control block. Allow the socket and tcpcb structures to be freed
earlier than inpcb. Update code to understand an inp w/o a socket.
Reviewed by: hsu, silby, jayanth
Sponsored by: DARPA, NAI Labs
routine does not require a tcpcb to operate. Since we no longer keep
template mbufs around, move pseudo checksum out of this routine, and
merge it with the length update.
Sponsored by: DARPA, NAI Labs
that a command completion happened, all further processing is deferred to
a taskqueue. The taskqueue itself runs implicetely under Giant, but we
already used a taskqueue for the biodone() processing, so this at least
saves the contesting of Giant in the interrupt handler.
retain symetry with aac_alloc_commans(). Since aac_alloc_commands()
allocates fib maps and places them onto the fib lists, aac_free_commands()
should reverse those operations.
o Combine two ifs with the same body with an ||.
o Switch from uintptr_t to uint32_t for fib map load operations.
The target is a uint32_t so using this type for the map load call
avoids an extra cast. uintptr_t should only be used when you need
an "int sized the same as the machine's poitner size" which is not
the case here.
o Removed the commented out M_WAITOK flag in the allocation in
aac_alloc_commands(). The kernel will only block in the allocator
if it can grow the size of the kernel. This usually results in a
page-out which could involve this aac device. Thus, sleeping here
could deadlock the machine. Assuming this operation is occurring outside
of attach time, we have enough fibs to operate anyway, so waiting for
fibs to free up is okay if not optimal.
o In aac_alloc_commands(), if we cannot dmamem_alloc additional fib
space, free the fib map.
o In aac_alloc_commands(), if we cannot create per-command dmamaps, don't
lose track of the fib map that is mapping all of the commands that we
have already released into the free pool. Instead, just cut out of
the loop and modify aac_free_commands to not attempt to free maps that
have not been allocated.
o Don't use a magic number when pre-allocating fibs.
o Use PAGE_SIZE to allocate in page sized chunks instead of an
architecture specific constant.
Submitted by: gibbs
- delay acks for T/TCP regardless of delack setting
- fix bug where a single pass through tcp_input might not delay acks
- use callout_active() instead of callout_pending()
Sponsored by: DARPA, NAI Labs
wish the busdma APIs were more consistent accross architectures.
We should probably move all the other DMA map creations in
xl_attach() where we can really handle them failing, since
xl_init() is void and shouldn't fail.
Pointy hat to: mux
Tested by: Anders Andersson <anders@hack.org>
<sys/endian.h>. It is needed to cross-build sparc64 on
RELENG_4 and to build sparc64 on say 5.0-DP1 (on systems
without <sys/endian.h>). This will be revisited when we
create RELENG_5.
Spotted by: make universe
One of the vnodes is on different mount and is possibly on a different
kind of filesystem; treating it as an smbfs vnode then writing to it
will probably corrupt it.
PR: 48381
MFC after: 1 month
group number properly based on the board id. Perform dummy reads of
registers after writing to flush the hardware write buffers.
This gets the soon to be committed zs attachment working.
Some DVcam(ex. Panasonic NV-DS1 DV camcorder) doesn't seems to set
this bit even if it's for PAL. Fix the DSF bit for such cases so that
we can send back the stream to the DVcam without problem.
Problem Reported by: Richard Tobin <richard@cogsci.ed.ac.uk>
- Make the number of bulkxfer packets(NPACKET_T) and the number of packets
write at once(TNBUF) to be different values.
I observe some block noise for large TNBUF.
- Show the detection of NTSC or PAL.
- Pad with 0xff rather than 0x00 for broken frames.
- Bzero hdr[0].
- Remove unused code.
for the sorts of errors we run into[1]. This also gives us room to put in a
vaguely appropriate casts to silence warnings since our compiler doesn't like
when we compare ssize_t to size_t[2]. Add a cast in sblock.c[3] to silence
a warning because of signed vs. size_t hell (again). Clean up nearby
excessive parenthemutilation[4].
Reviewed by: bde [2] [3]
Suggested by: bde, many [1]
Submitted by: bde [4]
An aside about [4], bde notes that we do not check for a negative value for
the fs bsize. I'm nto going to do that in every situation we use it, one must
expect a reasonable program to pass down reasonable values. Some foot shooting
protection I will tolerate, some I will not. Also he suggests some possible
conditional improvements there, which I may take to heart.
PS: For me at least, this is now WARNS=5 clean...
Minor CIS resource allocation code cleanup
Remove some fairly useless debug writes.
This finishes the work to move as much cardbus code as possible into
pci. We wind up removing 800-odd lines from cardbus.c: we go from
1285 to 400 lines.
Reviewed by: mdodd
bus_dmamap_load() it.
- Make it so reusing mbufs when we can't allocate (or map) new ones
actually works. We were previously trying to reuse a mbuf which
was already bus_dmamap_unload()'ed.
Reviewed by: silby
