_thr_suspend_check() which messes sigmask saved in thread structure.
- Don't suspend a thread has force_exit set.
- In pthread_exit(), if there is a suspension flag set, wake up waiting-
thread after setting PS_DEAD, this causes waiting-thread to break loop
in suspend_common().
- Always include the ie_disable and ie_eoi methods in 'struct intr_event'
and collapse down to one intr_event_create() routine. The disable and
eoi hooks simply aren't used currently in the !INTR_FILTER case.
- Expand 'disab' to 'disable' in a few places.
- Use function casts for arm and i386:intr_eoi_src() instead of wrapper
routines since to trim one extra indirection.
Compiled on: {arm,amd64,i386,ia64,ppc,sparc64} x {FILTER, !FILTER}
Tested on: {amd64,i386} x {FILTER, !FILTER}
the referenced data is only obtained/changed in the device open handler,
and the ioctl handler can only run after the open handler. Also fix a
few nearby style issues.
Submitted by: Matt Jacob
drivers.
In the giant_XXX wrappers for the device methods of the D_NEEDGIANT
drivers, do not dereference the cdev->si_devsw. It is racing with
the destroy_devl() clearing of the si_devsw. Instead, use the
dev_refthread() and return ENXIO for the destroyed device. [1]
The check for the D_INIT in the prep_cdevsw() was not synchronized with
the call of the fini_cdevsw() in destroy_devl(), that under rapid device
creation/destruction may result in the use of uninitialized cdevsw [2].
Change the protocol for the prep_cdevsw(), requiring it to be called
under dev_mtx, where the check for D_INIT is done.
Do not free the memory allocated for the gianttrick cdevsw while holding
the dev_mtx, put it into the free list to be freed later. Reuse the
d_gianttrick pointer to keep the size and layout of the struct cdevsw
(requested by phk). Free the memory in the dev_unlock_and_free(), and do
all the free after the dev_mtx is dropped (suggested by jhb).
Reported by: bsdimp + many [1], pho [2]
Reviewed by: phk, jhb
Tested by: pho
MFC after: 1 week
for a configurable number of seconds, spin the disk down. Spin it back
up on the next request.
Notice that the timeout is only armed by a request, so to spin down a
disk you may have to do:
atacontrol spindown ad10 5
dd if=/dev/ad10 of=/dev/null count=1
To disable spindown, set timeout to zero:
atacontrol spindown ad10 0
In order to debug any trouble caused, this code is somewhat noisy on the
console.
Enabling spindown on a disk containing / or /var/log/messages is not
going to do anything sensible.
Spinning a disk up and down all the time will wear it out, use sensibly.
Approved by: sos
10 microseconds is too short.
Always set the cpu to the highest frequency so that we get through
boot and don't handicap cpus where powerd(8) is not used.
10 microseconds is too short.
Always set the cpu to the highest frequency so that we get through
boot and don't handicap cpus where powerd(8) is not used.
monitor mode. This solves a problem that sometimes mangled frames
are passed.
Submitted by: Werner Backes <werner_at_bit-1.de>
Tested by: Werner Backes <werner_at_bit-1.de>
PR: kern/121608
Approved by: thompsa (mentor)
will have a special section, named .PPC.EMB.apuinfo, which will
tell GDB that a BookE processor is targeted and which will
result in GDB using a different register definition. In order
to support remote GDB for BookE, we need the GDB stub in the
kernel look for that section and use the BookE definitions.
uidinfo structure. This entirely removes contention observed on the
ui_mtxp mutex (as it is now gone).
- Convert the uihashtbl_mtx mutex to a rwlock, as most of the time we just
need to read-lock it.
Reviewed by: jhb, jeff, kris & others
Tested by: kris
this means that it no longer grabs the lagg rwlock. Use two port table arrays
which list the active ports for Tx and switch between them with an atomic op.
Now the lagg rwlock is only exclusively locked for management (ioctls) and
queuing of lacp control frames isnt needed.
of the array length needed to store all the directory entries.
Although BSD has historically guaranteed that st_size is the size
of the directory file, POSIX does not, and more to the point, some
recent filesystems such as ZFS use st_size to mean something else.
The fix is to not stat the directory at all, set the initial
array size to 32 entries, and realloc it in powers of 2 if that
proves insufficient.
PR: 113668
a jail, etc. by simply calling setpriority(PRIO_PROCESS, <PID>, 0) and
checking the return value: 0 means that the process exists and -1 that
it doesn't exist.
Reviewed by: rwatson
MFC after: 1 week
Instead of checking each page for PG_UNMANAGED, perform a one-time
check whether the object is OBJT_PHYS. (PG_UNMANAGED pages only
belong to OBJT_PHYS objects.)
with style(9) recommendation that macros not contain the
terminating ';', leaving that to the invoker. All SYSINIT()
consumers must now provide a trailing ';'.
Unlike the change to remove the ';'s from callers, this change
shouldn't be MFC'd unless we don't mind requiring source changes
to third party modules that might still depend on SYSINIT()
providing its own ';'.
after each SYSINIT() macro invocation. This makes a number of
lightweight C parsers much happier with the FreeBSD kernel
source, including cflow's prcc and lxr.
MFC after: 1 month
Discussed with: imp, rink
