With this bug fix we don't need to invalidate all the entries.
o Remove a call to pmap_invalidate_all(). This was never called
as the anyvalid variable is never set.
Obtained from: arm64/pmap.c (r322797, r322800)
Sponsored by: DARPA, AFRL
Rework the block device handle check to allow more robust device
classification. This is mostly usability issue - it can be quite confusing
for user when no disks are listed with lsdev.
Add more comments about what and why is done.
Reviewed by: imp
Differential Revision: https://reviews.freebsd.org/D13026
Patches with very little context (-U0 and -U1) could get misapplied if
the file to be patched changes and a hunk is no longer applicable. Matching
with fuzz would be attempted and default to a match when we unexpectedly ran
out of context.
This also affected patches with higher levels of context but had limited
actual context due to the hunk being located near the beginning/end of file.
PR: 74127, 223545 (exp-run)
Reviewed by: emaste, pfg
Approved by: emaste (mentor)
Differential Revision: https://reviews.freebsd.org/D12631
BHND Wi-Fi chipsets and SoCs share a common DMA engine, operating within
backplane address space. To support host DMA on Wi-Fi chipsets, the bridge
core maps host address space onto the backplane; any host addresses must
be translated to their corresponding backplane address.
- Defines a new bhnd_get_dma_translation(9) API to support querying DMA
address translation parameters from the bhnd(4) bus.
- Extends bhndb(4) to provide DMA translation descriptors from a DMA
address translation table defined in the host bridge-specific
bhndb_hwcfg.
- Defines bhndb(4) DMA address translation tables for all supported host
bridge cores.
- Extends mips/broadcom's bhnd_nexus driver to return an identity (no-op)
DMA translation descriptor; no translation is required when addressing
the SoC backplane.
Approved by: adrian (mentor)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12582
On BHND MIPS SoCs, this replaces the use of hard-coded MIPS IRQ#s in the
common bhnd(4) core drivers; we now register an INTRNG child PIC that
handles routing of backplane interrupt vectors via the MIPS core.
On BHND PCI devices, backplane interrupt vectors are now routed to the
PCI/PCIe host bridge core when bus_setup_intr() is called, where they are
dispatched by the PCI core via a host interrupt (e.g. INTx/MSI).
The bhndb(4) bridge driver tracks registered interrupt handlers for the
bridged bhnd(4) devices and manages backplane interrupt routing, while
delegating actual bus interrupt setup/teardown to the parent bus on behalf
of the bridged cores.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12518
In addition to some small style fixes to the ARMv6 vDSO, this release
includes a new vDSO that can be used for the execution of ARMv6/ARMv7
code on 64-bit platforms.
Just like for i686 on x86-64, this new vDSO is responsible for padding
arguments and return values to 64-bit values, so that the kernel can
easily forward system calls to the native system calls.
Obtained from: https://github.com/NuxiNL/cloudabi
The periodic 200.backup-passwd script outputs any differences it finds
in master.passwd, relative to the previous backup. It intends to elide
the encrypted password field, but previously did so only for changed
lines (i.e., those beginning with - or + in the diff).
Apply the sed expression also to unchanged lines to also elide their
passwords.
PR: 223461
Reported by: Andre Albsmeier
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Following struct vmtotal changes, make systat use and correctly
display 64-bit counters. Switch to humanize_number(3) to overcome
homegrown arithmetics limits in pretty printing large numbers. Use
1024 as a divisor for memory fields to make it consistent with other
tools and users expectations.
Submitted by: Pawel Biernacki <pawel.biernacki@gmail.com>
Sponsored by: Mysterious Code Ltd.
PR: 2137
Differential revision: https://reviews.freebsd.org/D13105
riscv doesn't have -msoft-float. For the moment, just don't add
anything. There's no /boot/loader or other bootstrap contained in the
tree for riscv*. However, with real hardware coming next year, there
are plans for one, so keep building at least a minimal libsa and
ficl to prevent bitrot.
Sponsored by: Netflix
The supported targets are riscv64 and riscv64sf. Use the former when
building with a bare TARGET=riscv and it is the more common one.
Sponsored by: Netflix
The problem happens when the writes have offsets and sizes aligned with
a filesystem's recordsize (maximum block size). In this scenario
dmu_tx_assign() would fail because of being over the quota, but the uio
would already be modified in the code path where we copy data from the
uio into a borrowed ARC buffer. That makes an appearance of a partial
write, so zfs_write() would return success and the uio would be modified
consistently with writing a single block.
That bug can result in a data loss because the writes over the quota
would appear to succeed while the actual data is being discarded.
This commit fixes the bug by ensuring that the uio is not changed until
after all error checks are done. To achieve that the code now uses
uiocopy() + uioskip() as in the original illumos design. We can do that
now that uiocopy() has been updated in r326067 to use
vn_io_fault_uiomove().
Reported by: mav
Analyzed by: mav
Reviewed by: mav
Pointyhat to: avg (myself)
MFC after: 1 week
X-MFC after: r326067
X-Erratum: wanted
HAVE_GPT isn't currently a thing, but HAVE_GELI is. Replace the former
with the latter and remove util.o from the build list (it's picked up
from libsa/libsa32, and that's OK).
Sponsored by: Netflix
copied from the build host. It is renamed to /etc/resolv.conf.bak
on boot, so never used anyway.
