Before the fix for single interrupt, both percpu and non-percpu routes
were enabled/disable at the same time.
Submitted by: Marcin Wojtas <mw@semihalf.com
Obtained from: Semihalf
Sponsored by: Stormshield, Netgate
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10716
e6000sw family automatically reflects PHY status in each port's registers.
Therefore it is not necessary to do a full PHY polling squence, which
results in much quicker operation and much less significant usage of
the SMI bus.
Care must be taken that the resulting ifmedia_active is identical to
what the PHY will compute, or gratuitous link status changes will
occur whenever the PHYs update function is called.
This patch implements above improvement. On the occasion set a pointer to
the proc structure to be part of software context instead of being
a global variable.
Submitted by: Marcin Wojtas <mw@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10714
Make sure the RX ring lock is only released when the state of the ring is
consistent, or else concurrent calls to xn_rxeof might get an inconsistent ring
state and thus some packets might be processed twice.
Note that this is not very common, and could only happen when an interrupt is
delivered while in xn_ifinit.
Reported by: cperciva
Tested by: cperciva
MFC after: 1 week
Sponsored by: Citrix Systems R&D
For all Marvell devices, MBUS windows configuration is done
in a common place. Only CESA was an exception, so move its
related code from driver to mv_common.c. This way it uses
same proper DRAM information, same as all other interfaces
instead of parsing DT /memory node directly.
Submitted by: Marcin Wojtas <mw@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10723
Hitherto implementation of PHY polling resulted in a risk of an
endless loop and very high occupation of the SMI bus. Improve the
operation by limiting the polling tries and adding sleepable
pause.
Submitted by: Marcin Wojtas <mw@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10713
Call disk_gone when the backend switches to the "Closing" state and blkfront
still has pending users. This allows the disk to be detached, and will call
into xbd_closing by itself when the geom layout cleanup has finished.
Reported by: bapt
Tested by: manu
Reviewed by: bapt
Sponsored by: Citrix Systems R&D
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D10772
defined. On machines without arithmetic shift instructions, zero bits
may be shifted in from the left, giving a large positive result instead
of the desired divide-by power-of-2. Fix this by operating on the
absolute value and compensating for the possible negation later.
Reverse the order of the underflow/overflow tests and the exponential
decay calculation to avoid the possibility of an erroneous overflow
detection if p is a sufficiently small non-negative value. Also
check for negative values of prob before doing the exponential decay
to avoid another instance of of right shifting a negative value.
Tested by: Rasool Al-Saadi <ralsaadi@swin.edu.au>
MFC after: 1 week
kern_yield(0) effectively causes the calling thread to be rescheduled
immediately since it resets the thread's priority to the highest possible
value. This can cause livelocks when the pattern
"while (!trylock()) kern_yield(0);" is used since the thread holding the
lock may linger on the runqueue for the CPU on which the looping thread is
running.
MFC after: 1 week
This will help Jenkins dedupe 9 warnings between the static build and
the module build of ipsec(4).
Missed in SRCTOP conversion in r314651.
MFC with: r314651
Sponsored by: Dell EMC Isilon
The ccr(4) driver supports use of the crypto accelerator engine on
Chelsio T6 NICs in "lookaside" mode via the opencrypto framework.
Currently, the driver supports AES-CBC, AES-CTR, AES-GCM, and AES-XTS
cipher algorithms as well as the SHA1-HMAC, SHA2-256-HMAC, SHA2-384-HMAC,
and SHA2-512-HMAC authentication algorithms. The driver also supports
chaining one of AES-CBC, AES-CTR, or AES-XTS with an authentication
algorithm for encrypt-then-authenticate operations.
Note that this driver is still under active development and testing and
may not yet be ready for production use. It does pass the tests in
tests/sys/opencrypto with the exception that the AES-GCM implementation
in the driver does not yet support requests with a zero byte payload.
