormal was missing.
fdlibm ilogbf() and ilogb() have always had the adjustment, but only
use a small part of their method for handling denormals; use the
normalization method in log[f]() for the main part.
