Yes, this puts things in the wrong place, doesn't compile and is
woefully incomplete. However, it will allow us to more easily track
against the upstream sources without needing to import the entire
Cavium tree under vendor.
This port is based on FreeBSD 7.0 as of April 2007 and the pre-import
MIPS tree (aka mips2), so much work is necessary here.
to prevent race over k0, k1 registers.
- Update interrupts mask in saved status register for
MipsUserIntr and MipsUserGenException. It might be
modified by intr filter or ithread.
hard and soft interrupts
- Do not handle masked interrupts
- Do not write Cause register because most bytes are read-only and
writing the same byte to RW fields are pointless. And in case of
software interrupt utterly wrong
- Get rid of arge_fix_chain, use m_defrag like if_vr
- Rework interrupt handling routine to avoid race that lead
to disabling RX interrupts
- Enable full duplex if requested
- Properly set station MAC address
- Slightly optimize RX loop
- Initialize FILTERMATCH and FILTERMASK registers as linux driver does
- Replace a1 with k1 to while restoring context. a1 was there by mistake,
interrupts are disabled at this point and it's safe to use k0, k1.
This code never was reached beacasue current Status register handling
prevented interrupta from user mode.
write fault or while wiring a mapping that must support write access.
In general, this change should reduce the number of traps that occur for
the purpose of setting the modified bit. More specifically, this change
should prevent traps while holding locks in a sysctl handler. See
kern/kern_sysctl.c revisions 1.168 and 1.195 (svn r192160) for further
details.
Tested by: gonzo
* In arge_attach(), hard reset the MAC blocks before configuring the MAC.
* In arge_reset_dma(), clear pending packet interrupts based off
the hardware counter instead of acking every packet in the ring,
as the hardware counter can exceed the ring size. If the reset
was successful the counters will be zero anyway.
* In arge_encap(), remove an unused variable.
* In arge_tx_locked(), remove redundant setting of the EMPTY flag as
the TX DMA engine sets it for us.
* In arge_intr(), remember to clear the interrupt status bits
relayed from arge_intr_filter().
* Handle RX overflow and TX underflow.
* In arge_tx_intr(), remember to unmask the TX interrupt bits
after processing them.
register increments only every second cycle. The only timing
references for us is Count value. Therefore it's better to convert
frequencies related to it and use them. Besides cleanup this commit
fixes twice more then requested sleep interval problem.
possible future I-cache coherency operation can succeed. On ARM
for example the L1 cache can be (is) virtually mapped, which
means that any I/O that uses temporary mappings will not see the
I-cache made coherent. On ia64 a similar behaviour has been
observed. By flushing the D-cache, execution of binaries backed
by md(4) and/or NFS work reliably.
For Book-E (powerpc), execution over NFS exhibits SIGILL once in
a while as well, though cpu_flush_dcache() hasn't been implemented
yet.
Doing an explicit D-cache flush as part of the non-DMA based I/O
read operation eliminates the need to do it as part of the
I-cache coherency operation itself and as such avoids pessimizing
the DMA-based I/O read operations for which D-cache are already
flushed/invalidated. It also allows future optimizations whereby
the bcopy() followed by the D-cache flush can be integrated in a
single operation, which could be implemented using on-chips DMA
engines, by-passing the D-cache altogether.
