testing it to know whether we should enable the 82503 serial mode...
Move code to the right location and disallow the use of the 82503
serial mode if the sc->revision field is 0 again. This makes fxp(4)
work correctly with ATMEL 350 93C46 cards (3 port 82559 based with a
82555 PHY), as well as with the older ATMEL 220 93C46 (same flavour)
and with the even older 10Mbps-only 82557 cards with the 82503 serial
interface.
Tested by: Andre Albsmeier <andrer@albsmeier.net>, krion
MFC after: 2 weeks
. Replace inclusion of sys/param.h to sys/cdefs.h and sys/types.h where
appropriate.
. move _*_init() prototypes to mblocal.h, and remove these prototypes
from .c files
. use _none_init() in __setrunelocale() instead of duplicating code
. move __mb* variables from table.c to none.c allowing us to not to
export _none_*() externs, and appropriately remove them from mblocal.h
Ok'ed by: tjr
appears in LC_COLLATE files (due to alignment). An alternative
would be to bump STR_LEN to 16.
(This is in preparation to make LC_COLLATE files architecture
independent.)
SMP systems. It appears all drivers except ichss should attach to each
CPU and that settings should be performed on each CPU. Add comments about
this. Also, add a guard for p4tcc's identify method being called more than
once.
do something sensible (namely: treat then '\0' as the EOL character, when
deciding what "a line" is for -N). Note that -I implies -N.
MFC after: 3 days
12 MB to run). These technically reflect 5.3-RELEASE figures,
but are probably closer to reality than the older numbers (8MB / 7MB).
While here, s/megs/MB/ to consistify our terminology.
PR: docs/77304
Submitted by: Ramiro Aceves
with moderate IO going on, system usage can hover around 65-77% even
though it would benefit from higher performance. Typically, only truly
idle systems pass the 90% mark so only demote then.
debug.cpufreq.lowest tunable and sysctl. Some systems seem to have problems
with the lowest frequencies so setting this prevents them from being
available or used.
introducing the disk formats for _RuneLocale and friends.
The disk formats do not have (useless) pointers and have 32-bit
quantities instead of rune_t and long. (htonl(3) only works
with 32-bit quantities, so there's no loss).
Bootstrap mklocale(1) when necessary. (Bootstrapping from 4.x
would be trivial (verified), but we no longer provide pre-5.3
source upgrades and this is the first commit to actually break
it.)
ARM_TP_ADDRESS, where the tp will be stored. On CPUs that support it, a cache
line will be allocated and locked for this address, so that it will never go
to RAM. On CPUs that does not, a page is allocated for it (it will be a bit
slower, and is wrong for SMP, but should be fine for UP).
The tp is still stored in the mdthread struct, and at each context switch,
ARM_TP_ADDRESS gets updated.
Suggested by: davidxu
