Instead just use num_io_queues to make this determination.
This prepares for some future changes enabling use of multiple
queues when we do not have enough queues or MSI-X vectors
for one queue per CPU.
MFC after: 3 days
Sponsored by: Intel
This significantly improves parallelism in the most common case.
The taskqueue is still used whenever BIO_ORDERED bios are in flight.
This patch is based heavily on a patch from gallatin@.
MFC after: 3 days
Sponsored by: Intel
This ensures the bio flags are not read after biodone().
The ordering will still be enforced, after the bio is
submitted successfully.
MFC after: 3 days
Sponsored by: Intel
Still wait until all in-flight bios (including the ordered bio)
complete before processing more bios from the queue.
MFC after: 3 days
Sponsored by: Intel
and t_maxseg. This dualism emerged with T/TCP, but was not properly cleaned
up after T/TCP removal. After all permutations over the years the result is
that t_maxopd stores a minimum of peer offered MSS and MTU reduced by minimum
protocol header. And t_maxseg stores (t_maxopd - TCPOLEN_TSTAMP_APPA) if
timestamps are in action, or is equal to t_maxopd otherwise. That's a very
rough estimate of MSS reduced by options length. Throughout the code it
was used in places, where preciseness was not important, like cwnd or
ssthresh calculations.
With this change:
- t_maxopd goes away.
- t_maxseg now stores MSS not adjusted by options.
- new function tcp_maxseg() is provided, that calculates MSS reduced by
options length. The functions gives a better estimate, since it takes
into account SACK state as well.
Reviewed by: jtl
Differential Revision: https://reviews.freebsd.org/D3593
This optimization is not proper (and causes kernel panic),
since driver checks fw_status to optimize away parsing stage
if it was already done.
Reported by: dchagin
It was returning a pointer to stack-allocated memory, so make the
allocation at the caller instead.
Found by: clang static analyzer
Coverity: CID 1245774
Reviewed by: ed, rpaulo
Review URL: https://reviews.freebsd.org/D4740
The fd is closed later in this case. This fixes a "SS_NOFDREF on enter"
panic.
Submitted by: Krishnamraju Eraparaju @ Chelsio
Reviewed by: Steve Wise @ Open Grid Computing
- Separate 'firmware_put(sc->fw_fp, FIRMWARE_UNLOAD); sc->fw_fp = NULL;'
into iwn_unload_firmware().
- Move error handling to the end of iwn_read_firmware().
No functional changes.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D4768
iwn(4) / wpi(4) works in the same way
(read_firmware() -> hw_init() -> firmware_put())
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D4766
- Simplify defragmentation code.
- Use proper number of dma segments for data.
Approved by: adrian (mentor)
Obtained from: DragonFlyBSD (mostly)
Differential Revision: https://reviews.freebsd.org/D4754
stable/10 doesn't have the if_getdrvflags(9) KPI. Reference the field in the
structure directly if the __FreeBSD_version is < 1100022, so the driver can
be built with PCI_IOV support on stable/10, without backporting all of
r266974 (which requires additional changes due to projects/ifnet, etc)
Differential Revision: https://reviews.freebsd.org/D4759
Reviewed by: erj, sbruno
Sponsored by: EMC / Isilon Storage Division
These are going to be much more efficient on low end embedded systems
but unfortunately they make it .. less convenient to implement correct
bus barriers and debugging. They also didn't implement the register
serialisation workaround required for Owl (AR5416.)
So, just remove them for now. Later on I'll just inline the routines
from ah_osdep.c.
- Change order of data in if_iwmvar.h
(like it is in other drivers: defines, data structures,
vap/node structures, softc struct and locks); use indentation.
- Fix IWM_LOCK(_sc) / IWM_UNLOCK(_sc) macro.
- Add IWM_LOCK_INIT / DESTROY(sc) + fix mtx_init() usage.
- Wrap iwm_node casts into IWM_NODE() macro.
- Drop some fields:
* wt_hwqueue from Tx radiotap header;
* macaddr[6] from iwm_vap;
Approved by: adrian
Differential Revision: https://reviews.freebsd.org/D4753
tree parsing opt-out rather than opt-in. All FDT-based systems as well as
PowerPC systems with real Open Firmware use the CHRP-derived binding that
includes it, which makes SPARC the odd man out here. Making it opt-out
avoids astonishment on new platform bring up.
The ath hal and driver code all assume the world is an x86 or the
bus layer does an explicit bus flush after each operation (eg netbsd.)
However, we don't do that.
