it gets unused.
Currently if_purgeifaddrs() uses in6_purgeaddr() to remove IPv6
ifaddrs. in6_purgeaddr() does not trrigger prefix removal if
number of linked ifas goes to 0, as this is a low-level function.
As a result, if_purgeifaddrs() purges all IPv4/IPv6 addresses but
keeps corresponding IPv6 prefixes.
Fix this by creating higher-level wrapper which handles unused
prefix usecase and use it in if_purgeifaddrs().
Differential revision: https://reviews.freebsd.org/D28128
-PRERELEASE exists as a given stable/X branch while the next minor version
release is in progress. From a functional standpoint, it should be treated
as -STABLE since it'll typically be a superset of what's included in the
concurrent releng branch.
Reviewed by: gjb
Differential Revision: https://reviews.freebsd.org/D28166
These only get staged off to the side, not installed into the system. Let's
change the default for packages/update-packages to be less surprising.
MFC after: 1 week
Reviewed by: manu, meena <me igalic co>
Differential Revision: https://reviews.freebsd.org/D28190
In the presence of high-level errors (spec violations, bad boot blocks
checksum), report non-detection instead of detection.
PR: 252787 (related, but does not fully address)
This stops busdma bounce making assumptions about alignment of malloc(9)
results, which are no longer true.
Also add assert that the result of malloc_aligned() fits into single
page, which is the assumption of the code.
Reported by: dim
Reviewed by: andrew, jah, markj
Tested by: pho
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D28147
Change the power-of-two malloc zones to require alignment equal to the
size [*]. Current uma allocator already provides such alignment, so in
fact this change does not change anything except providing future-proof
setup.
Suggested by: markj [*]
Reviewed by: andrew, jah, markj
Tested by: pho
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D28147
We try to ensure building WITHOUT_CLEAN (or -DNO_CLEAN) works on an
ongoing basis. b7ab6832cd changed cat to build w/o -DWITH_CASPER
by default; add a cat.o dependency on the Makefile so that it gets
rebuilt.
Even if it didn't behave well previously this is fixed.
Tested on: OrangePi One (armv7 u-boot) (serial only and serial + HDMI)
Tested on: Pine64-LTS (aarch64 u-boot) (serial only and serial + HDMI)
Tested on: Honeycomb (aarch64 EDK2) (serial only)
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D28153
Summary:
Linux's irq_work queue was created for asynchronous execution of code from contexts where spin_lock's are not available like "hardware interrupt context". FreeBSD's fast taskqueues was created for the same purposes.
Drm-kmod 5.4 uses irq_work_queue() at least in one place to schedule execution of task/work from the critical section that triggers following INVARIANTS-induced panic:
```
panic: acquiring blockable sleep lock with spinlock or critical section held (sleep mutex) linuxkpi_short_wq @ /usr/src/sys/kern/subr_taskqueue.c:281
cpuid = 6
time = 1605048416
KDB: stack backtrace:
db_trace_self_wrapper() at db_trace_self_wrapper+0x2b/frame 0xfffffe006b538c90
vpanic() at vpanic+0x182/frame 0xfffffe006b538ce0
panic() at panic+0x43/frame 0xfffffe006b538d40
witness_checkorder() at witness_checkorder+0xf3e/frame 0xfffffe006b538f00
__mtx_lock_flags() at __mtx_lock_flags+0x94/frame 0xfffffe006b538f50
taskqueue_enqueue() at taskqueue_enqueue+0x42/frame 0xfffffe006b538f70
linux_queue_work_on() at linux_queue_work_on+0xe9/frame 0xfffffe006b538fb0
irq_work_queue() at irq_work_queue+0x21/frame 0xfffffe006b538fd0
semaphore_notify() at semaphore_notify+0xb2/frame 0xfffffe006b539020
