- remove cpl->iff panic - we can't know the port number from the rspq on the 4-port
- pick the ifnet based on the interface in the CPL header
- switch to using qset 0 for egress on the 4-port for now - may change
when we start using RSS
- move ether_ifdetach to before the port lock gets deinitialized to avoid
hang in the case where there are BPF peers (cxgb_ioctl is called indirectly
when BPF peers are present)
- don't call t3_mac_reset if multiport is set, this was causing tx errors
by misconfiguring the MAC on the 4-port
- change V_TXPKT_INTF to use txpkt_intf as the interfaces are not contiguous
- free the mbuf immediately in the case where the payload is small enough to be copied
into the rspq
- only update the coalesce timer if for a queue if packets were taken off of it
- add in missed 20ms DELAY in initializaton vsc8211
- prompt MFC as this only applies to the 4-port which is currently completely
broken - OK'd by kensmith
Supported by: Chelsio
Approved by: re (blanket)
MFC after: 0 days
otherwise the /dev/mdX.uzip won't be created immediately, which is
needed because we issue a mount right afterwards.
Approved by: re@ (bmah@)
MFC after: 2 days
Updated release note: tzdata2007g [1].
[1] Technically I should remove the &merged; entity here but the commit has
a one-week MFC-after so I figure I can leave it this way for now.
Approved by: re (implicitly)
Timezone data changes in the following locations:
- Egypt
- Australia (new DST rules for 2008 and following)
- Perry County, Indiana
- America/Indiana/Tell_City
- Pike County, Indiana
Also:
- City coordinates corrected.
- Layout of leapseconds is updated
PR: conf/115706
Approved by: re (bmah@)
when peer acks the add in case the routing table changes.
- Fix sctp_lower_sosend to send shutdown chunk for mbuf send
case when sndlen = 0 and sinfoflag = SCTP_EOF
- Fix sctp_lower_sosend for SCTP_ABORT mbuf send case with null data,
So that it does not send the "null" data mbuf out and cause
it to get freed twice.
- Fix so auto-asconf sysctl actually effect the socket's asconf state.
- Do not allow SCTP_AUTO_ASCONF option to be used on subset bound sockets.
- Memset bug in sctp_output.c (arguments were reversed) submitted
found and reported by Dave Jones (davej@codemonkey.org.uk).
- PD-API point needs to be invoked >= not just > to conform to socket api
draft this fixes sctp_indata.c in the two places need to be >=.
- move M_NOTIFICATION to use M_PROTO5.
- PEER_ADDR_PARAMS did not fail properly if you specify an address
that is not in the association with a valid assoc_id. This meant
you got or set the stcb level values instead of the destination
you thought you were going to get/set. Now validate if the
stcb is non-null and the net is NULL that the sa_family is
set and the address is unspecified otherwise return an error.
- The thread based iterator could crash if associations were freed
at the exact time it was running. rework the worker thread to
use the increment/decrement to prevent this and no longer use
the markers that the timer based iterator uses.
- Fix the memleak in sctp_add_addr_to_vrf() for the case when it is
detected that ifa is already pointing to a ifn.
- Fix it so that if someone is so insane that they drop the
send window below the minimal add mark, they still can send.
- Changed all state for associations to use mask safe macro.
- During front states in association freeing in sctp_inpcbfree, we
had a locking problem where locks were not in place where they
should have been.
- Free association calls were not testing the return value in
sctp_inpcb_free() properly... others should be cast void returns
where we don't care about the return value.
- If a reference count is held on an assoc, even from the "force free"
we should not do the actual free.. but instead let the timer
free it.
- When we enter sctp_input(), if the SCTP_ASOC_ABOUT_TO_BE_FREED
flag is set, we must NOT process the packet but handle it like
ootb. This is because while freeing an assoc we release the
locks to get all the higher order locks so we can purge all
the hash tables. This leaves a hole if a packet comes in
just at that point. Now sctp_common_input_processing() will
call the ootb code in such a case.
- Change MBUF M_NOTIFICATION to use M_PROTO5 (per Sam L). This makes
it so we don't have a conflict (I think this is a covertity change).
We made this change AFTER some conversation and looking to make sure
that M_PROTO5 does not have a problem between SCTP and the 802.11
stuff (which is the only other place its used).
- Fixed lock order reversal and missing atomic protection around
locked_tcb during association lookup and the 1-2-1 model.
- Added debug to source address selection.
- V6 output must always do checksum even for loopback.
- Remove more locks around inp that are not needed for an atomically
added/subtracted ref count.
- slight optimization in the way we zero the array in sctp_sack_check()
- It was possible to respond to a ABORT() with bad checksum with
a PKT-DROP. This lead to a PKT-DROP/ABORT war. Add code to NOT
send a PKT-DROP to any ABORT().
- Add an option for local logging (useful for macintosh or when
you need better performing during debugging). Note no commands
are here to get the log info, you must just use kgdb.
- The timer code needs to be aware of if it needs to call
sctp_sack_check() to slide the maps and adjust the cum-ack.
This is because it may be out of sync cum-ack wise.
- Added threshold managment logging.
- If the user picked just the right size, that just filled the send
window minus one mtu, we would enter a forever loop not copying and
at the same time not blocking. Change from < to <= solves this.
- Sysctl added to control the fragment interleave level which defaults
to 1.
