additional information, when the page is guaranteed to not belong to a
paging queue. Usually, this results in a lot of type casts which make
reasoning about the code correctness harder.
Sometimes m->object is used instead of pageq, which could cause real
and confusing bugs if non-NULL m->object is leaked. See r141955 and
r253140 for examples.
Change the pageq member into a union containing explicitly-typed
members. Use them instead of type-punning or abusing m->object in x86
pmaps, uma and vm_page_alloc_contig().
Requested and reviewed by: alc
Sponsored by: The FreeBSD Foundation
- Use the right address when calling kva_free()
(Is there any reason why the s3c2xx0 comes with its own version of bs_map/
bs_unmap ? It seems to be just the same as in bus_space_generic.c)
devices and the FreeBSD USB stack itself. This program can be used to
test compliance against well established usb.org standards, also
called chapter-9 tests. The host platform can act as either USB device
or USB host depending on the available hardware. The basic USB
communication happens through FreeBSD's own libusb v2, and some
sysctls are also used to invoke specific error conditions. This test
program can be used to verify correct operation of external USB
harddisks under heavy load and various other conditions. The software
is driven via a simple command line interface. Main supported USB host
classes are "USB mass storage" and "USB modems".
random_adaptor is basically an adapter that plugs in to random(4).
random_adaptor can only be plugged in to random(4) very early in bootup.
Unplugging random_adaptor from random(4) is not supported, and is probably a
bad idea anyway, due to potential loss of entropy pools.
We currently have 3 random_adaptors:
+ yarrow
+ rdrand (ivy.c)
+ nehemeiah
* Remove platform dependent logic from probe.c, and move it into
corresponding registration routines of each random_adaptor provider.
probe.c doesn't do anything other than picking a specific random_adaptor
from a list of registered ones.
* If the kernel doesn't have any random_adaptor adapters present then the
creation of /dev/random is postponed until next random_adaptor is kldload'ed.
* Fix randomdev_soft.c to refer to its own random_adaptor, instead of a
system wide one.
Submitted by: arthurmesh@gmail.com, obrien
Obtained from: Juniper Networks
Reviewed by: so (des)
for nodes used in vm_radix.
On architectures supporting direct mapping, also avoid to pre-allocate
the KVA for such nodes.
In order to do so make the operations derived from vm_radix_insert()
to fail and handle all the deriving failure of those.
vm_radix-wise introduce a new function called vm_radix_replace(),
which can replace a leaf node, already present, with a new one,
and take into account the possibility, during vm_radix_insert()
allocation, that the operations on the radix trie can recurse.
This means that if operations in vm_radix_insert() recursed
vm_radix_insert() will start from scratch again.
Sponsored by: EMC / Isilon storage division
Reviewed by: alc (older version)
Reviewed by: jeff
Tested by: pho, scottl
Now the MTX_RECURSE flag can be passed to the mtx_*_flag() calls.
This helps in cases we want to narrow down to specific calls the
possibility to recurse for some locks.
Sponsored by: EMC / Isilon storage division
Reviewed by: jeff, alc
Tested by: pho
Unify the 2 concept into a real, minimal, sxlock where the shared
acquisition represent the soft busy and the exclusive acquisition
represent the hard busy.
The old VPO_WANTED mechanism becames the hard-path for this new lock
and it becomes per-page rather than per-object.
The vm_object lock becames an interlock for this functionality:
it can be held in both read or write mode.
However, if the vm_object lock is held in read mode while acquiring
or releasing the busy state, the thread owner cannot make any
assumption on the busy state unless it is also busying it.
Also:
- Add a new flag to directly shared busy pages while vm_page_alloc
and vm_page_grab are being executed. This will be very helpful
once these functions happen under a read object lock.
- Move the swapping sleep into its own per-object flag
The KPI is heavilly changed this is why the version is bumped.
It is very likely that some VM ports users will need to change
their own code.
