ath9k does a few different things here during config - if it's an early
AR5416 with two chains, it enables all three chains for calibration and
then restores the chainmask to the original values after initial
calibration has completed.
The reason behind this commit is to begin breaking out the chainmask
configuration for this specific reason; follow-up commits will add
the chainmask restore in the ar5416Reset() routine.
recent PCIe controllers(RTL8102E or later and RTL8168/8111C or
later) supports either 2 or 4 MSI-X messages. Unfortunately vendor
did not publicly release RSS related information yet. However
switching to MSI-X is one-step forward to support RSS.
architectures that support this .note. In particular, do not unneccessary
emit the notes on ia64 and sparc64, which ABI require non-executable stacks.
Tested by: marcel
* There is no plan for an alternative to the command "set".
* Attempting to unset a readonly variable has not raised an error for quite
a while, so the order of unsetting a variable and a function with the same
name does not matter.
MFC after: 1 week
RTL8111C generated corrupted frames where TCP option header was
broken. All other sample controllers I have did not show such
problem so it could be RTL8111C specific issue. Because there are
too many variants it's hard to tell how many controllers have such
issue. Just disable TSO by default but have user override it.
before checking the validity of the next buffer pointer. Otherwise, the
buffer might be reclaimed after the check, causing iteration to run into
wrong buffer.
Reported and tested by: pho
MFC after: 1 week
Properly document what `make targets` is supposed to list to avoid
further confusion given the place the target sits. Should have happened
with r217125.
Requested by: imp [1]
Reviewed by: rwatson
* Re-do the structure size/component math to make sure the struct matches
the expected size
* Just to be clear that we care about bitmask ordering, revert my previous
change and instead define that macro if we're on big-endian.
It turns out that the V4K eeprom definitions (used by the AR9285 and
its derivatives) is wrong. These values are at least causing issues
on my AR2427.
With this fix (and initvals in a subsequent commit), the AR2427 behaves
a lot better.
Note - there's still significant drift between the ath9k v4k eeprom
init code (again, used by AR9285 and derivatives) and what's in this
tree. That needs to be investigated and resolved.
Khelp/Hhook KPIs to hook into the TCP stack and maintain a per-connection, low
noise estimate of the instantaneous RTT. ERTT's implementation is robust even in
the face of delayed acknowledgements and/or TSO being in use for a connection.
A high quality, low noise RTT estimate is a requirement for applications such as
delay-based congestion control, for which we will be importing some algorithm
implementations shortly.
In collaboration with: David Hayes <dahayes at swin edu au> and
Grenville Armitage <garmitage at swin edu au>
Sponsored by: FreeBSD Foundation
Reviewed by: bz and others along the way
MFC after: 3 months
table in if_grow(). The order of the SYSINIT's for ifnet state were swapped
so that the various locks were initialized before being used.
Reviewed by: pluknet, bz
MFC after: 2 weeks
prevent sending data when CTS is de-asserted.
In uart_tty_intr(), call uart_tty_outwakeup() when the CTS signal
changed, knowing that uart_tty_outwakeup() will do the right
thing for flow control. This avoids redundant conditionals.
PR: kern/148644
Submitted by: John Wehle <john@feith.com>
MFC after: 3 days