- My rwnd control was not being used to control the rwnd properly (we
did not add and subtract to it :-() this is now fixed so we handle
small messages (1 byte etc) better to bring our rwnd down more
slowly.
Approved by: re@freebsd.org (Bruce Mah)
of threaded RPC servers to work out of the box.
Spotted by: Changming Sun <changming at staff.sina.com.cn>
Sponsored by: SINA Corporation
Approved by: re (kensmith)
ICMP error message, do not access th_flags. The field is beyond
the first eight bytes of the header that are required to be present
and were pulled up in the mbuf.
A random value of th_flags can have TH_SYN set, which made the
sequence number comparison not apply the window scaling factor,
which led to legitimate ICMP(v6) packets getting blocked with
"BAD ICMP" debug log messages (if enabled with pfctl -xm), thus
breaking PMTU discovery.
Triggering the bug requires TCP window scaling to be enabled
(sysctl net.inet.tcp.rfc1323, enabled by default) on both end-
points of the TCP connection. Large scaling factors increase
the probability of triggering the bug.
PR: kern/115413: [ipv6] ipv6 pmtu not working
Tested by: Jacek Zapala
Reviewed by: mlaier
Approved by: re (kensmith)
These files have been repo-copied from src/include/fts.h
and src/lib/libc/gen/fts.c to serve as a base for 4.4BSD
compatible versions of fts(3) functions to be preserved
through libc symbol versioning while the default versions
undergo ABI-breaking extension to support big file trees.
Approved by: re (kensmith)
- Add the bind mtree to the TinyBSD build so that files
can be installed there (else the build fails)
- Change GEOM_GPT to GEOM_PART_GPT since that had been
renamed in current. The kernel configuration provided
by TinyBSD will not build without these changes.
PR: misc/115484
PR: misc/115405
Submitted by: Richard Arends <richard at unixguru dot nl>
Approved by: re (bmah)
Approved by: imp (mentor)
on an down mxge interface
- Fix a bug where mxge reported the link state as
active when it wasn't (after ifconfig down).
- Prevent spurious watchdog resets when link partner is not consuming
- Add support for CX4 and popular XFP media detection
- Update the firmware and associated header files to 1.4.25
Approved by: re (kensmith)
longer create a pv entry for that mapping. (The two exceptions are
mappings into the kernel's exec and pipe submaps.) Consequently, there is
no reason for get_pv_entry() to dig deep into the free page queues, i.e.,
use VM_ALLOC_SYSTEM, by default. This revision changes get_pv_entry() to
use VM_ALLOC_NORMAL by default, i.e., before calling pmap_collect() to
reclaim pv entries.
Approved by: re (kensmith)
ENOENT if the option wasn't provided, instead of setting it to 0.
xfs however didn't catch up on this, so it assumed something went bad if
vfs_getopts() sets the error to non-zero, and just returns the error.
Unbreak xfs mount by just ignoring the error if vfs_getopts() sets the
error to ENOENT, as we should have sane defaults.
Reviewed by: kan
Approved by: re (rwatson)
Tested by: rpaulo
For this, introduce vm_map_fixed() that does that for MAP_FIXED case.
Dropping the lock allowed for parallel thread to occupy the freed space.
Reported by: Tijl Coosemans <tijl ulyssis org>
Reviewed by: alc
Approved by: re (kensmith)
MFC after: 2 weeks
aio_proc_rundown.
Do not allow for zero-length read to be passed to the fo_read file method
by aio.
Reported and tested by: Peter Holm
Approved by: re (kensmith)
of the bits we want to ignore on the first pass rather than doing a
linear scan. This puts us within a few instructions of the cost of
runq_findbit() and removes this function from the top of profiling output
for context switch heavy workloads.
Approved by: re
on 2cpu machines by reducing it to 1 by default. This improves loaded
operation on 8cpu machines by increasing it to 3 where the extra idle
time is not as critical.
Approved by: re
have caused a hang, but we got lucky with the available multi-CPU states
on actual hardware.
Submitted by: Bjorn Koenig <bkoenig / alpha-tierchen.de>
Approved by: re
MFC after: 3 days
GNU tar 1.17's implementation of --posix --sparse,
at the cost of losing compatibility with GNU tar 1.16.
Fortunately, the 1.17 implementation actually makes sense,
so the libarchive code is now a bit more straightforward
than before.
Background: GNU tar 1.16 defined a new way to store
sparse files in --posix archives. Unfortunately,
the implementation incorrectly inserted several
blocks of null padding after each such entry.
As a result, non-GNU tar implementations saw the
archive as truncated after any sparse entry.
This was fixed in GNU tar 1.17 at the cost of
losing compatibility with GNU tar 1.16 for this
new format (which is not the default, so hopefully
rarely used). Libarchive recently gained support
for reading the GNU tar 1.16 formats; this commit
updates it to read the GNU tar 1.17 variant instead.
Approved by: re (ksmith for libarchive portion)
Approved by: re (blanket for libarchive_test portion)
MFC after: 5 days
pointer to the installation chapter of the Handbook (it might be a
good idea to sprinkle a few more through this article).
De-emphasize the floppy disk part of installation media; it's
generally believed that most users install from CDROM or DVD
nowadays.
Use &arch.* entities where appropriate.
Bump copyright date while here.
Approved by: re (implicitly)
