out verbatim to the disk: see ffs_sbput() in sys/ufs/ffs/ffs_subr.c.
It contains a pointer to the fs_summary_info structure. This pointer
value inadvertently causes garbage to be stored. It is garbage because
the pointer to the fs_summary_info structure is the address the then
current stack or heap. Although a mere pointer does not reveal anything
useful (like a part of a private key) to an attacker, garbage output
deteriorates reproducibility.
This commit zeros out the pointer to the fs_summary_info structure
before writing the out the superblock.
Reviewed by: kib
Tested by: Peter Holm
PR: 246983
Sponsored by: Netflix
fs_summary_info structure. This change was originally done
by the CheriBSD project as they need larger pointers that
do not fit in the existing superblock.
This cleanup of the superblock eases the task of the commit
that immediately follows this one.
Suggested by: brooks
Reviewed by: kib
PR: 246983
Sponsored by: Netflix
This chip is used in the Rasperry Pi 4, and is supported by the if_genet
driver. Currently we use the ukphy mii driver, this patch switches over
to the brgphy mii driver instead. To support the rgmii-rxid phy mode,
which is now the default in the Linux dtb, we add support for clock
skewing.
These changes are taken from OpenBSD and NetBSD, except for the bailout
in brgphy_bcm54xx_clock_delay() in rgmii mode, which was found necessary
after testing.
Submitted by: Robert Crowston, crowston at protomail.com
Differential Revision: https://reviews.freebsd.org/D25251
hw.bus.info was added in r68522 as a node, but there was never anything
connected "behind" it. Its only purpose is to return a struct u_businfo.
The only in-base consumer are devinfo(3)/devinfo(8).
Rewrite the handler as SYSCTL_PROC and mark it as MPSAFE and read-only
as there never was a writable path.
Reviewed by: kib
Approved by: kib (mentor)
Sponsored by: Mysterious Code Ltd.
Differential Revision: https://reviews.freebsd.org/D25321
If multithreaded non-Linux process execs Linux binary, then non-Linux
threads different from the one that execing are cleared by
single-threading at boundary, and then terminating them in
post_execve(). Since at that time the process is already switched to
linux ABI, linuxolator is involved in the thread clearing on boundary,
but cannot find the emul data.
Handle it by pre-creating emuldata for all threads in the execing process.
Also remove a code in linux_proc_exec() handler that cleared emul data
for other threads when execing from multithreaded Linux process. It is
excessive.
PR: 247020
Reported by: Martin FIlla <freebsd@sysctl.cz>
Reported by: Henrique L. Amorim, Independent Security Researcher
Reported by: Rodrigo Rubira Branco (BSDaemon), Amazon Web Services
Reviewed by: markj
Tested by: trasz
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D25293
[BasicAA] Make BasicAA a cfg pass.
Summary:
Part of the changes in D44564 made BasicAA not CFG only due to it
using PhiAnalysisValues which may have values invalidated. Subsequent
patches (rL340613) appear to have addressed this limitation.
BasicAA should not be invalidated by non-CFG-altering passes. A
concrete example is MemCpyOpt which preserves CFG, but we are testing
it invalidates BasicAA.
llvm-dev RFC:
https://groups.google.com/forum/#!topic/llvm-dev/eSPXuWnNfzM
Reviewers: john.brawn, sebpop, hfinkel, brzycki
Subscribers: hiraditya, llvm-commits
Tags: #llvm
Differential Revision: https://reviews.llvm.org/D74353
This fixes an issue with clang's -fintegrated-cc1 feature, which could
make it output slightly different assembly code, depending on the way it
was invoked.
In r361755 we attempted to work around it by disabling the integrated
cc1 stage, but it did not solve the root cause for all situations.
Extensive testing and bisecting showed that the above change finally
makes the output deterministic, even if -fintegrated-cc1 is on.
Reported by: Fabian Keil <fk@fabiankeil.de>
PR: 246630
MFC after: 3 days
This is in preparation for enabling a loadable SCTP stack. Analogous to
IPSEC/IPSEC_SUPPORT, the SCTP_SUPPORT kernel option must be configured
in order to support a loadable SCTP implementation.
Discussed with: tuexen
MFC after: 2 weeks
Sponsored by: The FreeBSD Foundation
Instead of panic after one second of polling, make the normal timeout
handler to activate, reset the controller and abort the outstanding
requests. If all of it won't happen within 10 seconds then something
in the driver is likely stuck bad and panic is the only way out.
In particular this fixed device hot unplug during execution of those
polled commands, allowing clean device detach instead of panic.
MFC after: 1 week
Sponsored by: iXsystems, Inc.
Add EXAMPLES covering -d, -n and -p
Include small explanation about the size of the chunks for the -n option
Approved by: 0mp
Differential Revision: https://reviews.freebsd.org/D25198
- Mention option's arguments in the list of options (so that now we mention
"-N system" instead of just "-N").
- Stylize signals and other constants like O_APPEND with Dv.
- Sort options.
- Change indentation width for readability.
- Fix a couple of typos.
- Sort symbols list.
- Use Sy instead of Cm for symbols. They are not command modifiers.
- Use Ex -std in the EXIT STATUS section for consistency with other manual
pages.
- Use Ql instead of Dq Li for inline code examples as Li has recently been
deprecated by mdoc.
Reviewed by: bcr
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D25332
- Update synopsis to present all available arguments.
- Consistently call the argument specifying an arbitrary directory a
"directory".
- Do not put macros into -width argument to Bl. They do not expand there.