Noticed by: peter
MFC after: 3 days
Sponsored by: The FreeBSD Foundation
uiocopy() is currently unused, its purpose is copy data from a uio
without modifying the uio. It was in use before the vn_io_fault support
was added to ZFS, at which point our code diverged from the illumos code
a little bit. Because ZFS is the only (potential) user of the function
we are free to modify it to better suit ZFS needs.
The intention behind this change is to remove the differences introduced
earlier in zfs_write().
While here, re-implement uioskip() using uiomove() with
uio_segflg == UIO_NOCOPY.
The story of uioskip is the same as with uiocopy.
Reviewed by: mav
MFC after: 1 week
the system time.
As we seem to only read this time on boot, and this is the only source of
time on many arm64 machines we need to enable this by default there. As
this is not always the case with U-Boot firmware, or when we have been
booted from a non-UEFI environment we only enable the device driver when
the Runtime Services are present and reading the time doesn't result in an
error.
PR: 212185
Reviewed by: imp, kib
Tested by: emaste
Relnotes: yes
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D12650
Add some rules to more closely match what illumos does when an address
resolves to multiple symbols:
- prefer non-local symbols
- prefer symbols with fewer leading underscores and no leading '$'
Add some regression tests to verify these rules.
`vidcontrol -h 0` is acceptable, so be explicit that it's less than zero
that is not allowed.
Reported by: Siva Mahadevan
Sponsored by: The FreeBSD Foundation
case another thread has had the VFP unit enabled and will have its state
in the VFP registers along with it stored in memory. As such we don't need
to store the state, but do need to zero the fpcurthread pointer to stop
the VFP driver from using the enable fast path.
Reported by: emaste
Sponsored by: DARPA, AFRL
Some drm2 drivers will set PG_FICTITIOUS in physical pages in order to
satisfy the OBJT_MGTDEVICE object interface, so a scan may encounter
fictitous pages. For now, allow for this possibility; such pages will be
skipped later in the scan since they are wired.
Reported by: avg
Reviewed by: kib
MFC after: 1 week
parsing a textual UEFI Device Path, since otherwise it things the
passed in path is a filename. While here, reduce the repetition of
8192.
Sponsored by: Netflix
produces hex numbers for the dsn. Since that come is from EDK2, change
this for symmetry, by generating the dsn as a hex number.
Noticed by: gpart list | grep efimedia | awk -F: '{print $2;}' | \
sed -e 's/^ *//g;s/,,/,/' | grep MBR | efidp -p | efidp -f
Sponsored by: Netflix
The vast majority of pmap_kextract() calls are looking for a physical memory
address, not a device address. By checking the page table first this saves
the formerly inevitable 64 (on e500mc and derivatives) iteration loop
through TLB1 in the most common cases.
Benchmarking this on the P5020 (e5500 core) yields a 300% throughput
improvement on dtsec(4) (115Mbit/s -> 460Mbit/s) measured with iperf.
Benchmarked on the P1022 (e500v2 core, 16 TLB1 entries) yields a 50%
throughput improvement on tsec(4) (~93Mbit/s -> 165Mbit/s) measured with
iperf.
MFC after: 1 week
Relnotes: Maybe (significant performance improvement)
This replaces a partial workaround introduced in r305527 that was
incompatible with nested INTRNG interrupt controllers if not also using
FDT.
On non-FDT MIPS INTRNG targets, we now preemptively produce a set of fixed
mappings for the MIPS IRQ range during nexus attach. On FDT targets,
OFW_BUS_MAP_INTR() remains responsible for mapping the MIPS IRQs.
Approved by: adrian (mentor)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12385
When called with an absolute pathname, periodic should attempt to execute
every script in that directory. If the directory does not exist, it should
print an error and exit 1. Due to a copy/paste mistake in r231568, it exits
0 in that case.
Reported by: devel/hs-ShellCheck
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13070
Like its predecessor ST8000AS0002, this is a drive-managed SMR drive, but
doesn't declare that in its ATA identify data.
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
simd / no float stuff is centeralized here. Also centralise
-ffreestanding since it is specified everywhere.
This, along with a change to share/mk/bsd.cpu.mk to include -mno-avx2
in CFLAGS_NO_SIMD should fix building for newer machines (eg with
CPUTYPE=haswell) where clang was generating avx2 instructions.
Sponsored by: Netflix
sys/cam/scsi/scsi_da.c
Complete BIO_FLUSH commands immediately if the da(4) device hasn't
been written to since the last flush. If we haven't written to the
device, there is no reason to send a flush.
Submitted by: gibbs
Reviewed by: imp
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13106
* Wrongly matches strings that are shorter than the pattern
* Fails to match negative character sets
* Fails to match character sets that aren't at the end of the pattern
* Fails to match character ranges
Reviewed by: imp
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13173
bit_nclear() takes the bit numbers for the start and end bits, not the start
and a count. This was resulting in memory corruption past the end of the
bitstr_t.
Sponsored by: Limelight Networks
ZAC (Zoned-device ATA Command set) is the standard for addressing SMR
(shingled magnetic recording) devices over SATA. Drives indicate their
support for ZAC in their IDENTIFY block. Print whether and how a drive
supports ZAC in the output of "camcontrol identify".
Reviewed by: ken, imp
MFC after: 3 weeks
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D13171
