longer used. More precisely, they are always zero because the code that
decremented and incremented them no longer exists.
Bump __FreeBSD_version to mark this change.
Reviewed by: kib, markj
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D8583
an invalid address. It is also unneeded on arm64 as we use the ARM Generic
Timer driver.
Obtained from: ABT Systems Ltd
Sponsored by: The FreeBSD Foundation
TODO:
* drink real coffee before committing in the morning, or there's a high
risk of more obviously self-evident commits being turned into attempts
at humour.
Reported by: cem, Coverity CID 1366219
See r294954 for the bread(9) change and r297401 for similar cd9660 fix.
Reported and tested by: Joshua Kinard <kumba@gentoo.org>
PR: 214705
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The pager, due to its construction, implements clustering for the
page-ins. In particular, buildworld load demonstrates reduction of
the READ RPCs from 39k down to 24k. No change in real or CPU time was
observed.
Discussed with, and measured by: bde
No objections from: rmacklem
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
This just stores pointers to the IE; it doesn't yet parse anything.
Note: it blows out the size of ieee80211_node, so this will require
ye olde kernel/modules recompile.
* Obey the peer A-MPDU density if it's larger than the currently configured
one.
* Pay attention to the peer A-MPDU max-size and don't assume we can transmit
a full A-MPDU (64k!) if the peer announces smaller values.
Relnotes: ath(4): Fix A-MPDU transmit; obey A-MPDU density and max size.
* Pepper comments around which describe what state(s) we're in when faking
up 11n nodes.
* By default don't fake it up as 11n until we properly negotiate the 11n
capabilities using probe request/response frames.
* Send a probe request with our HT information, as the 802.11-2012 spec
suggests.
* Reassociate with the driver if we've been promoted.
This is done because although learning a peer via beacons can learn 11n
state, learning peers via hearing probe frames and broadcast frames
does not. Thus, sometimes you end up with an 11n peer in the peer
table and sometimes you don't.
Note that the probe request/response exchange may not actually succeed.
Ideally we'd put the peer into some blocking state until we've exchanged
probe request/reponse to learn capabilities, or we timeout and just
stay non-11n.
This is more an experiment to get 11n IBSS nodes actually discovering
each other and be able to transmit. There are other issues that creep
up which I'll attempt to address in future commits.
Tested:
* AR9380 NICs in 11n mode.
Reviewed by: avos
Differential Revision: https://reviews.freebsd.org/D8365
This avoids the time-warp after kthreads have started running and the
required fixup to td_slptick and td_blktick in the EARLY_AP_STARTUP
case. Now, 'ticks' is initialized before any kthreads are created or
any context switches are performed.
Tested by: gavin
MFC after: 2 weeks
Sponsored by: Netflix
always audit the file-descriptor number and vnode information for all
fnctl(2) commands, not just locking-related ones. This was likely an
oversight in the original adaptation of this code from XNU.
MFC after: 3 days
Sponsored by: DARPA, AFRL
The default pkg(8) from pkg.freebsd.org requires libjail.so,
so mark the jail package as vital along with the runtime
package to avoid errors when libjail.so is removed. This is
a no-op for systems with WITHOUT_JAIL in src.conf(5) and pkg(8)
built from the Ports Collection.
In order to make this work without marking packages such as
the jail-lib32, for example, the jail.ucl file needed to be
split out into separate files similarly to the runtime-*.ucl
files.
Glanced at by: brd
MFC after: 5 days
Sponsored by: The FreeBSD Foundation
many borken middle-boxes tend to do that. But during 3whs, in syncache_expand(),
we don't do that which causes us to send a RST to such a client. Relax this
constraint by only using tsecr to compare against timestamp that we sent when it
is not 0. As a result, we'd now accept the final ACK of 3whs with tsecr of 0.
Reviewed by: jtl, gnn
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D8552
This patch allows to specify PHY register offset for ukswitch. For instance,
switch MAICREL KS8995XA connected via MDIO to SoC, but PHY register starts
at 1. So hint for this case is: hint.ukswitch.0.phyoffset=1
No change/effect if hint is not set.
Submitted by: Hiroki Mori <yamori813@yahoo.co.jp>
Reviewed by: adrian, mizhka
Approved by: adrian(mentor)
Differential Revision: https://reviews.freebsd.org/D8584
FDT attachment to a new file. A separate ACPI attachment will then be added
to allow arm64 servers with ACPI to use it over FDT.
This should also help with merging this with the ofwpci driver, with
further work needed to remove restrictions this driver places on resource
allocation.
Obtained from: ABT Systems Ltd
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D7319
(hopefully) stock gcc 4.2.1 on i386 and other arches.
In particular:
- Do not use %ebx in the asm constraints on i386, since rtld is
compiled with -fPIC and gcc cannot handle GOT-base register reload
(clang and newer gcc can).
- Avoid direct use of [static N] construct in the function
declaration/definion. In-tree gcc was patched to support this, but
stock 4.2.1 cannot handle the feature.
Requested by: bde
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
uart we need to handle both it and FDT, and as such we need to have an
architecture specific driver.
Obtained from: ABT Systems Ltd
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D7796
on the AES-NI code, and modified as needed for use on ARMv8. When loaded
the driver will check the appropriate field in the id_aa64isar0_el1
register to see if AES is supported, and if so the probe function will
signal the driver should attach.
With this I have seen up to 2000Mb/s from the cryptotest test with a single
thread on a ThunderX Pass 2.0.
Reviewed by: imp
Obtained from: ABT Systems Ltd
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8297
Just in case, the # of TX/RX rings is changed upon synthetic parts
re-attach.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8520
And re-enable SIOCADDMULTI/SIOCDELMULTI, after WITNESS warning is fixed.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8489
Currently, it is only applied to packet sent through chimney sending
buffers. Not enabled by default yet.
This one gives 20%~30% performance boost for non-TSO usage in both
bit/packet rate tests and nginx performance test.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8560
When wcstof() skipped initial space and then parsing failed, it set
endptr to the first non-space character. Fix it to correctly report
failure by setting endptr to the beginning of the input string.
The fix is from theraven@, who fixed this bug in wcstod() and
wcstold() in r227753.
While I'm here:
Move assignments out of declarations in wcstod() and wcstold().
This is against my personal preference, but it is our agreed style(9).
Set endptr correctly on malloc() failure in all three functions.
Remove an incorrect comment: This is pointer arithmetic,
so the code was not actually making that assumption.
wcstold() advanced the wcp pointer beyond leading whitespace
and then reset it back to the beginning of the string.
Do not reset it. This seems to have no functional effect,
since strtold_l() also skips leading whitespace. I'm making
the change to keep this function consistent with wcstof() and
wcstod(), and because the C11 spec prescribes the use of iswspace()
to skip leading space.
Reported by: libc++ unit test for std::stof(std::wstring)
MFC after: 8 days
Sponsored by: Dell EMC
