was needed at preliminary version of the patch, where number of CPU ticks
was divided strictly on 16 seconds. Final code instead uses real interval
duration, so precise interval should not be important. Same time aliasing
issues around second boundary causes false positives, periodically logging
useless "t_delta ... too long/short" messages when HZ set below 256.
start so we should adjust the mbuf if the driver is running in PIO mode.
Now it should work well with WPA authentication and association for LP
PHY devices.
Tested by: Warren Block <wblock at wonkity.com>
MFC after: 1 month
Specifically, teach pmap_qenter() to recognize the case when it is being
asked to replace a mapping with the very same mapping and not generate
a shootdown. Unfortunately, the buffer cache commonly passes an entire
buffer to pmap_qenter() when only a subset of the mappings are changing.
For the extension of buffers in allocbuf() this was resulting in
unnecessary shootdowns. The addition of new pages to the end of the
buffer need not and did not trigger a shootdown, but overwriting the
initial mappings with the very same mappings was seen as a change that
necessitated a shootdown. With this change, that is no longer so.
For a "buildworld" on amd64, this change eliminates 14-15% of the
pmap_invalidate_range() shootdowns, and about 4% of the overall
shootdowns.
MFC after: 3 weeks
and symbol map are required to support various consequences of the dot
symbol scheme:
- Symbols beginning with a dot are reserved, so start private symbols with
an underscore.
- In order to set RTLD breakpoints, gdb must be able to locate the text
entry point, not the data section function descriptor, so add
.r_debug_state to the symbol map on powerpc64.
Obtained from: projects/ppc64
quirks for weak-symbol handling. Text symbols require also marking weak
the special dot-symbol associated with the function, and data symbols
require that you not do that. To fix this, provide a hacked
__weak_reference for powerpc64, and define a new __weak_reference_data
for the single weak data symbol in base.
Revert after: binutils 2.17 import
Obtained from: projects/ppc64
a variety of bugs in binutils related to handling of 64-bit PPC ELF,
provides a GCC configuration for 64-bit PowerPC on FreeBSD, and
associated build systems tweaks.
Obtained from: projects/ppc64
checksum offloading is enabled. The frame has a valid checksum
value so payload might be modified during TX checksum calculation.
Disable TX checksum offloading but give users chance to enable it
when they know their controller works without problems with TX
checksum offloading.
Reported by: Andrzej Tobola <ato <> iem dot pw dot edu dot pl>
- change the type of pm_active to cpumask_t, which it is;
- in pmap_remove_pages(), compare with PCPU(curpmap), instead of
dereferencing the long chain of pointers [1].
For amd64 pmap, remove the unneeded checks for validity of curpmap
in pmap_activate(), since curpmap should be always valid after
r209789.
Submitted by: alc [1]
Reviewed by: alc
MFC after: 3 weeks
the maintenance of vm_pageout_deficit can be localized to just two places:
vm_page_alloc() and vm_pageout_scan().
This change also corrects an off-by-one error in the maintenance of
vm_pageout_deficit. Historically, the buffer cache functions, allocbuf()
and vm_hold_load_pages(), have not taken into account that vm_page_alloc()
already increments vm_pageout_deficit by one.
Reviewed by: kib
- Run the adapter's tick at 1Hz and remove link state checks from it.
Instead, have each port check its link state. Delay the check so that
it takes place slightly after the driver is notified of a change in
link state. This is a cheap way to debounce these notifications if
many are received in rapid succession. POLL_LINK_1ST_TIME flag can
also be eliminated as a side effect of these changes.
- Do not reset the PHY when link goes down.
- Clear port's link_fault flag if the PHY indicates link is down.
- get_link_status_r should leave speed and duplex alone when link is down.
MFC after: 1 month
CVS r1.94 jhb:
Cast the integer read as the first argument for %b to an unsigned integer
so it's value is not sign extended when assigned to the uintmax_t variable
used internally by printf. For example, if bit 31 is set in the cpuid
feature word, then %b would print out the initial value as a 16 character
hexadecimal value. Now it only prints out an 8 character value.
CVS r1.109 njl:
Add support for 'h' and 'hh' modifiers for printf(9).
CVS r1.117 phk:
If we ignore an unknown % sequence, we must stop interpreting the remaining
% arguments because the varargs are now out of sync and there is a risk that
we might for instance dereference an integer in a %s argument.
SVN r209836 jkim:
Implement optional 'precision' for numbers. Previously, it was parsed but
ignored. Some third-party modules (e.g., APCICA) prefer this format over
zero padding flag '0'.
