resource deallocation back to fifo_close(). This eliminates any
stale data that might be stuck in the socket buffers after all the
readers and writers have closed the fifo.
Tested by: Thorsten Schroeder <ths@katjusha.de>
on friday 13th and without making a universe). This adds struct and
constant definitions for ATM traffic parameters and re-enables the
build of the midway driver.
Tested by: make universe
Previously, any normal I/O on an fdc(4) device would fail with ENXIO
if the device had been opened in non-blocking mode and then closed
prior to the conventional access; that would last until the floppy
disk was ejected and re-inserted to raise the unit attention condition.
Add a clarifying comment.
populated. Apparently, if you use an ehci controller, it's not.
Use usbd_device2interface_handle() to retrieve the interface handle.
NOTE: uaa->iface is populated in the probe routine, so I suspect the
fact that it's NULL in the attach routine is a bug in the ehci driver.
Also, don't depend on the PHY addresses returned by the AXE_CMD_READ_PHYID
command. The address is correct for my LinkSys NIC, but a user has
reported that with a D-Link NIC, the PHYID command returns address 4
while the attached Broadcom PHY is in fact strapped for address 0.
Instead, latch onto the first PHY address that returns valid data
during a readreg operation.
- Add vm page queue locking in certain places that are only needed on
sparc64.
This should make pmap_qenter and pmap_qremove MP-safe.
Discussed with: alc
as should every block device strategy routine.
There was at least one evil consequence of not doing so:
Some errors returned by fdstrategy() could be lost (EAGAIN,
in particular.)
PR: kern/52338 (in the audit-trail)
Discussed with: bde
to access floppy parameters through it.
Note: The DIOCGSECTORSIZE and DIOCGMEDIASIZE handlers withing
fdioctl() couldn't be just moved to below the existing check
for blocking mode because fd->ft can be non-NULL while still
in non-blocking mode (fd->ft can be set with the FD_STYPE ioctl.)
PR: kern/52338
No MFC: Not applicable to STABLE
schedules an upcall. Signal delivering to a bound thread is same as
non-threaded process. This is intended to be used by libpthread to
implement PTHREAD_SCOPE_SYSTEM thread.
2. Simplify kse_release() a bit, remove sleep loop.
ulpt_status() afterwards. This fixes a crash that can occur if a
USB printer is power-cycled when printing is just starting. The
problem is similar to that fixed in revision 1.33, but it is much
less likely to occur.
MFC after: 1 week
panics. Before revision 1.38, we used to just point panicstr at the
format string if panicstr was NULL, but since we now use a static
buffer for the formatted panic message, we have to be careful to
only write to it during the first panic.
Pointed out by: bde
UFS quota implementation. Push some quite broken access control
logic out of ufs_quotactl() into the individual command
implementations in ufs_quota.c; fix that logic. Pass in the thread
argument to any quotactl command that will need to perform access
control.
o quotaon() requires privilege (PRISON_ROOT).
o quotaoff() requires privilege (PRISON_ROOT).
o getquota() requires that:
If the type is USRQUOTA, either the effective uid match the
requested quota ID, that the unprivileged_get_quota flag be
set, or that the thread be privileged (PRISON_ROOT).
If the type is GRPQUOTA, require that either the thread be
a member of the group represented by the requested quota ID,
that the unprivileged_get_quota flag be set, or that the
thread be privileged (PRISON_ROOT).
o setquota() requires privilege (PRISON_ROOT).
o setuse() requires privilege (PRISON_ROOT).
o qsync() requires no special privilege (consistent with what
was present before, but probably not very useful).
Add a new sysctl, security.bsd.unprivileged_get_quota, which when
set to a non-zero value, will permit unprivileged users to query user
quotas with non-matching uids and gids. Set this to 0 by default
to be mostly consistent with the previous behavior (the same for
USRQUOTA, but not for GRPQUOTA).
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
from the tree until it is fixed. Since it is an atm driver, it isn't
commonly used so this will not negatively impact too many people.
harti can reconnect it when he resurfaces and corrects the en module
problems. This should allow snapshots to start succeeding again.
Reported by: lots of people
which meant no process would run for longer than 20ms.
- Slightly redo the interactivity scorer. It follows the same algorithm but
in a slightly more correct way. Previously values above half were
incorrect.
- Lower the interactivity threshold to 20. It seems that in testing non-
interactive tasks are hardly ever near there and expensive interactive
tasks can sometimes surpass it. This area needs more testing.
- Remove an unnecessary KTR.
- Fix a case where an idle thread that had an elevated priority due to
priority prop. would be placed back on the idle queue.
- Delay setting NEEDRESCHED until userret() for threads that haad their
priority elevated while in kernel. This gives us the same context switch
optimization as SCHED_4BSD.
- Limit the child's slice to 1 in sched_fork_kse() so we detect its behavior
more quickly.
- Inhert some of the run/slp time from the child in sched_exit_ksegrp().
- Redo some of the priority comparisons so they are more clear.
- Throttle the frequency of sched_pctcpu_update() so that rounding errors
do not make it invalid.
and return NULL.
vinum_scandisk: Don't handle NULL device pointers.
Only look at compatibility partition for i386. This
is a kludge which should go away once I have adequate
documentation for the New World Order.
Together, these fixes remove occasional error messages about
non-existent drives. They may also fix a number of problems that have
been reported without a PR.
PRs: None
directory vnodes use to refer to their constituent vnodes, into
union_dircache_free(). Also s/union_dircache/union_dircache_get/ and
tweak the structure of union_dircache_r().
MFC after: 3 days
to the machine-independent parts of the VM. At the same time, this
introduces vm object locking for the non-i386 platforms.
