This causes dtrace to automatically copyin arguments from userland, so
one no longer has to explicitly use the copyin() action to do so. Moreover,
copyin() on userland addresses is a no-op, so existing scripts should be
unaffected by this change.
Discussed with: rstone
MFC after: 2 weeks
This changes the transmit rate control code to do a few things:
* use fixed rates (mcast, ucast, mgmt) where required.
* Don't use a hard-coded 11a or 11bg rate for non-data frames -
use what net80211 says we should use.
* use mgmtrate for EAPOL frames.
Reviewed by: avos
Differential Revision: https://reviews.freebsd.org/D7994
The adhoc probe/beacon input path was creating nodes for all SSIDs.
This wasn't a problem when the NICs were configured to only process
frames for the current BSSID, but that didn't allow IBSS merges.
Once avos and I flipped on "beacons from all BSSIDs" to allow for
correct IBSS merging, we found this interesting behaviour.
This adds a check against the current SSID.
* If there's no VAP SSID, allow anything
* If there's a VAP SSID, check if the incoming frame has a suitable
SSID and if so, allow it.
This prevents nodes being created for other SSIDs in probe and beacon
frames - ie, beacons overlapping IBSSes with different SSIDs, and
probe requests from arbitrary devices.
Tested:
* AR9380, IBSS mode, both local and other IBSSes.
Reviewed by: avos
Differential Revision: https://reviews.freebsd.org/D7959
event generation is disabled by default in favour of sysmouse. This
behavoiur is controlled by kern.evdev.rcpt_mask sysctl, bit 2 should
be set to give priority to hw over sysmouse
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
Reviewed by: hans
Differential Revision: https://reviews.freebsd.org/D7863
event generation is disabled by default in favour of kbdmux. This
behavoiur is controlled by kern.evdev.rcpt_mask sysctl, bit 3 should
be set to give priority to hw over mux
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
Reviewed by: hans
Differential Revision: https://reviews.freebsd.org/D7957
During a bus rescan the check for an invalid vendor ID of a subfunction
used the wrong constant.
Submitted by: Dexuan Cui <decui@microsoft.com>
MFC after: 3 days
This is an RTL8168 chip, which we already support so all we have to do is add
the vendor ID.
PR: 212876
Submitted by: Tobias Kortkamp <t@tobik.me>
MFC after: 3 days
Right now our workaround is so good that it doesn't throw any warnings
on misuse. This means that people will keep on using the old version
of dirname(3) silently without fixing their code.
Go ahead and change the prototype of __old_dirname() to also use a plain
char *, so that we still get a compiler warning. This won't have any
negative effect on building older versions of FreeBSD on HEAD, as those
are built with -Werror disabled.
Differential Revision: https://reviews.freebsd.org/D7844
These functions are allowed to overwrite their input. Pull a copy of the
input parameter and call dirname() and basename() on that instead. Do
ensure that we reload the pathname value between calls.
This helps to ensure we will not lose SIGINT sent by parent to child.
Reviewed by: sbruno, ngie
Sponsored by: DARPA, AFRL
Sponsored by: HEIF5
Differential Revision: https://reviews.freebsd.org/D7892
Runtime services require special execution environment for the call.
Besides that, OS must inform firmware about runtime virtual memory map
which will be active during the calls, with the SetVirtualAddressMap()
runtime call, done while the 1:1 mapping is still used. There are two
complication: the SetVirtualAddressMap() effectively must be done from
loader, which needs to know kernel address map in advance. More,
despite not explicitely mentioned in the specification, both 1:1 and
the map passed to SetVirtualAddressMap() must be active during the
SetVirtualAddressMap() call. Second, there are buggy BIOSes which
require both mappings active during runtime calls as well, most likely
because they fail to identify all relocations to perform.
On amd64, we can get rid of both problems by providing 1:1 mapping for
the duration of runtime calls, by temprorary remapping user addresses.
As result, we avoid the need for loader to know about future kernel
address map, and avoid bugs in BIOSes. Typically BIOS only maps
something in low 4G. If not runtime bugs, we would take advantage of
the DMAP, as previous versions of this patch did.
Similar but more complicated trick can be used even for i386 and 32bit
runtime, if and when the EFI boot on i386 is supported. We would need
a trampoline page, since potentially whole 4G of VA would be switched
on calls, instead of only userspace portion on amd64.