__i915_sw_fence_notify() at __i915_sw_fence_notify+0x2e/frame 0xfffffe006b539050
__i915_sw_fence_complete() at __i915_sw_fence_complete+0x63/frame 0xfffffe006b539080
i915_sw_fence_complete() at i915_sw_fence_complete+0x8e/frame 0xfffffe006b5390c0
dma_i915_sw_fence_wake() at dma_i915_sw_fence_wake+0x4f/frame 0xfffffe006b539100
dma_fence_signal_locked() at dma_fence_signal_locked+0x105/frame 0xfffffe006b539180
dma_fence_signal() at dma_fence_signal+0x72/frame 0xfffffe006b5391c0
dma_fence_is_signaled() at dma_fence_is_signaled+0x80/frame 0xfffffe006b539200
dma_resv_add_shared_fence() at dma_resv_add_shared_fence+0xb3/frame 0xfffffe006b539270
i915_vma_move_to_active() at i915_vma_move_to_active+0x18a/frame 0xfffffe006b5392b0
eb_move_to_gpu() at eb_move_to_gpu+0x3ad/frame 0xfffffe006b539320
eb_submit() at eb_submit+0x15/frame 0xfffffe006b539350
i915_gem_do_execbuffer() at i915_gem_do_execbuffer+0x7d4/frame 0xfffffe006b539570
i915_gem_execbuffer2_ioctl() at i915_gem_execbuffer2_ioctl+0x1c1/frame 0xfffffe006b539600
drm_ioctl_kernel() at drm_ioctl_kernel+0xd9/frame 0xfffffe006b539670
drm_ioctl() at drm_ioctl+0x5cd/frame 0xfffffe006b539820
linux_file_ioctl() at linux_file_ioctl+0x323/frame 0xfffffe006b539880
kern_ioctl() at kern_ioctl+0x1f4/frame 0xfffffe006b5398f0
sys_ioctl() at sys_ioctl+0x12a/frame 0xfffffe006b5399c0
amd64_syscall() at amd64_syscall+0x121/frame 0xfffffe006b539af0
fast_syscall_common() at fast_syscall_common+0xf8/frame 0xfffffe006b539af0
--- syscall (54, FreeBSD ELF64, sys_ioctl), rip = 0x800a6f09a, rsp = 0x7fffffffe588, rbp = 0x7fffffffe640 ---
KDB: enter: panic
```
Here, the dma_resv_add_shared_fence() performs a critical_enter() and following call of schedule_work() from semaphore_notify() triggers 'acquiring blockable sleep lock with spinlock or critical section held' panic.
Switching irq_work implementation to fast taskqueue fixes the panic for me.
Other report with the similar bug: https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=247166
Reviewed By: hselasky
Differential Revision: https://reviews.freebsd.org/D27171
Some systems may provide multiple GOP instances and not all are
bound to hardware. The current loader is picking up the first GOP,
which may not be usable. Instead we load the GOP handle array,
and test every handle to have registered ConOut protocol. If ConOut is
present, we can use this GOP handle to open GOP protocol.
Back when I wrote openfirm.4, sparc64 was the only architecture to
include the corresponding device. However, nowadays all supported
architectures will provied this Open Firmware interface, even x86
when built with FDT support.
As for ofw_console(4), powerpc actually was the first architecture
to ship it but we'll probably not see another consumer in future.
This partially reverts 702547720c and
r357794 respectively, adjusting paths and content as appropriate.
rtinit[1]() is a function used to add or remove interface address prefix routes,
similar to ifa_maintain_loopback_route().
It was intended to be family-agnostic. There is a problem with this approach
in reality.
1) IPv6 code does not use it for the ifa routes. There is a separate layer,
nd6_prelist_(), providing interface for maintaining interface routes. Its part,
responsible for the actual route table interaction, mimics rtenty() code.
2) rtinit tries to combine multiple actions in the same function: constructing
proper route attributes and handling iterations over multiple fibs, for the
non-zero net.add_addr_allfibs use case. It notably increases the code complexity.
3) dstaddr handling. flags parameter re-uses RTF_ flags. As there is no special flag
for p2p connections, host routes and p2p routes are handled in the same way.
Additionally, mapping IFA flags to RTF flags makes the interface pretty messy.
It make rtinit() to clash with ifa_mainain_loopback_route() for IPV4 interface
aliases.