To use this driver currently, the "uwire" configuration must be used
along with explicitly enabling support for lookaside crypto capabilities
in the cxgbe(4) driver. These can be done by setting the following
tunables before loading the cxgbe(4) driver:
hw.cxgbe.config_file=uwire
hw.cxgbe.cryptocaps_allowed=-1
MFC after: 1 month
Relnotes: yes
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D10763
Please note that only a subset of CPU0 registers are exported. CPU1
registers are not touched.
Obtained from: ARMADA38X Functional Specifications
Sponsored by: Rubicon Communications, LLC (Netgate)
This includes NVMe device support and adds support for the following adapters:
SAS 3408
SAS 3416
SAS 3508
SAS 3516
SAS 3616
SAS 3708
SAS 3716
Reviewed by: ken, scottl, asomers, mav
Approved by: ken, scottl, mav
MFC after: 2 weeks
Relnotes: yes
Differential Revision: https://reviews.freebsd.org/D10095
consistent and easier to read.
While here, remove two unused static functions and fix a unused function
warning when building !INTRNG.
No functional changes.
Sponsored by: Rubicon Communications, LLC (Netgate)
Malloc should always return something when M_WAITOK flag is used,
but keep this code and change flag to M_NOWAIT as it is under a lock
(allows for possible future change). Free ifnet structure to avoid
memory leak on failure.
Submitted by: Zbigniew Bodek <zbb@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10711
If MPIC happens to be a slave interrupt controller (as on Armada38x),
it should be attached after primary interrupt controller.
Thus BUS_PASS_ORDER_LATE was added to default BUS_PASS_INTERRUPT.
This change doesn't affect the cases when MPIC is standalone IC.
Submitted by: Bartosz Szczepanek <bsz@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield, Netgate
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10715
OF_finddevice doesn't find the "simple-bus" node, which is problematic
for Marvell platforms, using nested buses in Device Tree, like
Armada 38x SoC.
Submitted by: Arnaud Ysmal <arnaud.ysmal@stormshield.eu>
Obtained from: Stormshield
Sponsored by: Stormshield
Reviewed by: loos
Differential revision: https://reviews.freebsd.org/D10719
Experimentally we know this value works, but the hardware
may support an even higher value.
PR: 213876
Reported by: J.Catrysse@proximedia.be
MFC after: 1 week
r290383 has changed how mbufs sent by divert socket are handled.
Previously they are always handled by slow path processing in ip_input().
Now ip_tryforward() is invoked from ip_input() before in_broadcast() check.
Since diverted packet lost all mbuf flags, it passes the broadcast check
in ip_tryforward() due to missing M_BCAST flag. In the result the broadcast
packet is forwarded to the wire instead of be consumed by network stack.
Add in_broadcast() check to the div_output() function. And restore the
M_BCAST flag if destination address is broadcast for the given network
interface.
PR: 209491
MFC after: 1 week
prevents one from running eg clang built with debug; the new one is
arbitrary (equal to MAXDSIZ) and... well, should be quite future-proof.
Same fix might be applicable to other 64 bit architectures; I'll ask
their respective maintainers to make sure it won't break anything.
Reviewed by: kib
MFC after: 2 weeks
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D10758
A long long time ago the register keyword told the compiler to store
the corresponding variable in a CPU register, but it is not relevant
for any compiler used in the FreeBSD world today.
ANSIfy related prototypes while here.
Reviewed by: cem, jhb
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D10193
This function permits a range of one scatter/gather list to be appended to
another sglist. This can be used to construct a scatter/gather list that
reorders or duplicates ranges from one or more existing scatter/gather
lists.
Sponsored by: Chelsio Communications
Invoke any identify routines of child drivers during attach before attaching
children, and delete any remaining devices after deleting ports.
