for 1020/1X80/12160/2X00- for readability. Add in 12160 (Ultra3)
support- but not with PPR just yet. Fix and clarify fetching of
return parameter for getting firmware rev which for the 2200 contains
the connection topology (Private Loop (NL-port), N-port, FL-port,
F-port). Synthesize the connection topology for the 2100 which can
only be Private Loop or FL-port. Handle a couple of new async
mailbox commands which signify connection in Point-to-Point mode
(N-port or F-port) or indicate various toe stubbing getting to same.
Approved: jkh@freebsd.org
interface on the dhclient command line. Not doing so screws up vmware's
network interface by attempting to configure it for DHCP (which will
never work, of course). It also would impact any other interface that
may be present that, again, would likely be manually configured for
some other purpose.
Approved by: jkh
parameter is missing, or specified as above, then passwd behaves as normal
when the user enters an all lower case password -- i.e., it prompts them
to use mixed case, and will only grudgingly accept an all lower case
password.
If you negate this entry in login.conf, with "mixpasswordcase@", then
passwd will allow all lower case passwords without complaining.
Approved by: jkh
parameter is missing, or specified as above, then passwd behaves as normal
when the user enters an all lower case password -- i.e., it prompts them
to use mixed case, and will only grudgingly accept an all lower case
password.
If you negate this entry in login.conf, with "mixpasswordcase@", then
passwd will allow all lower case passwords without complaining.
Approved by: jkh
- trying for a fit for a PnP configuration from a device
- soaking up resources from a configuration that were not allocated by
the driver
do not attempt to activate them. Only a device driver that is aware of
the nature of the resource and its suitability can be certain that
activating a resource, particularly a memory resource, is a safe thing
to do.
This was prompted by the discovery that many systems report all physical
memory through a PNP0c02 device; activating this resource maps all
physical memory into the kernel's virtual space, either blowing out the
kernel pagetable or in the worst case causing a panic in pmap_mapdev()
if the system has too much physical memory.
Authorised by: jkh
Reviewed by: dfr
won't appear on the screen, and "blinking" and "destructive" cursor
won't appear in the vty for which the text cursor is currently hidden.
Approved by: jkh
-Should retry as much as possible when some of source
routing intermediate hosts' address families missmatch
happened.
(such as when a host has only A record, and another host
has each of A and AAAA record.)
-Should retry as much as possible when dest addr and
source addr(specified with -s option) address family
missmatch happend
Approved by: jkh
-Should not error return when rresvport_af() failed for one of dest
addrs resolved by getaddrinfo().
Should retry until all dest addr fail.
Approved by: jkh
Some of IPsec authentication related functions should have
'const' for its 2nd argument, but not now.
But if someone try to use them, and passed const data for
those functions, then much bogus compile warnings will be
generated.
So those funcs prototype should be modified.
Requested by: archie
Approved by: jkh
KAME put INET6 related stuff into sys/netinet6 dir, but IPv6
standard API(RFC2553) require following files to be under sys/netinet.
netinet/ip6.h
netinet/icmp6.h
Now those header files just include each following files.
netinet6/ip6.h
netinet6/icmp6.h
Also KAME has netinet6/in6.h for easy INET6 common defs
sharing between different BSDs, but RFC2553 requires only
netinet/in.h should be included from userland.
So netinet/in.h also includes netinet6/in6.h inside.
To keep apps portability, apps should not directly include
above files from netinet6 dir.
Ideally, all contents of,
netinet6/ip6.h
netinet6/icmp6.h
netinet6/in6.h
should be moved into
netinet/ip6.h
netinet/icmp6.h
netinet/in.h
but to avoid big changes in this stage, add some hack, that
-Put some special macro define into those files under neitnet
-Let files under netinet6 cause error if it is included
from some apps, and, if the specifal macro define is not
defined.
(which should have been defined if files under netinet is
included)
-And let them print an error message which tells the
correct name of the include file to be included.
Also fix apps which includes invalid header files.
Approved by: jkh
Obtained from: KAME project
problem was basically (for offset > 4096):
vtophys(addr) + offset != vtophys(addr + offset)
Also, use TD's with a maximum size of 4k instead of 8kb for OHCI
controllers.
This problem occurs in drivers that use large transfer sizes:
umass, host2host and ethernet with jumbo frames.
ntpd.8:
add -gx to SYNOPSIS
clarify explanation of -g
ntp.conf.5:
add missing field description for rawstats lines
Install audio.htm, driver3[567].htm and qth.htm.
or not a process in a jail, with privilege, may set the jail's hostname.
Defaults to 1, which permits this. May be set to 0 by a process with
appropriate privilege outside of jail. Preventing hostname renaming
from within a jail is currently required to make jails manageable, as they
a currently identifiable only by hostname using /proc, which may be
modified without this sysctl being set to 0. This will be documented
in upcoming man commits.
Authorized by: jkh, the ever-patient
back to the vendor branch.
Re-merge changes from the vendor branch.
Undo the local spammed changes that I could find. There are probably
more local fixes that were clobbered that I've missed.
IPv6 scoped addr display is not yet supported by ifconfig
and route. Now almost of IPv6 apps support it, so its support
in ifconfig and route is important to keep consisetncy, and
to avoid user confusion.
Approved by: jkh
(shortend format, etc)
Current KAME getaddrinfo() supports only d.d.d.d format IPv4
addr. But traditionally inet_aton() and etc support other formats.
(shortend format and octal/deciaml/hex format)
Aboud this,
-As far as the discussion on freebsd-current, many people
think traditional format should also be supported by getaddrinfo().
-X/Open spec requires getaddrinfo() also support those
traditional IPv4 format.
-RFC2553 say nothing about it.
-As the result of confirmation in ietf/ipng list, there is
no clear concensus yet, and the reply was, "RFC2553 update
and X/Open spec will be in sync"
So takeing these conditions into account, I think
getaddrinfo() should also support traditional IPv4 format.
Specified by: Marc Schneiders <marc@oldserver.demon.nl>
Approved by: jkh
strictly a security hole, but neither is it a very good idea. Replace
it with a symlink to /dev/null to happify programs that expect it.
It is suggested that users of the jail environment modify the jail's
syslog.conf to not send stuff to /dev/console, but instead syslog
it somewhere else. Such as a loghost, potentially even to the host
environment's syslog.
Approved by: jkh