- Stylize command modifiers like "daily" with Cm instead of Pa. While
technically periodic(8) operates on directories with such names, it is
confusing from the perspective of the manual page reader as Pa and Ar are
stylized the same way. Also, I cannot recall a single manual page where
Pa would be used to describe the syntax of command-line arguments.
MFC after: 2 weeks
* Add pretty small EXAMPLES section
* While here, fix a warning in line 98 (new sentence in new line)
Approved by: bcr@
Differential Revision: https://reviews.freebsd.org/D25205
It is plausible that the hardware interrupts a host only when GIS goes
from zero to one. GIS is formed by OR-ing multiple hardware statuses,
so it's possible that a previously cleared status gets set again while
another status has not been cleared yet. Thus, there will be no new
interrupt as GIS always stayed set. If we don't re-examine GIS then we
can leave it set and never get another interrupt again.
Without this change I frequently saw a problem where snd_hda would stop
working. Setting dev.hdac.1.polling=1 would bring it back to life and
afterwards I could set polling back to zero. Sometimes the problem
started right after a boot, sometimes it happened after resuming from
S3, frequently it would occur when sound output and input are active
concurrently (such as during conferencing). I looked at HDAC_INTSTS
while the sound was not working and I saw that both HDAC_INTSTS_GIS and
HDAC_INTSTS_CIS were set, but there were no interrupts.
I have collected some statistics over a period of several days about how
many loops (calls to hdac_one_intr) the new code did for a single
interrupt:
+--------+--------------+
|Loops |Times Happened|
+--------+--------------+
|0 |301 |
|1 |12857746 |
|2 |280 |
|3 |2 |
|4+ |0 |
+--------+--------------+
I believe that previously the sound would get stuck each time we had to loop
more than once.
The tested hardware is:
hdac1: <AMD (0x15e3) HDA Controller> mem 0xfe680000-0xfe687fff at device 0.6 on pci4
hdacc1: <Realtek ALC269 HDA CODEC> at cad 0 on hdac1
No objections: mav
MFC after: 5 weeks
Differential Revision: https://reviews.freebsd.org/D25128
module from that file into ffs_vfsops.c. This fixes the build for kernel
configs that don't include FFS.
PR: 247256
Submitted by: glebius
Reviewed by: mckusick (earlier version)
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D25285
- Sort options in the list & indent for readability.
- Pet linters
- Use "\(em" instead of "--"
- Remove Tn macros
- Use Ql instead of Dq Li
- Add arguments to the -M, -N, -p, and -u options in their descriptions.
- Use Sy instead of Li for field names. Li is deprecated, and Ql makes no
sense here.
- Replace a literal block with a list for the table of special names
related to FD.
- Use Ql instead of ``X''.
- Add a dot after etc.
- Reference fuser(1).
MFC after: 1 week
one place where we now need to multiply the size of the struct with the
number of entries. This lead to problems when restarting user space
daemons, as the cleanup was never properly done, resulting in MRT_ADD_VIF
EADDRINUSE.
Properly zero all array elements to avoid this problem.
PR: 246629, 206583
Reported by: (many)
MFC after: 4 days
Sponsored by: Rubicon Communications, LLC (d/b/a "Netgate")
we'll panic on an assertion.
While here, leave a comment that the ifp was never protected and stable
(as glebius pointed out) and this needs to be fixed properly.
Discovered while working on: PR 246629
Reviewed by: glebius
MFC after: 4 days
Sponsored by: Rubicon Communications, LLC (d/b/a "Netgate")
- Support Prefetchable Memory.
- Use the correct rman when allocating memory and ioports.
- Translate PCI addresses in bus_alloc_resource to allow physical
addresses that are different than pci addresses.
Reviewed by: Robert Crowston <crowston_protonmail.com>
Sponsored by: Innovate UK
Differential Revision: https://reviews.freebsd.org/D25121
These macro definitions are no longer needed as the NFS OSX port is long
dead. The vfs_statfs macro conflicts with the vfsops field of the same
name.
Submitted by: shivank@
Reviewed by: rmacklem
MFC after: 2 weeks
Sponsored by: Google, Inc. (GSoC 2020)
Differential Revision: https://reviews.freebsd.org/D25263
o Parse the ACPI DSD (Device Specific Data) graph property and record
device connections.
o Split-out FDT support to a separate file.
o Get the corresponding (FDT/ACPI) Coresight platform data in
the device drivers.
Sponsored by: DARPA, AFRL
Add a header definition for DCCP as defined in RFC4340. This header definition
is required to perform validation when receiving and forwarding DCCP packets.
We do not currently support DCCP.
Reviewed by: gallatin, bz
Approved by: bz (co-mentor)
MFC after: 1 week
MFC with: 350749
Differential Revision: https://reviews.freebsd.org/D21179
Changes in the mbuf layout regarding HW TLS, resulted in wrong detection
of starting mbuf. Use a boolean variable to handle this and pass m_adj()
the top mbuf, so that the packet header is adjusted correctly.
MFC after: 1 week
Sponsored by: Mellanox Technologies
Make sure we disable the multicast filter in promiscious mode aswell as when
the all multicast flag is set.
MFC after: 1 week
Found by: Tycho Nightingale <tychon@freebsd.org>
Sponsored by: Mellanox Technologies
Inject \e[J to erase the initial loader screen. We have two options,
find where out cursor is and use BIOS scroll for data from boot2 or erase the
display and start from origin. Erasing the screen is easier and we also
get the screen buffer initialized.
Sponsored by: Netflix, Klara Inc.