4) rtinit() is the last customer passing non-masked prefixes to rib_action(),
complicating rib_action() implementation.
5) rtinit() coupled ifa announce/withdrawal notifications, producing "false positive"
ifa messages in certain corner cases.
To address all these points, the following has been done:
* rtinit() has been split into multiple functions:
- Route attribute construction were moved to the per-address-family functions,
dealing with (2), (3) and (4).
- funnction providing net.add_addr_allfibs handling and route rtsock notificaions
is the new routing table inteface.
- rtsock ifa notificaion has been moved out as well. resulting set of funcion are only
responsible for the actual route notifications.
Side effects:
* /32 alias does not result in interface routes (/32 route and "host" route)
* RTF_PINNED is now set for IPv6 prefixes corresponding to the interface addresses
Differential revision: https://reviews.freebsd.org/D28186
.Dl indents literal display text for one line, but .Bd can do it for a
whole subsection.
Pointy hat to: debdrup
Reported by: 0mp
Reviewed by: 0mp
Differential Revision: https://reviews.freebsd.org/D28198
service(8) has an example for bash completion, however bash is third
party and in /usr/share/examples/csh/dot.cshrc is a working example for
csh.
Since I use (t)csh, I've tested it, and it works for me.
PR: 179497
Submitted by: ohauer@
Reviewed by: kp (tentatively)
Differential Revision: https://reviews.freebsd.org/D28197
On little-endian PowerPC64, this prevented /usr/lib/clang/11.0.0 being
cleaned up completely after upgrading to clang 11.0.1.
Noticed by: pkubaj
MFC after: 4 weeks
X-MFC-With: r364284
There is no guarantee that after close(2)/free the errno will remain
persistent. The caller of the udom_open function depends on the errno
for reporting errors.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D28185
AMD 10GbE hardware is designed to have two buffers per receive descriptor to
support split header feature. For this purpose, the driver was designed to use
2 iflib freelists per receive queue. So, that buffers from 2 freelists are used
to refill an entry in the receive descriptor. The current design holds good
with regular data traffic.
But, when netmap comes into play, the current design will not fit in. The
current netmap interfaces and netmap implementation in iflib doesn't seem
to accomodate the design of 2 freelists per receive queue. So, exercising
Netmap capability with inbuilt tools like bridge, pkt-gen doesn't work with
the 2 freelists driver design.
So, the driver design is changed to accomodate the current netmap interfaces
and netmap implementation in iflib by using single freelist per receive queue
approach when Netmap capability is exercised without disturbing the current
2 freelists approach.
The dev.ax.sph_enable tunable can be set to 0 to configure the single
free list mode.
Thanks to Stephan Dewt for his Initial set of code changes for the stated
problem.
Submitted by: rajesh1.kumar_amd.com
Approved by: vmaffione
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D27797
This rode in with the OpenZFS import. It may have been necessary at some
point, but it is no longer and it breaks the WITHOUT_DYNAMICROOT build as
it collides with the definition in libspl.
Reported-by: Michael Dexter
-R is currently shorthand for cachefile=none, altroot=<mount>. This is
functionally the same, but perhaps more resilient to future changes that
could be necessary that may be added when -R is specified.
MFC after: 1 week
disk failure.
Each vnode has an embedded lock that controls access to its contents.
However vnodes describing a UFS snapshot all share a single snapshot
lock to coordinate their access and update. As part of mounting a
UFS filesystem with snapshots, each of the vnodes describing a
snapshot has its individual lock replaced with the snapshot lock.
When the filesystem is unmounted the vnode's original lock is
returned replacing the snapshot lock.
When a disk fails while the UFS filesystem it contains is still
mounted (for example when a thumb drive is removed) UFS forcibly
unmounts the filesystem. The loss of the drive causes the GEOM
subsystem to orphan the provider, but the consumer remains until
the filesystem has finished with the unmount. Information describing
the snapshot locks was being prematurely cleared during the orphaning
causing the return of the snapshot vnode's original locks to fail.
The fix is to not clear the needed information prematurely.
Sponsored by: Netflix
