Add the ability to set `prefer_source' flag to an IPv6 address.
It affects the IPv6 source address selection algorithm (RFC 6724)
and allows override the last rule ("longest matching prefix") for
choosing among equivalent addresses. The address with `prefer_source'
will be preferred source address.
Fix ifconfig to show pltime and vltime with -L option,
again after usage change from time_second to time_uptime.
PR: 188520
Submitted by: Guy Yur <guyyur__at__gmail.com>
made in r263029.
Merge r257186,257215,257349,259736,261797.
These changesets split pfvar.h into several smaller headers and make
userland utilities to include only some of them.
Provide a working example line for an interface with 1 address running
with CARP.
Currently, we've got a problem that interface isn't IFF_UP at the time
we assign it a redundant address, and the latter gets stuck in INIT state.
Additional SIOCSIFFLAGS from ifconfig(8) kicks it to a working state.
A proper fix is kernel side and appeared to be non-trivial, not to be
checked in before 10.0-RELEASE.
Submitted by: Ole Myhre <ole.myhre dataoppdrag.no>
Approved by: re (kib)
It stops treating the address on the interface as special by source
address selection rule even when the interface is outgoing interface.
This is desired in some situation.
Requested by: hrs
Reviewed by: IHANet folks including hrs
MFC after: 1 week
- Check V_deembed_scopeid before checking if sa_family == AF_INET6.
- Fix scope id handing in route(8)[2] and ifconfig(8).
Reported by: rpaulo[1], Mateusz Guzik[1], peter[2]
userland via routing socket or sysctl. This eliminates the following
KAME-specific sin6_scope_id handling routine from each userland utility:
sin6.sin6_scope_id = ntohs(*(u_int16_t *)&sin6.sin6_addr.s6_addr[2]);
This behavior can be controlled by net.inet6.ip6.deembed_scopeid. This is
set to 1 by default (sin6_scope_id will be filled in the kernel).
Reviewed by: bz
seemingly mysterious actions that are not done by ifconfig itself, but
by devd triggering on events caused by ifconfig.
PR: docs/173405
Submitted by: Mateusz Kwiatkowski <mateusz.kwiatkowski@atlashost.eu>
MFC after: 1 week
implementation of RFC 3484 for this purpose for a long time and "prefer_source"
was never implemented actually. ND6_IFF_PREFER_SOURCE macro is left intact.
- Stateful TCP offload drivers for Terminator 3 and 4 (T3 and T4) ASICs.
These are available as t3_tom and t4_tom modules that augment cxgb(4)
and cxgbe(4) respectively. The cxgb/cxgbe drivers continue to work as
usual with or without these extra features.
- iWARP driver for Terminator 3 ASIC (kernel verbs). T4 iWARP in the
works and will follow soon.
Build-tested with make universe.
30s overview
============
What interfaces support TCP offload? Look for TOE4 and/or TOE6 in the
capabilities of an interface:
# ifconfig -m | grep TOE
Enable/disable TCP offload on an interface (just like any other ifnet
capability):
# ifconfig cxgbe0 toe
# ifconfig cxgbe0 -toe
Which connections are offloaded? Look for toe4 and/or toe6 in the
output of netstat and sockstat:
# netstat -np tcp | grep toe
# sockstat -46c | grep toe
Reviewed by: bz, gnn
Sponsored by: Chelsio communications.
MFC after: ~3 months (after 9.1, and after ensuring MFC is feasible)
Currently, 'ifconfig laggX down' does not remove members from this
lagg(4) interface. So, 'service netif stop laggX' followed by
'service netif start laggX' will choke, because "stop" will leave
interfaces attached to the laggX and ifconfig from the "start" will
refuse to add already-existing interfaces.
The real-world case is when I am bundling together my Ethernet and
WiFi interfaces and using multiple profiles for accessing network in
different places: system being booted up with one profile, but later
this profile being exchanged to another one, followed by 'service
netif restart' will not add WiFi interface back to the lagg: the
"stop" action from 'service netif restart' will shut down my main WiFi
interface, so wlan0 that exists in the lagg0 will be destroyed and
purged from lagg0; the "start" action will try to re-add both
interfaces, but since Ethernet one is already in lagg0, ifconfig will
refuse to add the wlan0 from WiFi interface.
Since adding the interface to the lagg(4) when it is already here
should be an idempotent action: we're really not changing anything,
so this fix doesn't change the semantics of interface addition.
Approved by: thompsa
Reviewed by: emaste
MFC after: 1 week
headers for TSO but also for generic checksum offloading. Ideally we
would only have one common function shared amongst all drivers, and
perhaps when updating them for IPv6 we should introduce that.
Eventually we should provide the meta information along with mbufs to
avoid (re-)parsing entirely.
To not break IPv6 (checksums and offload) and to be able to MFC the
changes without risking to hurt 3rd party drivers, duplicate the v4
framework, as other OSes have done as well.
Introduce interface capability flags for TX/RX checksum offload with
IPv6, to allow independent toggling (where possible). Add CSUM_*_IPV6
flags for UDP/TCP over IPv6, and reserve further for SCTP, and IPv6
fragmentation. Define CSUM_DELAY_DATA_IPV6 as we do for legacy IP and
add an alias for CSUM_DATA_VALID_IPV6.
This pretty much brings IPv6 handling in line with IPv4.
TSO is still handled in a different way and not via if_hwassist.
Update ifconfig to allow (un)setting of the new capability flags.
Update loopback to announce the new capabilities and if_hwassist flags.
Individual driver updates will have to follow, as will SCTP.
Reported by: gallatin, dim, ..
Reviewed by: gallatin (glanced at?)
MFC after: 3 days
X-MFC with: r235961,235959,235958
Allow tso4 and tso6 be set individually given we have the bits.
This will help with drivers not working as expected during the
transition time and later.
Sponsored by: The FreeBSD Foundation
Sponsored by: iXsystems
Reviewed by: gnn
MFC After: 1 week
reality:
1. Only 12-bit VLAN Identifiers, not full 16-bit VLAN tags can be set using
ifconfig vlan.
2. When we mean VLAN Identifiers, spell it that way, rather than as VLAN tag.
MFC after: 3 days
Sponsored by: Adara Networks, Inc.
from scratch, copying needed functionality from the old implemenation
on demand, with a thorough review of all code. The main change is that
interface layer has been removed from the CARP. Now redundant addresses
are configured exactly on the interfaces, they run on.
The CARP configuration itself is, as before, configured and read via
SIOCSVH/SIOCGVH ioctls. A new prefix created with SIOCAIFADDR or
SIOCAIFADDR_IN6 may now be configured to a particular virtual host id,
which makes the prefix redundant.
ifconfig(8) semantics has been changed too: now one doesn't need
to clone carpXX interface, he/she should directly configure a vhid
on a Ethernet interface.
To supply vhid data from the kernel to an application the getifaddrs(8)
function had been changed to pass ifam_data with each address. [1]
The new implementation definitely closes all PRs related to carp(4)
being an interface, and may close several others. It also allows
to run a single redundant IP per interface.
Big thanks to Bjoern Zeeb for his help with inet6 part of patch, for
idea on using ifam_data and for several rounds of reviewing!
PR: kern/117000, kern/126945, kern/126714, kern/120130, kern/117448
Reviewed by: bz
Submitted by: bz [1]
