provide no methods does not make any sense, and is not used by any
driver.
It is a pretty hard to come up with even a theoretical concept of
a device driver which would always fail open and close with ENODEV.
Change the defaults to be nullopen() and nullclose() which simply
does nothing.
Remove explicit initializations to these from the drivers which
already used them.
- Removed conversion of a zero input speed to the output speed. This
has been done better in ttioctl() since rev.1.108 of kern/tty.c
almost 5 years ago. comparam() did the conversion incompletely for
the case where the output speed is also zero. It had complications
to avoid using zero speeds, but would still have used a zero input
speed for setting watermarks if kern/tty.c had passed one.
- Never permit the input speed to be different from the output speed.
There was no validity check on the input speed for the case of a zero
output speed. Then we didn't change the physical speeds, but we used
the unvalidated input speed for setting watermarks and didn't return
an error, so ttioctl() stored the unvalidated input speed in the tty
struct where it could cause problems later.
- Removed complications that were to avoid using a divisor of 0. The
divisor is now always valid if the speed is accepted.
cd_setreg() were still using !(read_eflags() & PSL_I) as the condition
for the lock hidden by COM_LOCK() (if any) being held. This worked
when spin mutexes and/or critical_enter() used hard interrupt disablement,
but it has caused recursion on the non-recursive mutex com_mtx since
all relevant interrupt disablement became soft. The recursion is
harmless unless there are other bugs, but it breaks an invariant so
it is fatal if spinlocks are witnessed.
struct msdosfsmount so that this file has the same prerequisites as
it used to. The new prerequistite was a meta-style bug. It required
many style bugs (unsorted includes ...) elsewhere.
Formatted prototypes in KNF. Resisted urge to sort all the prototypes,
to minimise differences with NetBSD. (NetBSD has reformatted the
prototypes but has not sorted them and still uses __P(()).)
instances: the memory holding a struct disk should be pre-zeroed so
as to initialize any storage framework private data in the structures
properly. In addition, the memory must be writable so that the
private data may be updated.
Pointed out by: phk
APIs permit disk device drivers to register and deregister storage devices
for use by storage device consumers. No doubt this API will change
more as time flies by, but this should be helpful to the creators of
new storage device drivers.
Reviewed by: phk
node lock while sending a management frame as this will potentially
result in a LOR with a driver lock. This doesn't happen for the
Atheros driver but does for the wi driver. Use a generation number
to help process each node once when scanning the node table and
drop the node lock if we need to timeout a node and send a frame.
AP has basic rates that we do not support then ignore them instead
of marking the rate set in error.
This fixes an 11b station associating with an 11g/b AP.
are allowed by Windows (ref: MS KB article 120138).
XXX From my reading of the CIFS specification, it's not clear that
clients need to validate filenames at all.
PR: 57123
Submitted by: Paul Coucher
MFC after: 1 month
in the loopback test in the probe. The delay was too short for consoles
at speeds lower than about 3200 bps. This shouldn't have caused many
problems, since such low speeds are rare and the probe is forced to
succeed for consoles.
