Some systems may provide multiple GOP instances and not all are
bound to hardware. The current loader is picking up the first GOP,
which may not be usable. Instead we load the GOP handle array,
and test every handle to have registered ConOut protocol. If ConOut is
present, we can use this GOP handle to open GOP protocol.
Back when I wrote openfirm.4, sparc64 was the only architecture to
include the corresponding device. However, nowadays all supported
architectures will provied this Open Firmware interface, even x86
when built with FDT support.
As for ofw_console(4), powerpc actually was the first architecture
to ship it but we'll probably not see another consumer in future.
This partially reverts 702547720c and
r357794 respectively, adjusting paths and content as appropriate.
rtinit[1]() is a function used to add or remove interface address prefix routes,
similar to ifa_maintain_loopback_route().
It was intended to be family-agnostic. There is a problem with this approach
in reality.
1) IPv6 code does not use it for the ifa routes. There is a separate layer,
nd6_prelist_(), providing interface for maintaining interface routes. Its part,
responsible for the actual route table interaction, mimics rtenty() code.
2) rtinit tries to combine multiple actions in the same function: constructing
proper route attributes and handling iterations over multiple fibs, for the
non-zero net.add_addr_allfibs use case. It notably increases the code complexity.
3) dstaddr handling. flags parameter re-uses RTF_ flags. As there is no special flag
for p2p connections, host routes and p2p routes are handled in the same way.
Additionally, mapping IFA flags to RTF flags makes the interface pretty messy.
It make rtinit() to clash with ifa_mainain_loopback_route() for IPV4 interface
aliases.
4) rtinit() is the last customer passing non-masked prefixes to rib_action(),
complicating rib_action() implementation.
5) rtinit() coupled ifa announce/withdrawal notifications, producing "false positive"
ifa messages in certain corner cases.
To address all these points, the following has been done:
* rtinit() has been split into multiple functions:
- Route attribute construction were moved to the per-address-family functions,
dealing with (2), (3) and (4).
- funnction providing net.add_addr_allfibs handling and route rtsock notificaions
is the new routing table inteface.
- rtsock ifa notificaion has been moved out as well. resulting set of funcion are only
responsible for the actual route notifications.
Side effects:
* /32 alias does not result in interface routes (/32 route and "host" route)
* RTF_PINNED is now set for IPv6 prefixes corresponding to the interface addresses
Differential revision: https://reviews.freebsd.org/D28186
.Dl indents literal display text for one line, but .Bd can do it for a
whole subsection.
Pointy hat to: debdrup
Reported by: 0mp
Reviewed by: 0mp
Differential Revision: https://reviews.freebsd.org/D28198
service(8) has an example for bash completion, however bash is third
party and in /usr/share/examples/csh/dot.cshrc is a working example for
csh.
Since I use (t)csh, I've tested it, and it works for me.
PR: 179497
Submitted by: ohauer@
Reviewed by: kp (tentatively)
Differential Revision: https://reviews.freebsd.org/D28197
On little-endian PowerPC64, this prevented /usr/lib/clang/11.0.0 being
cleaned up completely after upgrading to clang 11.0.1.
Noticed by: pkubaj
MFC after: 4 weeks
X-MFC-With: r364284
There is no guarantee that after close(2)/free the errno will remain
persistent. The caller of the udom_open function depends on the errno
for reporting errors.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D28185
AMD 10GbE hardware is designed to have two buffers per receive descriptor to
support split header feature. For this purpose, the driver was designed to use
2 iflib freelists per receive queue. So, that buffers from 2 freelists are used
to refill an entry in the receive descriptor. The current design holds good
with regular data traffic.
But, when netmap comes into play, the current design will not fit in. The
current netmap interfaces and netmap implementation in iflib doesn't seem
to accomodate the design of 2 freelists per receive queue. So, exercising
Netmap capability with inbuilt tools like bridge, pkt-gen doesn't work with
the 2 freelists driver design.
So, the driver design is changed to accomodate the current netmap interfaces
and netmap implementation in iflib by using single freelist per receive queue
approach when Netmap capability is exercised without disturbing the current
2 freelists approach.
The dev.ax.sph_enable tunable can be set to 0 to configure the single
free list mode.
Thanks to Stephan Dewt for his Initial set of code changes for the stated
problem.
Submitted by: rajesh1.kumar_amd.com
Approved by: vmaffione
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D27797
This rode in with the OpenZFS import. It may have been necessary at some
point, but it is no longer and it breaks the WITHOUT_DYNAMICROOT build as
it collides with the definition in libspl.
