opens if the reference count is not decremented on close.
Note that this may result in the reference count being corrupted
on full duplex devices (due to mismatching opens/closes), but the
code doesn't use the reference count for anything on full duplex
devices.
2. Offer half duplex with both playback and record on channel 1 or
full duplex with playback always on channel 2 as a compile-time option.
3. 16 bit record output is byte swapped for some dumb reason. Report the _BE
AFMTs for recording.
usb, all in usb.ko. uhub depends on usb. The bug was that the preload
processing only adds a module to the list once it's internal dependencies
are resolved... Since it was not "seeing" the internal usb module it
believed that uhub had a missing dependency.
if you kldload this driver, all the subordinate devices are probed/attached
as expected. But this is not the case when the driver is statically compiled
into the kernel. Since I do most of my testing with modules, I failed to
notice this. I'm not sure if it's intended behavior or not. I think it may
be, but it seems a little counter-intuitive.
sector 0 of a disk and boot0.5 is the `boot selector' which starts
from address 0x400. The IPL loads boot0.5 and boot0.5 loads bootblock
of a slice.
The boot manager stuff was developed by me (kato) with Borland C++,
and then, translated into bcc in the ports collection by Nokubi-san.
After that, boot0 has been translated into gas with the .code16
directive by Takahashi-san (nyan) and boot0.5 has been rewritten in
gas by me.
16 bit samples have some sort of choppiness, the nature of which
is not completely clear, but it clearly has something to do with
dma buffer synchronization. But at least channel 1 makes noise now.
Previously, using -S/--skip, -f/--force, or -t/--batch to skip a patch in
a patchset still registers a failure which causes patch to return a
non-zero exit code. This is particularly undesirable with regards to
ports as there is no way to ignore the non-zero code. (Luckily, we don't
currently have any ports that make use of any of these options.)
The PR (yes, my own) is slightly incorrect: It states that -f does indeed
properly skip patches. It does, but it still sets the failure flag causing
patch to return non-zero.
PR: 19638
Submitted by: kbyanc@posi.net
appears to be the correct length, but quality of output has not yet
been tested. Also, full duplex audio (that is, playback on channel 1)
does not yet work. Two constants and I am there!
Obtained from: major hints from ALSA
with LEDs on some cards being stomped on when clearing the "jabber disable"
bit. Using DC_SETBIT() has an unwanted side effect of setting a write enable
bit in the watchdog timer register which we really want to be cleared when
we do a write.
has set pwok to a non-zero value.
Previously, the fact that skey.access(5) allowed UNIX passwords for
this connection attempt was ignored, even in the NOPAM case.
This only addresses the NOPAM case; when libpam is used, the problem
will persist.
PR: 20333
