100 cycles per us seems accurate enough, at least it's better than the 200 value
that was used before.
Reviewed by: andrew, imp
Differential Revision: https://reviews.freebsd.org/D8062
Since if_addrlist is used only for ipfilter(4), add a macro if_addrlist
in ip_compat.h.
Reviewed by: cy
Differential Revision: https://reviews.freebsd.org/D8059
This prepares to consolidate hn_stop() and netvsc_detach().
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8055
Technically touchscreen chip is FT5406 but all hardware
communication is performed by VideCore and only final results
are presented to ARM part through memory region shared between
VC and ARM.
evdev is used as userland interface. FT5406 supports up to
10 touchpoints, but for now driver emulates single touch device
because I do not have GUI bits to test this functionality.
Driver is not enabled in default config for RPI and RPI2
Tested with: evdev-dump, tslib
- The original 'disengage' ATA controller model does not work properly
for all possible disk configurations. Use the newly added ATA disk
veto eventhandler to fit into all possible disk configuration.
- If the 'invalid LUN' happens on blkvsc controllers, return
CAM_DEV_NOT_THERE so that CAM will not destroy attached disks under
the blkvsc controllers.
Submitted by: Hongjiang Zhang <honzhan microsoft com>
Discussed with: mav
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D7693
Until we can resolve the numerous hole_birth bugs that have cropped up
recently, and come up with a way going forwards to protect users from
corruption, we should disable the hole_birth feature. Using a tunable
allows those who are confident that their data is correct to continue to
take advantage of the feature.
Closes#188
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Author: Paul Dagnelie <pcd@delphix.com>
dsl_dataset_space is looking at the ds_bp's fill count while
dmu_objset_write_ready() is concurrently modifying it. This fix adds an
rrwlock to protect the ds_bp.
Closes#180
Reviewed by: George Wilson <george.wilson@delphix.com>
Reviewed by: Prakash Surya <prakash.surya@delphix.com>
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Steve Gonczi <steve.gonczi@delphix.com>
Author: Paul Dagnelie <pcd@delphix.com>
Until we can resolve the numerous hole_birth bugs that have cropped up
recently, and come up with a way going forwards to protect users from
corruption, we should disable the hole_birth feature. Using a tunable
allows those who are confident that their data is correct to continue to
take advantage of the feature.
Closes#188
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Author: Paul Dagnelie <pcd@delphix.com>
dsl_dataset_space is looking at the ds_bp's fill count while
dmu_objset_write_ready() is concurrently modifying it. This fix adds an
rrwlock to protect the ds_bp.
Closes#180
Reviewed by: George Wilson <george.wilson@delphix.com>
Reviewed by: Prakash Surya <prakash.surya@delphix.com>
Reviewed by: Matthew Ahrens <mahrens@delphix.com>
Reviewed by: Steve Gonczi <steve.gonczi@delphix.com>
Author: Paul Dagnelie <pcd@delphix.com>
Previously it was possible to smuggle in addional files that would
be used by later portsnap runs. Now we only move those files expected
to be in the snapshot into files/ and require that there are no
unexpected files.
This was used by portsnap attacks 2, 3, and 4 in the "non-cryptanalytic
attacks against FreeBSD update components" anonymous gist.
Reported by: anonymous gist
Reviewed by: allanjude, delphij
MFC after: ASAP
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8052
s_{fabs,fmax,logb,scalb}{,f,l}.c may be built elsewhere with a higher
WARNS setting.
Reviewed by: ed
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8061
While here, prefer if_addrhead (FreeBSD) to if_addrlist (BSD compat) naming
for the interface address list in sctp_bsd_addr.c
Reviewed by: tuexen
Differential Revision: https://reviews.freebsd.org/D8051
This eventhandler is mainly used by VMs, e.g. Hyper-V, whose disk
controllers share the disks with the simulated ATA controllers.
Submitted by: Hongjiang Zhang <honzhan microsoft com>
Discussed with: mav
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D7693
Suspend:
- Prevent the backend from being touched on TX path.
- Clear the RNDIS RX filter, and wait for RX to drain.
- Make sure that NVS see the chimney sending buffer and RXBUF
disconnection, before unlink these buffers from the channel.
Resume:
- Reconfigure the RNDIS filter.
- Allow TX path to work on the backend.
- Kick start the TX eof task, in case the OACTIVE is set.
This fixes various panics, when the interface has traffic and MTU
is being changed.
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8046
The command interpreter does leave command_errmsg as is after printing its
content, assuming the next command will reset it in bf_command(). However,
in case the forth native word is defined as builtin, the bf_command is not
used and forth words will also end up the command_errmsg content printed.
Since command_errmsg is pointer to actual error message, which can be static
read only string, we can not just set *command_errmsg = '\0', instead we need
to reset the pointer itself.
Illumos issue: https://www.illumos.org/issues/7405
Reported by: Igor Kozhukhov.
Reviewed by: allanjude
Approved by: allanjude (mentor)
Differential Revision: https://reviews.freebsd.org/D8032
Also switch to the style used in the clang390-import branch to reduce
future conflicts.
Reviewed by: dim
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8039
The hardware can be set to limit the number of interrupts from 2 to 63
interrupts per ms.
To keep the compatibility with the TI documentation the sysctl take the
interval between the interrupts pulses: 16~500 us.
Sponsored by: Rubicon Communications, LLC (Netgate)
It also turns off dependencies (bsdinstall, bsdconfig, dpv, tzsetup).
Reviewed by: dteske
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D7969
It's unsafe to update the BAR when the related EN bit is set.
Submitted by: Dexuan Cui <decui microsoft com>
Reviewed by: jhb
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D7914
Summary:
This enables some features of the DIU, using a static configuration,
specified either via a 'edid' property on the 'display' FDT node, or a
'video-mode' environment variable (bootarg). 'video-mode' was chosen because it
matches u-boot's naming, so it can be set with:
setenv bootargs video-mode=${video-mode}
at the u-boot CLI.
Mouse cursor is not supported currently, as a hardware cursor is not supported
by framebuffer VT yet. Currently it only supports a 32bpp ARGB (actually BGRA)
format, and only a single composite plane, at up to 1280x1024.
Differential Revision: https://reviews.freebsd.org/D8022
Elantech trackpads are found in some laptops like the Asus UX31E. They
are "synaptics compatible" but use a slightly different protocol.
Elantech hardware support is not enabled by default and just like
Synaptic or TrackPoint devices it should be enabled by setting
tunable, in this case hw.psm.elantech_support, to non-zero value
PR: 205690
Submitted by: Vladimir Kondratyev <wulf@cicgroup.ru>
MFC after: 1 week
i.e. SandyBridge and IvyBridge, correct a race between pmap_activate()
and invltlb_pcid_handler().
Reported by and tested by: Slawa Olhovchenkov <slw@zxy.spb.ru>
MFC after: 1 week
