membar_producer is supposed to be a store-store barrier.
Also, in the code that FreeBSD has ported from illumos membar_producer
is used only with regular stores to regular memory (with respect to
caching).
We do not have an MI primitive for the store-store barrier, so
atomic_thread_fence_rel is the closest we have as it provides
(load | store) -> store barrier.
Previously, membar_producer was an empty function call on all 32-bit
arm-s, 32-bit powerpc, riscv and all mips variants. I think that it was
inadequate.
On other platforms, such as amd64, arm64, i386, powerpc64, sparc64,
membar_producer was implemented using stronger primitives than required
for a store-store barrier with respect to regular memory access.
For example, it used sfence on amd64 and lock-ed nop in i386 (despite TSO).
On powerpc64 we now use recommended lwsync instead of eieio.
On sparc64 FreeBSD uses TSO mode.
On arm64/aarch64 we now use dmb sy instead of dmb ish. Not sure if this
is an improvement, actually.
After this change we can drop opensolaris_atomic.S for aarch64, amd64,
powerpc64 and sparc64 as all required atomic operations have either
direct or light-weight mapping to FreeBSD native atomic operations.
Discussed with: kib
MFC after: 4 weeks
starting at the max. domain, and then work down. Then existing FreeBSD
drivers will attach. Interrupt routing from the VMD MSI-X to the NVME
drive is not well known, so any interrupt is sent to all children that
register.
VROC used Intel meta data so graid(8) works with it. However, graid(8)
supports RAID 0,1,10 for read and write. I have some early code to
support writes with RAID 5. Note that RAID 5 can have life issues
with SSDs since it can cause write amplification from updating the parity
data.
Hot plug support needs a change to skip the following check to work:
if (pcib_request_feature(dev, PCI_FEATURE_HP) != 0) {
in sys/dev/pci/pci_pci.c.
Looked at by: imp, rpokala, bcr
Differential Revision: https://reviews.freebsd.org/D21383
* Don't partition a disk if too few are available. Just rely on Kyua to
ensure that the tests aren't run with insufficient disks.
* Remove redundant cleanup steps
* In zpool_add_003_pos, store the temporary file in $PWD so Kyua will
automatically clean it up.
* Update zpool_add_005_pos to use dumpon instead of dumpadm. This test had
never been ported to FreeBSD.
* In zpool_add_005_pos, don't format the dump disk with UFS. That was
pointless.
MFC after: 2 weeks
Sponsored by: Axcient
The cursor boundary tag is statically allocated in the vmem instead of
from the vmem_bt_zone. Explicitly remove it from the vmem's segment
list in vmem_destroy before freeing all the segments from the vmem.
Reviewed by: markj
MFC after: 1 week
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D21953
Simplify expressions as suggested by jhb. The extra indirection made
sense in earlier versions of this patch, but not the final one.
While here, apply suggestion from emaste for wording of universe.
Also wordsmith awkwardly worded comment about when we effectively
neuter the universe build for an architecture.
Once llvm 9.0 has been vetted for mips and powerpc, I'll take them out
of these lists.
This ensures the clip task won't race with t4_destroy_clip_table.
While here, make some mutex destroys unconditional since attach always
initializes them.
Reviewed by: np
MFC after: 1 week
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D21952
Cast the pointers to (uintptr_t) before assigning to type
uint64_t. This eliminates an error from gcc when we cast the pointer
to a larger integer type.
Only compile clang supporting architectures of amd64, arm, arm64,
i386, and riscv as part of universe. Compile the other architectures
if MAKE_OBSOLETE_GCC is defined. In all cases, explicit lists of
architectures in TARGETS= on the command line override.
For mips, powerpc and sparc64, do the same thing we do for risvc when
MAKE_OBSOLETE_GCC isn't defined and short-circuit their universe build
with an echo saying to install the xtoolchain port or pkg.
PR: 241134
Discussed on: arch@ (https://lists.freebsd.org/pipermail/freebsd-arch/2019-August/019674.html)
Differential Revision: https://reviews.freebsd.org/D21942
The test is necessarily racy, because it depends on being able to complete a
"zpool add" before a previous resilver finishes. But it was racier than it
needed to be. Move the first "zpool add" to before the resilver starts.
MFC after: 2 weeks
Sponsored by: Axcient
checked before access or destruction" when launching executables, while
we sort this out with upstream.
Reported by: jbeich
PR: 241137
MFC after: 1 month
X-MFC-With: r353358
The ZFS test suite was overriding the common $PWD variable with the path to
the pwd command, even though no test wanted to use it that way. Most tests
didn't notice, because ksh93 eventually restored it to its proper meaning.
MFC after: 2 weeks
Sponsored by: Axcient
* Don't create a UFS mountpoint just to store some temporary files. The
tests should always be executed with a sufficiently large TMPDIR.
Creating the UFS mountpoint is not only unneccessary, but it slowed
zpool_import_missing_002_pos greatly, because that test moves large files
between TMPDIR and the UFS mountpoint. This change also allows many of
the tests to be executed with just a single test disk, instead of two.
* Move zpool_import_missing_002_pos's backup device dir from / to $PWD to
prevent cross-device moves. On my system, these two changes improved that
test's speed by 39x. It should also prevent ENOSPC errors seen in CI.
* If insufficient disks are available, don't try to partition one of them.
Just rely on Kyua to skip the test. Users who care will configure Kyua
with sufficient disks.
MFC after: 2 weeks
Sponsored by: Axcient
Ensure the epoch_call() function is not called more than one time
before the callback has been executed, by always checking the
RS_FUNERAL_SCHD flag before invoking epoch_call().
