- bounded cookie-life to 1 second minimum in socket option set.
- Delayed_ack_time becomes delayed_ack per new socket api document.
- Improve port number selection, we now use low/high bounds and
no chance of a endless loop. Only one call to random per bind
as well.
- fixes so set_peer_primary pre-screens addresses to be
valid to this host.
- maxseg did not allow setting on an assoc basis. We needed
to thus track and use an association value instead of a inp value.
- Fixed ep get of HB status to report back properly.
- use settings flag to tell if assoc level hb is on off not
the timer.. since the timer may still run if unconf address
are present.
- check for crazy ENABLE/DISABLE conditions.
- set and get of pmtud (fixed path mtu) not always taking into account ovh.
- Getting PMTU info on stcb only needs to return PMTUD_ENABLED if
any net is doing PMTU discovery.
- Panic or warning fixed to not do so when a valid ip frag is
taking place.
- sndrcvinfo appearing in both inp and stcb was full size, instead
of the non-pad version. This saves about 92 bytes from each struct
by carefully converting to use the smaller version.
- one-2-one model get(maxseg) would always get ep value, never the
tcb's value.
- The delayed ack time could be under a tick, this fixes so
it bounds it to at least 1 tick for platforms whos tick
is more than a ms.
- Fragment interleave level set to wrong default value.
- Fragment interleave could not set level 0.
- Defered stream reset was broken due to a guard check and ntohl issue.
- Found two lock order reversals and fixed.
- Tighten up address checking, if the user gives an address the sa_len
had better be set properly.
- Get asoc by assoc-id would return a locked tcb when it was asked
not to if the tcb was in the restart hash.
- sysctl to dig down and get more association details
Reviewed by: gnn
in tcp_input():
o tighten the checks on allowed TCP flags to be RFC793 and
tcp-secure conform
o log check failures to syslog at LOG_DEBUG level
o rearrange the code flow to be easier to follow
o add KASSERTs to validate assumptions of the code flow
Add sysctl net.inet.tcp.syncache.rst_on_sock_fail defaulting to enable
that controls the behavior on socket creation failure for a otherwise
successful 3-way handshake. The socket creation can fail due to global
memory shortage, listen queue limits and file descriptor limits. The
sysctl allows to chose between two options to deal with this. One is
to send a reset to the other endpoint to notify it about the failure
(default). The other one is to ignore and treat the failure as a
transient error and have the other endpoint retransmit for another try.
Reviewed by: rwatson (in general)
based on individual fields beeing set. This doesn't work for setattr replay,
because va_type is set there, so we add AT_TYPE flag to va_mask, which won't
be accepted by zfs_setattr().
Reported by: kris
- Double the number of descriptors that a single call to send can use
- Quadruple the number of descriptors that can be reclaimed per pass
- only run reclaim twice per second
- increase coalesce timer from 3.5us to 5us
fix printf warning on 64-bit platforms
Neither me nor Ariff have access to any of this hardware, so all tests
have been made by Konstantin and Artem. Commit message mostly written
by Konstantin.
envy24:
- Add test code to support rear line-in input on 'Terratec DMX 6fire'
audio card. This code is also intended to be used in the future for
support of cards, that have I2C-to-GPIO expanders wired between the
control line of the audio codec and the Envy24, however such cards
are too complex and i can't add that support without hardware sample
of such board, i've already tried and failed.
envy24ht:
- Add support for 'AudioTrak Prodigy HD2'.
- Add support for 'AudioTrak Prodigy 7.1 XT'.
- Add support for 'ESI Juli@' (Works ok, DAC volume is hard-coded for
the time being, so 'mixer vol ...' doesn't work, only 'mixer pcm
...' works). [1]
- Fix bug in the init data for M-Audio Revolution 5.1, that
results in distorted sound.
- Add software volume control (now 'mixer pcm' works, thanks to Ariff).
- Add support for more samples rates - 176.4kHz and 192kHz.
- Fix problem with the 192kHz samples rate playback when 24.576MHz
crystal is used on the board instead of 49.152MHz crystal.
spicds:
- Add support for Asahi Kasei flagship DAC - AK4396 (used in AudioTrak
Prodigy HD2).
Submitted by: Konstantin Dimitrov <kosio.dimitrov@gmail.com>
Tested by: Artem Antonov [1]
Reviewed by: ariff
debugger is quite capable of handling Giant-free execution at this
point. Several other similar comments remain in trap.c on both i386
and amd64 awaiting analysis.
speculative loads. This at least makes control speculative loads
work. In the future we should analyze which faults/exceptions
we want to handle rather than defer to avoid having to call the
recovery code when it's not strictly necessary.
actually works. mbp_count() turns out only to be used in debugging code
in if_patm_intr.c, so this bug did not affect much in practice.
Found with: Coverity Prevent(tm)
CID: 1943
existing UMA statistics for pipes, and allows us to get rid of both the
per-pipe dtor and two atomic operations per pipe required to maintain
the counter.
at the credential to be used by the connection. However, the pointer's
value was ignored when actually setting hcp->nc_owner.
(1) Do set nc_owner to the owner pointer value so that the credential is
not discarded after being carefully configured.
(2) In the case where we create a new credential with modified uid, copy
the existing credential to initialize non-uid fields to existing
values, which will lead to a fully initialized MAC label, groups, etc.
Found with: Coverity Prevent(tm)
CID: 2226
the card, panic explicitly if EN_DEBUG is enabled. In the (default)
case of !EN_DEBUG, the driver resets the card. Probably this case
shouldn't exist at all.
debug is turned off, initialize locks with NOWITNESS flag.
At some point I'll get back to them, we would probably need BLESSING
functionality, which is currently turned off by default.
SD Simplified specification, as well as other SD and SDIO
implemenations I've examined, suggest this disclaimer may be required.
It is unclear to me exactly what the license would be for, or why it
might be required. Err on the side of caution and include this
disclaimer so anybody deploying this code can judge for themselves. I
have no further unformation about the details.
parent vnode and relock it after locking child vnode. The problem was that
we always relock it exclusively, even when it was share-locked.
Discussed with: jeff