The following systems are affected:
- MPC8555CDS
- MPC8572DS
This overhaul covers the following major changes:
- All integrated peripherals drivers for Freescale MPC85XX SoC, which are
currently in the FreeBSD source tree are reworked and adjusted so they
derive config data out of the device tree blob (instead of hard coded /
tabelarized values).
- This includes: LBC, PCI / PCI-Express, I2C, DS1553, OpenPIC, TSEC, SEC,
QUICC, UART, CFI.
- Thanks to the common FDT infrastrucutre (fdtbus, simplebus) we retire
ocpbus(4) driver, which was based on hard-coded config data.
Note that world for these platforms has to be built WITH_FDT.
Reviewed by: imp
Sponsored by: The FreeBSD Foundation
most one call to pmap_qremove(), and thus one TLB shootdown, instead of one
call and TLB shootdown per page.
Simplify the interface to vm_hold_free_pages().
MFC after: 3 weeks
was needed at preliminary version of the patch, where number of CPU ticks
was divided strictly on 16 seconds. Final code instead uses real interval
duration, so precise interval should not be important. Same time aliasing
issues around second boundary causes false positives, periodically logging
useless "t_delta ... too long/short" messages when HZ set below 256.
start so we should adjust the mbuf if the driver is running in PIO mode.
Now it should work well with WPA authentication and association for LP
PHY devices.
Tested by: Warren Block <wblock at wonkity.com>
MFC after: 1 month
Specifically, teach pmap_qenter() to recognize the case when it is being
asked to replace a mapping with the very same mapping and not generate
a shootdown. Unfortunately, the buffer cache commonly passes an entire
buffer to pmap_qenter() when only a subset of the mappings are changing.
For the extension of buffers in allocbuf() this was resulting in
unnecessary shootdowns. The addition of new pages to the end of the
buffer need not and did not trigger a shootdown, but overwriting the
initial mappings with the very same mappings was seen as a change that
necessitated a shootdown. With this change, that is no longer so.
For a "buildworld" on amd64, this change eliminates 14-15% of the
pmap_invalidate_range() shootdowns, and about 4% of the overall
shootdowns.
MFC after: 3 weeks
quirks for weak-symbol handling. Text symbols require also marking weak
the special dot-symbol associated with the function, and data symbols
require that you not do that. To fix this, provide a hacked
__weak_reference for powerpc64, and define a new __weak_reference_data
for the single weak data symbol in base.
Revert after: binutils 2.17 import
Obtained from: projects/ppc64
checksum offloading is enabled. The frame has a valid checksum
value so payload might be modified during TX checksum calculation.
Disable TX checksum offloading but give users chance to enable it
when they know their controller works without problems with TX
checksum offloading.
Reported by: Andrzej Tobola <ato <> iem dot pw dot edu dot pl>
- change the type of pm_active to cpumask_t, which it is;
- in pmap_remove_pages(), compare with PCPU(curpmap), instead of
dereferencing the long chain of pointers [1].
For amd64 pmap, remove the unneeded checks for validity of curpmap
in pmap_activate(), since curpmap should be always valid after
r209789.
Submitted by: alc [1]
Reviewed by: alc
MFC after: 3 weeks
the maintenance of vm_pageout_deficit can be localized to just two places:
vm_page_alloc() and vm_pageout_scan().
This change also corrects an off-by-one error in the maintenance of
vm_pageout_deficit. Historically, the buffer cache functions, allocbuf()
and vm_hold_load_pages(), have not taken into account that vm_page_alloc()
already increments vm_pageout_deficit by one.
Reviewed by: kib
- Run the adapter's tick at 1Hz and remove link state checks from it.
Instead, have each port check its link state. Delay the check so that
it takes place slightly after the driver is notified of a change in
link state. This is a cheap way to debounce these notifications if
many are received in rapid succession. POLL_LINK_1ST_TIME flag can
also be eliminated as a side effect of these changes.
- Do not reset the PHY when link goes down.
- Clear port's link_fault flag if the PHY indicates link is down.
- get_link_status_r should leave speed and duplex alone when link is down.
MFC after: 1 month
checksum is enabled in sge_init_locked().
While I'm here do not set RX checksum bits in RX descriptor
initialization. It is controller's job to set these bits.
Tested by: xclin <xclin <> cs dot nctu dot edu dot tw >
