conflicts due to radically different approaches to security and bug fixes.
In some cases I re-started from the vendor version and reimplemented our
patches. Fortunately, this is not enabled by default in -current.
is used to grab and hold some number of multicast addresses in order
to test what happens when an interface goes over the number of multicast
addresses it can filter in hardware.
Initialize %ds, %es, and %fs during CPU startup. Otherwise a garbage
value could leak to a 32-bit process if a process migrated to a different
CPU after exec and the new CPU had never exec'd a 32-bit process.
A more complete fix is needed, but this mitigates the most frequent
manifestations.
Obtained from: ups
it's non-NULL, as all callers can and should already do the required
checking. Update comments a bit more to talk about rawcb allocation
for consumers.
Reviewed by: bz
MFC after: 3 weeks
it in detail.
When setting media, don't error out when a specific media is selected.
# Note: There may be some issues still here since the EtherJet PC Card doesn't
# conform to the datasheet. Many different kinds of dongles can be plugged in
# and it is unknown how to ask which one it is.
Also, add a /* bad! */ comment to a 1/2 second delay after we set the
DC/DC parameters. This should be a *sleep of some sort for !cold.
Fortunately it is the only one and is only used when setting media, so
the benefit from removing it is small. Unfortunately, it likely
serves as an exemplar of good programming techniques, which it isn't.
2) Adds some __UserSpace__ on some of the common defines that
the user space code needs
3) Fixes a bug when we send up data to a user that failed. We
need to a) trim off the data chunk headers, if present, and
b) make sure the frag bit is communicated properly for the
msgs coming off the stream queues... i.e. we see if some
of the msg has been taken.
Obtained from: jeli contributed the VIMAGE changes on this pass Thanks Julain!
socket support. These utility routines are used only for routing and
pfkey sockets, neither of which have a notion of address, so were
required to mock up fake socket addresses to avoid connection
requirements for applications that did not specify their own fake
addresses (most of them).
Quite a bit of the removed code is #ifdef notdef, since raw sockets
don't support bind() or connect() in practice. Removing this
simplifies the raw socket implementation, and removes two (commented
out) uses of dtom(9).
Fake addresses passed to sendto(2) by applications are ignored for
compatibility reasons, but this is now done in a more consistent way
(and with a comment). Possibly, EINVAL could be returned here in
the future if it is determined that no applications depend on the
semantic inconsistency of specifying a destination address for a
protocol without address support, but this will require some amount
of careful surveying.
NB: This does not affect netinet, netinet6, or other wire protocol
raw sockets, which provide their own independent infrastructure with
control block address support specific to the protocol.
MFC after: 3 weeks
Reviewed by: bz
when it worked as generic IDE.
PR: 125422
Submitted by: Andrey V. Elsukov <bu7cher at yandex dot ru>
Approved by: imp (mentor, implicit)
MFC after: 1 week
generation of RTL810x PCIe fast ethernet controller. Note, Tx/Rx
descriptor format is different from that of first generation of
RTL8101E series. Jumbo frame is not supported for RTL810x
family.
Tested by: NAGATA Shinya ( maya AT negeta DOT com )
mutexes and replacing the obsolete if_watchdog interface. The ndis_ticktask
function calls into ieee80211_new_state under one condition with NDIS_LOCK
held. The ieee80211_new_state would call into ndis_start in some cases too,
resulting in the occasional case where ndis_start acquires NDIS_LOCK from
inside the NDIS_LOCK held by ndis_ticktask.
Obtained from: Paul B. Mahol <onemda@gmail.com>
MFC after: 1 week
page directory pages from VM_MIN_KERNEL_ADDRESS through the end of the
kernel's bss. Specifically, the dependence was in pmap_growkernel()'s one-
time initialization of kernel_vm_end, not in its main body. (I could not,
however, resist the urge to optimize the main body.)
Reduce the number of preallocated page directory pages to just those needed
to support NKPT page table pages. (In fact, this allows me to revert a
couple of my earlier changes to create_pagetables().)
- Fix a number of potential memory leaks in libgeom related to doing realloc
without freeing old pointer if things go wrong.
- Fix a number of places in libgeom where malloc and calloc return values
were not checked.
- Check malloc return value and provide sufficient warning messages when XML
parsing fails.
PR: kern/83464
Submitted by: Dan Lukes <dan - at - obluda.cz>
Approved by: kib (mentor)
page table pages have to be preallocated ...'', violates an assumption made
by minidumpsys(): kernel_vm_end is the highest virtual address that has ever
been used by the kernel. Now, however, the kernel code, data, and bss may
reside at addresses beyond kernel_vm_end. This revision modifies the upper
bound on minidumpsys()'s two page table traversals to account for this
possibility.
The changes to make the option work are already in place, but I missed
the patch hunk that adds it to the getopt() option-handling loop.
Pointy hat: keramida
Approved by: flz
MFC after: 1 week