Context switches are disabled for the duration of the call, FPU access
is granted, and interrupts are not disabled. The later is possible
because kernel is mapped during calls.
To test, the sysctl mib debug.efi_time is provided, setting it to 1
makes one call to EFI get_time() runtime service, on success the efitm
structure is printed to the control terminal. Load efirt.ko, or add
EFIRT option to the kernel config, to enable code.
Discussed with: emaste, imp
Tested by: emaste (mac, qemu)
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
physical address of the EFI System Table. Add _KERNEL guard around
its declaration in sys/efi.h.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
There is no way to see anything about the faults occuring in
loader.efi. Some intel BIOSes do output a line into serial port at
115200/8/1 regardless of the current port settings with the EFI error
number, but this is too little, and not always available, esp. if the
user does not know where to look.
The patch adds a simple facility to grab exceptions and at least dump
generic registers and some exception details. Due to the relative
complexity of correctly taking over the BIOS IDT setup, only install
the facility on user request.
Two new commands, 'grab_faults' and 'ungrab_faults' are provided,
first one takes over, second undoes the first. It is supposed that
user would execute 'grab' by the developer direction of collecting the
debugging data. The 'fault' command generates exception to test the
setup.
Fault handlers use dedicated stack to improve chances of catching
stack/TSS exceptions. Due to this, BIOS IDT is duplicated into a
private copy, and debugger needs to find a free GDT slot for TSS. This
is done in somewhat complicated efi_redirect_exceptions().
Reviewed by: jhb
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D7935
CLOCK_GETTIME() with the lock.
Now all time-related accesses to the CMOS for RTC should be under the
lock. This is needed to allow upcoming EFI Runtime Services support
to provide required execution environment for the firmware calls.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Note that lgdt() name is already used for function which, besides
loading GDT, also reloads segment descriptors cache, thus new function
is named bare_lgdt().
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
amd64 pmap.
The new pmap_pinit_pml4() function initializes the level 4 page table
with entries for the kernel mappings. Both functions are needed for
upcoming EFI Runtime Services support.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
There were two bugs:
* There was an accounting bug resulting in reporting a too small a_rwnd.
* There are a bug when abandoning messages in the reassembly queue.
MFC after: 4 weeks
Both can be used to cause processes in capability mode to receive
SIGTRAP when ENOTCAPABLE or ECAPMODE errors are returned from
syscalls.
Idea by: emaste
Reviewed by: oshogbo (previous version), emaste
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D7965
2) Implememt %u for GNU compatibility.
3) Don't forget to advance buf for %w/%u.
4) Fail with incomplete week (week 0) request and no such week in the
year.
5) Fix yday formula when Sunday requested and the week started from Monday.
6) Fail with impossible yday for incomplete week (week 0) and direct %w/%u
request.
7) Shift yday/wday to the first day of the year, if incomplete week
(week 0) requested and no %w/%u used.
MFC after: 7 days
So that reinitialization, e.g. MTU change, will not fail when the system
memory is excessively fragmented.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D7961
The assumption that the channel is only opened upon synthetic device
attach time no longer holds, e.g. Hyper-V network device MTU changes.
We have to allow device drivers to preallocate bufrings, e.g. in
attach DEVMETHOD, to prevent bufring allocation failure once the
system memory is fragmented after running for a while.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D7960
SPI-mapped MSI interrupts coming from a controller other
than GICv2m need to have their trigger and polarity
properly configured. This patch fixes MSI/MSI-X
on Annapurna Alpine platform with GICv2.
Obtained from: Semihalf
Submitted by: Michal Stanek <mst@semihalf.com>
Sponsored by: Annapurna Labs
Reviewed by: skra, wma
Differential Revision: https://reviews.freebsd.org/D7698
PIC_SETUP_INTR implementation in GICv3 did not allow
for setting up interrupts without included FDT
description. GICv2m-like MSI interrupts, which map
MSI messages to SPI interrupt lines, may not have
a description in FDT. Add support for such interrupts
by setting the trigger and polarity to the appropriate
values for MSI (edge, high) and get the hardware
IRQ number from the corresponding ISRC.
Obtained from: Semihalf
Submitted by: Michal Stanek <mst@semihalf.com>
Sponsored by: Annapurna Labs
Reviewed by: wma
Differential Revision: https://reviews.freebsd.org/D7662