Reported-by: Michael Dexter
-R is currently shorthand for cachefile=none, altroot=<mount>. This is
functionally the same, but perhaps more resilient to future changes that
could be necessary that may be added when -R is specified.
MFC after: 1 week
disk failure.
Each vnode has an embedded lock that controls access to its contents.
However vnodes describing a UFS snapshot all share a single snapshot
lock to coordinate their access and update. As part of mounting a
UFS filesystem with snapshots, each of the vnodes describing a
snapshot has its individual lock replaced with the snapshot lock.
When the filesystem is unmounted the vnode's original lock is
returned replacing the snapshot lock.
When a disk fails while the UFS filesystem it contains is still
mounted (for example when a thumb drive is removed) UFS forcibly
unmounts the filesystem. The loss of the drive causes the GEOM
subsystem to orphan the provider, but the consumer remains until
the filesystem has finished with the unmount. Information describing
the snapshot locks was being prematurely cleared during the orphaning
causing the return of the snapshot vnode's original locks to fail.
The fix is to not clear the needed information prematurely.
Sponsored by: Netflix
with snapshots.
Each vnode has an embedded lock that controls access to its contents.
However vnodes describing a UFS snapshot all share a single snapshot
lock to coordinate their access and update. As part of mounting a
UFS filesystem with snapshots, each of the vnodes describing a
snapshot has its individual lock replaced with the snapshot lock.
When the filesystem is unmounted the vnode's original lock is
returned replacing the snapshot lock.
The lock order reversal happens because vnode locks must be acquired
before snapshot locks. When unmounting we must lock both the snapshot
lock and the vnode lock before swapping them so that the vnode will
be continuously locked during the swap. For each vnode representing
a snapshot, we must first acquire the snapshot lock to ensure
exclusive access to it and its original lock. We then face a lock
order reversal when we try to acquire the original vnode lock. The
problem is eliminated by doing a non-blocking exclusive lock on the
original lock which will always succeed since there are no users
of that lock.
Sponsored by: Netflix
This fixes the positioning of the "Welcome to FreeBSD" heading, which was
misplaced after the recent update to Lua 5.4. The issue was previously
masked by a compatibility knob in Lua 5.3 that would cause float-tagged
numbers to render faithfully without the decimal component. Lua 5.4 dropped
that and ensures that it always prints a decimal component, even if it has
to append a ".0" to the value.
Standard division produces a "float", floor division (//) can be used to
guarantee an integer. Floating point operations have been completely ripped
out of the liblua compiled for the bootloader, so this is a nop. This is
decidedly better than trying to hack out the float tag entirely.
Reported-by: mjg, probably others
MFC-after: 3 days
depend on FILESYSTEMS run mktemp(1). For systems that have read-only
root this is broken until memory disk based /tmp is instantiated. At
least 'os-release' and 'motd' are subject to this problem.
Reviewed by: ngie
Differential Revision: https://reviews.freebsd.org/D28097
remote filesystems. Discussed this with Brooks and he can't find
evidence that provoked the change in 2005. If anything gets broken
I will fix it in a different way, not via rc sequence change.
Discussed with: brooks
Reviewed by: ngie
Differential Revision: https://reviews.freebsd.org/D28097
This allows us to use it when we only need to check if the virtual address
is valid. For example when checking if an address in the DMAP region is
mapped.
Reviewed by: kib, markj
Sponsored by: Innovate UK
Differential Revision: https://reviews.freebsd.org/D27621
The old vendor tree was never fully merged and doing partial merge isn't
supported with git subtree merge so a new one was created.
Switch the build to use the new DTS from sys/contrib/device-tree
This also bump the DTS used to be in sync with Linux 5.9
While here change the way to get the linux version, simply hardcode
the value in sys/dts/freebsd-compatible.dts and use awk to get that
to put it in the CFLAGS.
As a bonus we now have the bindings docs available
in sys/contrib/device-tree/Bindings/ so no need to link to the Linux repo
or to the vendor tree.
It changed the #pinctrl-cells value to be equal to 2 and the macro
that generates the values.
Based on the bindings docs a value of 2 is only acceptable if the node
used pinctrl-single,bits and not pinctrl-single,pins
This allow booting further on the beaglebone black with 5.9 DTS
A more complete fix for this function is being worked on in D28054. Fix
the uninitialized variable error so that builds can at least proceed.
Reported by: several