Sponsored by: EMC / Isilon storage division
Discussed with: alc
Reviewed by: jeff, kib
Tested by: gavin, bapt (older version)
Tested by: pho, scottl
- update powerpc/GENERIC64 as well, suggested by mdf
- update comments so that they make sense after the change, suggested by
jhb
X-MFC after: never (change specific to head)
bit25 of rxMode MAC register of 5762 needs to be set for rx mgmt
filter to work correctly when processing match for UDP header
fields. Otherwise false positive can occur which causes IPv4
fragment to be received by APE instead of host.
Reported by: Geans Pin <geanspin@broadcom.com>
Add a tunable that allows such a device to be excluded from the driver.
The id parameter is the target id that the driver assigns to a given device.
dev.mps.X.exclude_ids=<id>,<id>
Obtained from: Netflix
MFC after: 3 days
Illumos ZFS issues:
3957 ztest should update the cachefile before killing itself
3958 multiple scans can lead to partial resilvering
3959 ddt entries are not always resilvered
3960 dsl_scan can skip over dedup-ed blocks if
physical birth != logical birth
3961 freed gang blocks are not resilvered and can cause pool to suspend
3962 ztest should print out zfs debug buffer before exiting
Check DTLS_BAD_VER for version number.
The version check for DTLS1_VERSION was redundant as
DTLS1_VERSION > TLS1_1_VERSION, however we do need to
check for DTLS1_BAD_VER for compatibility.
Requested by: zi
Approved by: benl
match devices where the driver class was fixed but the unit number was
wildcarded. This better matches the documented behaviour in
DEVICE_PROBE(9).
Reviewed by: imp
the GEOM_PART. Instead of just using number of entries from the GPT
header, calculate this limit based on the reserved space between
GPT header and first available LBA.
MFC after: 2 weeks
(or svnliteversion) in the current lookup path is not what
was used to check out the tree. If an incompatible version
is used, the svn revision number is not reported in uname(1).
Run ${svnversion} on newvers.sh itself when evaluating if the
svn(1) in use is compatible with the tree. Fallback to an
empty ${svnversion} if necessary.
With this change, svnliteversion from base is only used
if no compatible svnversion is found, so with this change,
the version of svn(1) from the ports tree is evaluated first.
Requested by: many
MFC after: 3 days
X-MFC-To: stable/9, releng/9.2 only
echo xxx | grep -D skip xxx
returns nothing. Instead of just removing added S_ISFIFO condition
(originally absent in this version of grep), make it work as latest
GNU version does: don't skip directories and devices if fd == STDIN_FILENO.
any character including '\0', but our version replace escaped '\0'
with '\\'.
I.e. fnmatch("\\", "\\", 0) should not match while fnmatch("\\", "", 0)
should (Linux and NetBSD does the same). Was vice versa.
PR: 181129
MFC after: 1 week
I haven't yet reviewed the Intel driver(s) in more depth to see if
there are 1x1 NICs that report they support 2 transmit/receive chains..
if so then we'll have to update this.
Tested:
* Intel 4965, which is a 2x2 device with 3 RX and 2 TX chains.
PR: kern/181132
upper layer(s).
This eliminates the if_snd queue from net80211. Yay!
This unfortunately has a few side effects:
* It breaks ALTQ to net80211 for now - sorry everyone, but fixing
parallelism and eliminating the if_snd queue is more important
than supporting this broken traffic scheduling model. :-)
* There's no VAP and IC flush methods just yet - I think I'll add
some NULL methods for now just as placeholders.
* It reduces throughput a little because now net80211 will drop packets
rather than buffer them if the driver doesn't do its own buffering.
This will be addressed in the future as I implement per-node software
queues.
Tested:
* ath(4) and iwn(4) in STA operation
This is a cosmetic change but it does help with a proposed change to increase
the maximum size of physical memory supported on amd64 platforms.
Submitted by: Chris Torek (torek@torek.net)
bypass mode when src == dst. Unfortunately, there are tools in ports
that pass byte streams through iconv to determine if the encodings
are valid. eg: gettext-0.18.3+.
Disable the optimization and behave like the other implementations.