The "rs_number_dead" is balanced again after r353353.
Discussed with: rrs@
Sponsored by: Mellanox Technologies
the epoch section towards return statement. Since entering epoch
is cheap, it is easier to cover the whole function with epoch,
rather than try to properly maintain its state.
If the bootloader enabled DMA we need to fully reset the DMA controller
otherwise we might have some stale data in it that provoke weird
behavior.
MFC after: 1 week
atomic_cas_32 is implemented using atomic_fcmpset_32 on all platforms.
Ditto for atomic_cas_64 and atomic_fcmpset_64 on platforms that have it.
The only exception is sparc64 that provides MD atomic_cas_32 and
atomic_cas_64.
This is slightly inefficient as fcmpset reports whether the operation
updated the target and that information is not needed for cas.
Nevertheless, there is less code to maintain and to add for new platforms.
Also, the operations are done inline now as opposed to function calls before.
atomic_add_64_nv is implemented using atomic_fetchadd_64 on platforms
that provide it.
casptr, cas32, atomic_or_8, atomic_or_8_nv are completely removed as they
have no users.
atomic_mtx that is used to emulate 64-bit atomics on platforms that lack
them is defined only on those platforms.
As a result, platform specific opensolaris_atomic.S files have lost most of
their code. The only exception is i386 where the compat+contrib code
provides 64-bit atomics for userland use. That code assumes availability of
cmpxchg8b instruction. FreeBSD does not have that assumption for i386
userland and does not provide 64-bit atomics. Hopefully, this can and will
be fixed.
MFC after: 3 weeks
called in syscall context, so it must enter epoch itself. This
changeset originates from early version of the patch, and somehow
slipped to the final version.
Reported by: pho
Pass the list of user selected disks from zfsboot to bootconfig so that
the latter doesn't rely on ESP autodetection that apparently fails for
some cases, e.g. memstick installation with nvme (boot) and sata drives.
While here, fix printing of debug messages in bootconfig.
Reviewed by: bcran, imp, tsoome
Differential Revision: https://reviews.freebsd.org/D21930
Compiling with clang gives a loss-of-alignment error due the cast to
uint8_t *. Since the TLS is always tcb aligned and TP_OFFSET is defined
as sizeof(struct tcb) we can guarantee there is no misalignment. Silence
the error by moving the offset into the inline assembly.
Reviewed by: br
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D21926
As unp_internalize() processes the input control messages, it builds
an output mbuf chain containing the internalized representations of
those messages. In one special case, that of an empty SCM_RIGHTS
message, the message is simply discarded. However, the loop which
appends mbufs to the output chain assumed that each iteration would
produce an mbuf, resulting in a null pointer dereference if an empty
SCM_RIGHTS message was followed by a non-empty message.
Fix this by advancing the output mbuf chain tail pointer only if an
internalized control message was produced.
Reported by: syzbot+1b5cced0f7fad26ae382@syzkaller.appspotmail.com
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
This adds a TOE hook to allocate a KTLS session. It also recognizes
TLS mbufs in the socket buffer and sends those to the NIC using a TLS
work request to encrypt the record before segmenting it.
TOE TLS support must be enabled via the dev.t6nex.<N>.tls sysctl in
addition to enabling KTLS.
Reviewed by: np, gallatin
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D21891
Clang from trunk recently added a warning for when implicit int-to-float
conversions cause a loss of precision. The code in question is designed
to be able to handle that, so add explicit casts to silence this.
Submitted by: James Clarke <jrtc27@jrtc27.com>
Reviewed by: dim
Obtained from: CheriBSD
MFC after: 1 week
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D21913
This adds the glue to allocate TLS sessions and invokes it from
the TLS enable socket option handler. This also adds some counters
for active TOE sessions.
The TOE KTLS mode is returned by getsockopt(TLSTX_TLS_MODE) when
TOE KTLS is in use on a socket, but cannot be set via setsockopt().
To simplify various checks, a TLS session now includes an explicit
'mode' member set to the value returned by TLSTX_TLS_MODE. Various
places that used to check 'sw_encrypt' against NULL to determine
software vs ifnet (NIC) TLS now check 'mode' instead.
Reviewed by: np, gallatin
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D21891
ABI already guarantees the direction is forward. Note this does not take care
of i386-specific cld's.
Reviewed by: kib
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D21906
This warning (comparing a pointer against a zero character literal
rather than NULL) has existed since GCC 7.1.0, and was recently added to
Clang trunk.
Almost all of these are harmless, except for fwcontrol's str2node, which
needs to both guard against dereferencing a NULL pointer (though in
practice it appears none of the callers will ever pass one in), as well
as ensure it doesn't parse the empty string as node 0 due to strtol's
awkward interface.
Submitted by: James Clarke <jtrc27@jrtc27.com>
Obtained from: CheriBSD
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D21914
The PCI block in the adapter requires this field to be set to a valid
queue ID. It is not clear why it did not fail on all machines, but
the effect was that crypto operations reading input data via DMA
failed with an internal PCI read error on machines with 128G or more
of RAM.
Reported by: gallatin
Reviewed by: np
MFC after: 3 days
Sponsored by: Chelsio Communications
As noted by the commit message, callouts are now persistant
and should not be in the auto-zero section of the RQ's and SQ's.
This fixes an assert when using the TX completion event
factor feature with mlx5en(4).
Found by: gallatin@
MFC after: 3 days
Sponsored by: Mellanox Technologies
