may be installed as cc and we don't need to build gcc as a
cross-tools, we still build gcc and thus need cc_tools built
as a build tool. Not doing this results in building gengenrtl with
the target compiler while we need to run it on the build machine.
Use whitespace (spaces and tabs) as the delimiter.
Consecutive spaces and tabs count as one single field
separator.
Reviewed by: swildner@dragonflybsd.org
Approved by: cperciva
Obtained from: DragonFlyBSD
MFC after: 1 week
encryption types.
The AR5210 only has four WEP key slots, in contrast to what the
later MACs have (ie, the keycache.) So there's no way to store a "clear"
key.
Even if the driver is taught to not allocate CLR key entries for
the AR5210, the hardware will actually attempt to decode the encrypted
frames with the (likely all 0!) WEP keys.
So for now, disable the hardware encryption entirely and just so it
all in software. That allows both WEP -and- WPA to actually work.
If someone wishes to try and make hardware WEP _but_ software WPA work,
they'll have to create a HAL capability to enable/disable hardware
encryption based on the current STA/Hostap mode. However, making
multi-vap work with one WEP and one WPA VAP will require hardware
encryption to be disabled anyway.
received granular locking) but the comment present in UFS has been
copied all over other filesystems code incorrectly for several times.
Removes comments that makes no sense now.
Reviewed by: kib
MFC after: 3 days
then:
- assume the lock is held in exclusive mode and remove a moot check
about the lock acquisition.
- in the destructor remove !MPSAFE specific chunk.
Reviewed by: kib
MFC after: 2 weeks
Also remove the checks from vop_lookup_pre and vop_lookup_post, which
are now completely redundant (before this change they were partially
redundant).
Discussed with: kib
MFC after: 10 days
cmdlengthdelta is the size of the header and we were using it to
allocate a buffer to store the command line. This would mean that
the cmdbuf could be too short. In practice this was never noticed unless
you usually run top -a. On a stock FreeBSD system you can see the
problem by running sendmail and then running top -a on a big terminal
window. In practice this doubles to size available to cmdbuf since the
header is around 65-68 bytes.
Reviewed by: adrian
other than UART 0 from the outset.
o) Print board information from sysinfo after consoles have been initialized
rather than doing it during boot descriptor parsing.
o) Use cvmx_safe_printf and platform_reset rather than panic when doing very
early boot descriptor parsing before the console is set up.
o) Get rid of the global octeon_bootinfo.
- Use 2001:db8:: as an example instead of deprecated 3ffe:: address block.
- Add check for connected routes.
- Add support of RTM_IFANNOUNCE for dyanmically-added/removed interfaces.
- Add support of *, ?, and [ in the interface list.
- Add -P number to specify route flag which will never expire.
- Add -Q number to specify route flag which route6d will add to routes via RIP.
- Add -p pidfile to specify the process ID file.
