controller, I'm not sure whether this is also applicable to SiS190
so this feature is only activated on SiS191 controller.
In theory, controller reinitialization is not needed when VLAN tag
configuration is changed, but xclin said controller was not stable
whenever toggling VLAN tag bit. To address that, sge(4)
reinitialize controller for VLAN configuration which seems to work
as expected. VLAN tag information for TX/RX descriptor and
configure bit of RxMacControl register was found by xclin.
Submitted by: xclin <xclin <> cs dot nctu dot edu dot tw > (initial version)
Tested by: xclin <xclin <> cs dot nctu dot edu dot tw >
register. Due to lack of SiS190 controller, I'm not sure whether
this is also applicable to SiS190 so this feature is only activated
on SiS191 controller.
The controller can pad 10 bytes before DMAing a received frame to
RX buffer and received bytes include the padded bytes. This padding
is very useful on strict-alignment architectures because driver
does not have to copy received frame to align IP header on 4 bytes
boundary. It also gives better RX performance on non-strict
alignment architectures. Special thanks to xclin to give me
valuable register information. Without his enthusiastic trial and
errors this wouldn't be even possible.
While I'm here tighten validity check of received frame. Controller
clears RDS_CRCOK bit when it received bad CRC frames. xclin found
that using loop back testing.
Tested by: xclin <xclin <> cs dot nctu dot edu dot tw >
programs RX filter configuration. It seems RX MAC control register
is one of key registers to get various offloading features as well
as performance. Blindly clearing unrelated bits can result in
unexpected results.
Tested by: xclin <xclin <> cs dot nctu dot edu dot tw >
than checking each page for PG_UNMANAGED, check the vm object's type.
Only OBJT_PHYS can have unmanaged pages. Eliminate a pointless counter.
The vm object is locked, that lock is never released by the inner loop,
and the set of pages contained by the vm object is not changed by the
inner loop. Therefore, the counter serves no purpose.
Clearing a page table entry's accessed bit and setting the page's
PG_REFERENCED flag in pmap_protect() can't really be justified, so
don't do it. Moreover, on ia64, don't set the page's dirty field
unless pmap_protect() is removing write access.
secondary, which died between send(2) and recv(2). Do it by adding timeout
to recv(2) for primary incoming and outgoing sockets and secondary outgoing
socket.
Reported by: Mikolaj Golub <to.my.trociny@gmail.com>
Tested by: Mikolaj Golub <to.my.trociny@gmail.com>
MFC after: 3 days
"Whitspace" churn after the VIMAGE/VNET whirls.
Remove the need for some "init" functions within the network
stack, like pim6_init(), icmp_init() or significantly shorten
others like ip6_init() and nd6_init(), using static initialization
again where possible and formerly missed.
Move (most) variables back to the place they used to be before the
container structs and VIMAGE_GLOABLS (before r185088) and try to
reduce the diff to stable/7 and earlier as good as possible,
to help out-of-tree consumers to update from 6.x or 7.x to 8 or 9.
This also removes some header file pollution for putatively
static global variables.
Revert VIMAGE specific changes in ipfilter::ip_auth.c, that are
no longer needed.
Reviewed by: jhb
Discussed with: rwatson
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 6 days
wired. Kstack pages are wired, this change prepares swap pager for handling
of long runs of kstack pages.
Noted and reviewed by: alc
Tested by: pho
MFC after: 2 weeks
This is done in kern_ntptime, perhaps not the best place.
This is done using resettodr().
Some features:
- make save period configurable via tunable and sysctl
- period of zero disables saving, setting a non-zero period re-enables
it or reschedules it
- do saving only if system clock is ntp-synchronized
- save on shutdown
Discussed with: des, Peter Jeremy <peterjeremy@acm.org>
X-Maybe: save time near seconds boundary for better precision
MFC after: 2 weeks
emulated by BIOS using SMI interrupt. On those chipsets reading
from the status port may be thousand times slower than usually.
Sometimes this emilation is not working properly resulting in
commands timing out and since we assume that inb() operation
takes very little time to complete we need to adjust number of
retries to keep waiting time within a designed limits (100ms).
Measure time it takes to make read_status() call and adjust
number of retries accordingly.
To keep it simple, use TSC to measure inb() performance and
keep it to amd64-only, since TSC may not available on older
CPUs.
Also enable detection of the AT controller absence on amd64.
Reviewed by: jhb
MFC after: 1 month
buffers before closing the NFSv4 opens, as the comment states.
This patch deletes the call to nfscl_mustflush() which would
return 0 for the case where a delegation still exists, which
was incorrect and could cause crashes during recovery from
an expired lease.
MFC after: 1 week
named_chrootdir IS set, named-checkconf fails because it
cannot find the conf file. Fix this by making checkconf a
variable that includes "-t $named_chrootdir" as needed.
Notice of the bug and suggested direction for the fix from [1].
Using required_files for named.conf is overkill ever since
I added the named-checkconf call, so rather than update the
logic to handle the case described above, remove it. This
also handles the case where named_chroot_autoupdate IS set
but the symlink doesn't exist yet.
PR: conf/145904
Submitted by: J R Matthews
back in rxeof (I could see little point in taking it out),
and now release it before the stack entry.
Also, make it so the 82574 does not configure for multiqueue
when its not used in the stack.
On top of that, LLVM+Clang mis-compiles this code because of its register
allocator bug.
Analyzed by: Andrew Reilly (areilly at bigpond dot net dot au)
Reviewed by: ariff, rdivacky
MFC after: 3 days
In the end, it does help fixing /dev/io usage from multithreaded
processes.
- On i386 and amd64 the old behaviour is kept but multithreaded
processes must use the new interface in order to work well.
- Support for the other architectures is greatly improved, where
necessary, by the necessity to define very small things now.
Manpage update will happen shortly.
Sponsored by: Sandvine Incorporated
PR: threads/116181
Reviewed by: emaste, marcel
MFC after: 3 weeks
ratectl_node_init() functions and since ni_rtctls was already
malloc'ed() we will panic. Fix this by using the already malloc'ed
pointer.
Found by: bschmidt
Reviewed by: bschmidt
a revert call. In this case don't attempt to remove something that
has not yet been added. Otherwise this jaddref must hang around
to prevent the bitmap write as normal.
the page table entry's accessed bit is either preset by the immediately
preceding call to pmap_enter() or by hardware (or software) upon return
from vm_fault() when the faulting access is restarted.
or unmanaged before acquiring the page queues lock. Neither of these
tests require that lock. Moreover, a better way of testing if the page
is unmanaged is to test the type of vm object. This avoids a pointless
vm_page_lookup().
MFC after: 3 weeks