Badly formed ELF note may cause the caclulated pointer to the next note
to point both after the note region, that was checked in the code, but
also to point before the region, that was not checked [1]. Remember the
first note location in note0 and leap out if the note is not between
note0 and note_end.
In the similar way, badly formed note may cause infinite loop by
pointing next note into the same or previous note. Guard against this by
limiting amount of loop iterations by arbitrary choosen big number.
For clarity, check the calculated note alignment in each iteration.
Reported by: Chris Palmer <chris noncombatant org> [1]
PR: kern/132886
Reviewed and tested by: dchagin
MFC after: 3 days
it is right for only a tiny fraction of these devices and this
wild-card entry is too broad.
# I run a kernel without this entry at all without ill effects...
stored in the pmap is from the direct map region. The two exceptions have
been the kernel pmap and the swapper's pmap. These pmaps have used a
kernel virtual address established by pmap_bootstrap() for their shared
pml4 page table page. However, there is no reason not to use the direct
map for these pmaps as well.
they were passed uninitialized to in6_pcblookup_hash. Instead, do as is done
for IPv4 and use the addresses within the sockaddr structure, which are
correctly populated.
This fixes tcpdrop(8) for IPv6 address pairs.
Reviewed by: bz
definitely doing an NFSv2 or NFSv3 RPC, rather than sometimes doing
so and sometimes not. This makes it easier to add a DTrace return
probe at a single point in the function.
MFC after: 1 week
The tick routine was not being restarted in the init_locked routine
which could resulted in loss of carrier when updating the MTU.
Submitted by: Navdeep Parhar at Chelsio
MFC after: 3 weeks
- If boot verbose, print asicrev, chiprev and bus type on attach.
- For PCI Express devices:
1) Adjust max read request size to 4Kbytes
2) Turn on FIFO_LONG_BURST in RDMA during bge_blockinit()
Though 1) does not seem to have much to do with the poor TX performance
observed on PCI Express bge(4), 2) does fix the problem. [1]
- Nuke the RX CPU self-diag, which prevents working cards from working
(Linux tg3 does not have this diag neither does OpenBSD's bge(4)).
The increasing of the firmware handshaking timeout to 20000 retries
done as part of the original commit isn't merged as way already have a
way higher BGE_TIMEOUT of 100000.
PR: 119361 [1]
Obtained from: tg3 via DragonflyBSD [1], DragonflyBSD
Workaround for buggy USB hardware not handling new SETUP packet before STATUS
stage is complete, this allows xfers to endpoint0 to return a short frame.
Submitted by: Hans Petter Selasky
Reported by: me
Workaround for buggy USB hardware not handling new SETUP packet before STATUS
stage is complete, this allows xfers to endpoint0 to return a short frame.
Submitted by: Hans Petter Selasky
Reported by: me