Two details:
1. KSTACK_GUARD has been removed in favor of KSTACK_GUARD_PAGES. The
different machine-dependent implementations used various combinations
of KSTACK_GUARD and KSTACK_GUARD_PAGES. To disable guard page, set
KSTACK_GUARD_PAGES to 0.
2. Remove the (unnecessary) clearing of PG_ZERO in vm_thread_new. In
5.x, (but not 4.x,) PG_ZERO can only be set if VM_ALLOC_ZERO is passed
to vm_page_alloc() or vm_page_grab().
Devices below may experience a change in geometry.
* Due to a bug, aic(4) never used extended geometry. Changes all drives
>1G to now use extended translation.
* sbp(4) drives exactly 1 GB in size now no longer use extended geometry.
* umass(4) drives exactly 1 GB in size now no longer use extended geometry.
For all other controllers in this commit, this should be a no-op.
Looked over by: scottl
Devices below may experience a change in geometry.
* Due to a bug, aic(4) never used extended geometry. Changes all drives
>1G to now use extended translation.
* sbp(4) drives exactly 1 GB in size now no longer use extended geometry.
* umass(4) drives exactly 1 GB in size now no longer use extended geometry.
For all other controllers in this commit, this should be a no-op.
PR:
Submitted by:
Looked over by: scottl
Approved by:
Obtained from:
MFC after:
in smb_fphelp(): the parent vnode may have already been recycled
since we don't hold a reference to it. Fixes a panic when rebooting
with mdconfig -t vnode devices referring to vnodes on a smbfs mount.
how we registered pccard_intr, it is MPSAFE. However, since we
register the pccard_intr handler with the flags of the ISR we call,
that is the gating factor. We need do nothing specific here.
Prompted by: seeing pccard_intr in a panic.
are the same that those of the kernel in the KLD_MODULE case. If
we ever want to detect that kind of problems, this is not the right
place to do this since every network driver would be affected by
such desynchronisation.
toggle several media options (sonet/sdh, for example) with ifconfig and
to see the carrier state in ifconfig's output. It gives also read/write
access (given the right privilegs) to the S/Uni registers to user space
programs.
been tested extensively, but -CURRENT testing has been hampered by a
number of panics that also occur without the patch. Since the
destabilizing changes between 4.X and 5.X are external to unionfs,
I believe this patch applies equally well to both.
Thanks to scrappy for assistance testing these and other changes.
MFC after: 4 days
small but noticeable increase in performance for name lookup operations.
The code uses two zones, one for short names (less than 32 characters)
and one for long names (up to NAME_MAX). Since most file names are
fairly short, this saves a considerable amount of space that would
otherwise be wasted if we always allocated NAME_MAX bytes. The cutoff
value of 32 characters was picked arbitrarily and may benefit from some
tweaking; it could also be made into a tunable.
Submitted by: hmp
Restructure the error handling portion of the resource allocation
code to eliminate duplicated code.
Test for the O_NONBLOCK && fi_readers == 0 case before incrementing
fi_writers and modifying the the socket flag to avoid having to
undo these operations in this error case.
Restructure and simplify the code that handles blocking opens.
There should be no change to functionality.
than once. This appears to work around the hanging issues, at the
expense of warnings about bad RID allocations. I'm not sure this is a
permanant workaround, but does appear to help in the tests that I've
done here.
has not been cleaned in the meantime, since this can happen during
a forced unmount. Also add a comment that nfs_removeit() should
really be locking the directory vnode before calling nfs_removerpc().
Reported by: mbr
Tested by: mbr
MFC after: 1 week
It currently supports the PMC Sierra Lite, Ultra and 622 chips and
the IDT 77105. The driver handles media options and state in a consistent
manner for ATM drivers. The next commit to the midway driver will make
it use utopia.
doesn't have one. The test was bogus on these architectures, but
recent changes broke it altogether.
Prompted by: phk
This should fix the recent SPARC 64 build problems.
defined, then #error out. This is protected inside of #ifdef _KERNEL.
This allows one to tag code in the tree that will be deleted in 6.x
with the 'OBSOLETE_IN_6 #define at the top of the file. This makes
for easy grepping, plus a mechanism that automatically fails the
compilation of those files that are so tagged after we do the cutover.
However, GENERIC has wdc commented out, and COMPAT_OLDISA is required
for that. Comment out COMPAT_OLDISA and sdd a comment to this effect
near wdc.
Reviewed by: nyan@
o Register ISR INTR_MPSAFE.
o Loop on KTHREAD_DONE == 0 in the thread.
o Safe the INTR_MPSAFE flag for client drivers (don't know if there are any
CardBus/PCI drivers that are INTR_MPSAFE)
o Read status after acquiring mtx_lock(Giant) rather than before so that we
catch state changes that happen while Giant is being acquired.
o Turn off the CD bit when we see a CD interrupt, and turn it back on after
we've attached/detached the card.
o On suspend, actually set the CBB_SOCKET_MASK to zero rather than oring
in '0' to turn it off on suspend.
o If the ISR that's registerd is MPSAFE, don't acquire Giant around call to
client ISR.
o Fix comments to reflect these changes.
PCB contains FP registers, whose alignment must be 16 bytes at least.
Since the PCB pointed to by pc_pcb is immediately after the PCPU
itself, round-up the size of thge PCPU to a multiple of 16 bytes. The
PCPU is page aligned.
This fixes a misalignment trap caused by stopping a CPU in a SMP
kernel, such as been done when entering the debugger.
Reported by: Alan Robinson <alan.robinson@fujitsu-siemens.com>
too small panics on PAE machines which have odd > 4GB sizes (4.5 gig
would render a 20MB of KVA for kmem_map instead of 200MB).
Submitted by: John Cagle <john.cagle@hp.com>, jeff
Reviewed by: jeff, peter, scottl, lots of USENIX folks
