... as opposed to files with data in extents.
Some UDF authoring tools produce this type of file for sufficiently small
data files.
Approved by: jhb (mentor)
Use bit-shift instead of division/multiplication.
Act on error as soon as it is detected.
Report attempt to read data embedded in file entry via regular way.
While there, fix lblktosize macro and make use of it.
No functionality should change as a result.
Approved by: jhb (mentor)
`p' is already initialized with `td->td_proc'. Because td is always
curthread, it is safe to initialize it without any locks.
Found by: LLVM's scan-build
priv:kernel:priv_check:priv_ok fires for granted privileges
priv:kernel:priv_check:priv_errr fires for denied privileges
The first argument is the requested privilege number. The naming
convention is a little different from the OpenSolaris equivilent
because we can't have '-' in probefunc names, and our privilege
namespace is different.
MFC after: 1 week
fault. In r188331 this update was relocated because of synchronization
changes to a place where it would occur on both hard and soft faults. This
change again restricts the update to hard faults.
required to make 3CR990 familiy controllers run on NV flash
firmware version 03.001.008.
The latest firmware added HMAC digest information so teach txp(4)
to pass them to sleep image before downloading is started.
While I'm here restore previous IMR/IER register if firmware
downloading have failed.
PR: kern/89876, kern/132047
The old BTX passed the general purpose registers from the 32-bit client to
the routines called via virtual 86 mode. The new BTX did the same thing.
However, it turns out that some instructions behave differently in virtual 86
mode and real mode (even though this is under-documented). For example, the
LEAVE instruction will cause an exception in real mode if any of the upper
16-bits of %ebp are non-zero after it executes. In virtual 8086 mode the
upper 16-bits are simply ignored. This could cause faults in hardware
interrupt handlers that inherited an %ebp larger than 0xffff from the 32-bit
client (loader, boot2, etc.) while running in real mode.
To fix, when executing hardware interrupt handlers provide an explicit clean
state where all the general purpose and segment registers are zero upon
entry to the interrupt handler. While here, I attempted to simplify the
control flow in the 'intusr' code that sets up the various stack frames
and exits protected mode to invoke the requested routine via real mode.
A huge thanks to Tor Egge (tegge@) for debugging this issue.
Submitted by: tegge
Reviewed by: tegge
Tested by: bz
MFC after: 1 week
function, done in r188334. Instead, collect the entries that shall be
freed, in the deferred_freelist member of the map. Automatically purge
the deferred freelist when map is unlocked.
Tested by: pho
Reviewed by: alc
an NFS file. Now the priming is conditional on a new
vfs.nfs.prime_access_cache sysctl. For now I've left the default setting
to disabling the priming.
Requested by: scottl
checks for the tcpcb, previously used to detect complete disconnection,
with INP_DROPPED checks. Correct that, preventing shutdown() from
improperly generating a TCP segment with destination IP and port of
0.0.0.0:0.
PR: kern/132050
Reported by: david gueluy <david.gueluy at netasq.com>
MFC after: 3 weeks
- We don't need to exit the Giant mutex when sleeping. This is done
automatically. Replace Giant by NULL mutex for all control requests in the
enumeration path.
- Optimise away duplicate alternate interface selection requests in USB Host
mode.
Submitted by: Hans Petter Selasky
