clean MI/MD driver, but it *does* actually work at this time. Updated
to use new make_dev stuff. A CONS_DRIVER declaration is also put in
so that this can be the real console for the 8200s.
not the current BPF device should report locally generated packets or not.
This allows sniffing applications to see only packets that are not generated
locally, which can be useful for debugging bridging problems, or other
situations where MAC addresses are not sufficient to identify locally
sourced packets. Default to true for this flag, so as to provide existing
behavior by default.
Introduce two new ioctls, BIOCGSEESENT and BIOCSSEESENT, which may be used
to manipulate this flag from userland, given appropriate privilege.
Modify bpf.4 to document these two new ioctl arguments.
Reviewed by: asmodai
this version include:
- Support for version 2.x firmware (2.42 or later recommended). This
means we are the only open-source driver supporting these adapters.
This code has only been tested on a Digital KZPCA adapter in an Alpha
system, but is believed to be correct. NOTE: EISA adapters are not
yet supported.
- Support the BIOS/Firmware initialisation handshake protocol. This
allows the driver to bring the card up to operational state even if
the BIOS can't be run (eg. if it's an x86 BIOS in an Alpha system).
- A working command pasthrough interface. This allows a user-space
configuration tool (under development) to issue arbitrary commands
to the controller or to devices in the system.
return ENXIO (Device not configured). Without this, vn_isdisk()
could (and did in the case of lstat() under fdesc) pass a NULL pointer
to devsw(), which caused a page fault.
Reviewed by: alfred
This avoids the unit number from going up indefinitely when
diconnecting and connecting 2 devices alternately.
Noticed by: nsayer (quite a while ago)
And stop calling DEVICE_NOMATCH at probe repeatedly. This stops the
message on the PCI VGA board from being printed when loading a PCI driver.
platform we're running on so we know how many bits to reserve at the top
end for the 'hose' value. It turns out that there's *just* enough room
to support all possible hoses on TurboLaser.
Reviewed by: gallatin@freebsd.org, dfr@free3bsd.org
This makes it possible to handle the done queue even when the end of tail
TD has ended up on the done queue as well (the xfer in this case is NULL
but the next field is valid, so we simply skip that element.
Make sure we mark all the handled transfers as handled.
Stop using powerhooks. They are a NetBSD-ism.
the unwary if the code were called in slightly different ways.
1) In ufs_bmaparray() the code for calculating 'runb' will stop one block
short of the first entry in an indirect block. i.e. if an indirect block
contains N block numbers b[0]..b[N-1] then the code will never check if
b[0] and b[1] are sequential. For reference, compare with the equivalent
code that deals with direct blocks.
2) In ufs_lookup() there is an off-by-one error in the test that checks
if dp->i_diroff is outside the range of the the current directory size.
This is completely harmless, since the following while-loop condition
'dp->i_offset < endsearch' is never met, so the code immediately
does a second pass starting at dp->i_offset = 0.
3) Again in ufs_lookup(), the condition in a sanity check is wrong
for directories that are longer than one block. This bug means that
the sanity check is only effective for small directories.
Submitted by: Ian Dowse <iedowse@maths.tcd.ie>