MFC after: 1 month
Sponsored by: Chelsio Communications
2. Use sysctls for TRACE_LRO_CNT and TRACE_TSO_PKT_LEN
3. remove unused mtx tx_lock
4. bind taskqueue kernel thread to the appropriate cpu core
5. when tx_ring is full, stop further transmits till at least 1/16th of the Tx Ring is empty. In our case 1K entries. Also if there are rx_pkts to process, put the taskqueue thread to sleep for 100ms, before enabling interrupts.
6. Use rx_pkt_threshold of 128.
MFC after:3 days
For p_endcopy to work correctly, it must be the name of the next element
in struct proc after the end of the copy region, not the name of the
last element in the copy region. Currently, the last element
(p_elf_flags) is not being copied. In addition, the p_xexit and
p_xsig fields should not be copied on fork, so move them out of the
copy region.
Reviewed by: kib
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D10677
With ip fragment reassembly implemented, it makes sense to allow
larger nfs reads. Note due to loader heap size limit, we do not want
to set too large maximum read size. Also we do not change default read size.
Reviewed by: bcr, allanjude
Differential Revision: https://reviews.freebsd.org/D10754
This was introduced in r290156. It's present in 11.0, but not any 10.x
release unless someone decided to MFC it.
It affects ordinary pages right above the DMAP limit, which is effectively
system memory rounded up to a 1 GB (3rd level superpage) boundary (or up to
a minimum of 4 GB, on small systems).
Reported by: vangyzen
Reviewed by: kib, alc
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D4030
This patch improves the boundary checks in busdma to allow more cases
using the regular page based kernel memory allocator. Especially in
the case of having a non-zero boundary in the parent DMA tag. For
example AMD64 based platforms set the PCI DMA tag boundary to
PCI_DMA_BOUNDARY, 4GB, which before this patch caused contiguous
memory allocations to be preferred when allocating more than PAGE_SIZE
bytes. Even if the required alignment was less than PAGE_SIZE bytes.
This patch also fixes the nsegments check for using kmem_alloc_attr()
when the maximum segment size is less than PAGE_SIZE bytes.
Updated some comments describing the code in question.
Differential Revision: https://reviews.freebsd.org/D10645
Reviewed by: kib, jhb, gallatin, scottl
MFC after: 1 week
Sponsored by: Mellanox Technologies
sdhci_fdt.
Enable the SDHCI controller, bus and devices on ARMADA38X kernel.
Tested on: ClearFog Pro
Reviewed by: Marcin Wojtas <mw at semihalf.com>
Sponsored by: Rubicon Communications, LLC (Netgate)
Differential Revision: https://reviews.freebsd.org/D10606
Tested on: ClearFog Pro
Reviewed by: Marcin Wojtas <mw at semihalf.com>
Sponsored by: Rubicon Communications, LLC (Netgate)
Differential Revision: https://reviews.freebsd.org/D10601
function (they used to say UMA_ZONE_NOFREE), so flag parameter goes away.
The zone_fini parameter also goes away. Previously no protocols (except
divert) supplied zone_fini function, so inpcb locks were leaked with slabs.
This was okay while zones were allocated with UMA_ZONE_NOFREE flag, but now
this is a leak. Fix that by suppling inpcb_fini() function as fini method
for all inpcb zones.
The idle thread may process callouts while reloading the timer in
cpu_activeclock(). In this case, provide a representative value, &cpu_idle,
instead of 0 for args[0] so that the active thread can be more easily
identified from the probe.
This addresses intermittent failures of the profile-n/tst.argtest.d test.
MFC after: 2 weeks
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D10651
operation after processor is configured to allow all required
features.
In particular, NX must be enabled in EFER, otherwise load of page
table element with nx bit set causes reserved bit page fault. Since
malloc uses direct mapping for small allocations, in particular for
the suspension pcbs, and DMAP is nx after r316767, this commit tripped
fault on resume path.
Restore complete state of EFER while wakeup code is still executing
with custom page table, before calling resumectx, instead of trying to
guess which features might be needed before resumectx restored EFER on
its own.
Bisected and tested by: trasz
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