So, to be "correct" on platforms like sparc64, mips and ppc (and maybe
ARM, I am not sure), just do explicit barriers after each operation.
Now, this does slow things down a tad on embedded platforms but I'd
rather things be "correct" versus "fast." At some later point if someone
wishes it to be fast then we should add the barrier calls to the HAL and
driver.
Tested:
* carambola 2 (AR9331.)
rounding) has better spread. Implement fp16_sin() to go along with
fp16_cos(). In the rendering loop, switch from addition to subtraction
so the center of the pattern will be a trough rather than a peak. This
is completely arbitrary, of course, but looks better to me.
This is a port from openbsd. It's incomplete and unstable, but it's better
than nothing. I have no plans to MFC this until it's complete and stable.
Submitted by: kevlo
Add if_requestencap() interface method which is capable of calculating
various link headers for given interface. Right now there is support
for INET/INET6/ARP llheader calculation (IFENCAP_LL type request).
Other types are planned to support more complex calculation
(L2 multipath lagg nexthops, tunnel encap nexthops, etc..).
Reshape 'struct route' to be able to pass additional data (with is length)
to prepend to mbuf.
These two changes permits routing code to pass pre-calculated nexthop data
(like L2 header for route w/gateway) down to the stack eliminating the
need for other lookups. It also brings us closer to more complex scenarios
like transparently handling MPLS nexthops and tunnel interfaces.
Last, but not least, it removes layering violation introduced by flowtable
code (ro_lle) and simplifies handling of existing if_output consumers.
ARP/ND changes:
Make arp/ndp stack pre-calculate link header upon installing/updating lle
record. Interface link address change are handled by re-calculating
headers for all lles based on if_lladdr event. After these changes,
arpresolve()/nd6_resolve() returns full pre-calculated header for
supported interfaces thus simplifying if_output().
Move these lookups to separate ether_resolve_addr() function which ether
returs error or fully-prepared link header. Add <arp|nd6_>resolve_addr()
compat versions to return link addresses instead of pre-calculated data.
BPF changes:
Raw bpf writes occupied _two_ cases: AF_UNSPEC and pseudo_AF_HDRCMPLT.
Despite the naming, both of there have ther header "complete". The only
difference is that interface source mac has to be filled by OS for
AF_UNSPEC (controlled via BIOCGHDRCMPLT). This logic has to stay inside
BPF and not pollute if_output() routines. Convert BPF to pass prepend data
via new 'struct route' mechanism. Note that it does not change
non-optimized if_output(): ro_prepend handling is purely optional.
Side note: hackish pseudo_AF_HDRCMPLT is supported for ethernet and FDDI.
It is not needed for ethernet anymore. The only remaining FDDI user is
dev/pdq mostly untouched since 2007. FDDI support was eliminated from
OpenBSD in 2013 (sys/net/if_fddisubr.c rev 1.65).
Flowtable changes:
Flowtable violates layering by saving (and not correctly managing)
rtes/lles. Instead of passing lle pointer, pass pointer to pre-calculated
header data from that lle.
Differential Revision: https://reviews.freebsd.org/D4102
We'll remove the per-channel control_work_queue because it can't properly
do serialization of message handling, e.g., when there are 2 NIC devices,
vmbus_channel_on_offer() -> hv_queue_work_item() has a race condition:
for an SMP VM, vmbus_channel_process_offer() can run concurrently on
different CPUs and if the second NIC's
vmbus_channel_process_offer() -> hv_vmbus_child_device_register() runs
first, the second NIC's name will be hn0 and the first NIC's name will
be hn1!
We can fix the race condition by removing the per-channel control_work_queue
and run all the message handlers in the global
hv_vmbus_g_connection.work_queue -- we'll do this in the next patch.
With the coming next patch, we have to run the non-blocking handlers
directly in the kernel thread vmbus_msg_swintr(), because the special
handling of sub-channel: when a sub-channel (e.g., of the storvsc driver)
is received and being handled in vmbus_channel_on_offer() running on the
global hv_vmbus_g_connection.work_queue, vmbus_channel_process_offer()
invokes channel->sc_creation_callback, i.e., storvsc_handle_sc_creation,
and the callback will invoke hv_vmbus_channel_open() -> hv_vmbus_post_message
and expect a further reply from the host, but the handling of the further
messag can't be done because the current message's handling hasn't finished
yet; as result, hv_vmbus_channel_open() -> sema_timedwait() will time out
and th device can't work.
Also renamed the handler type from hv_pfn_channel_msg_handler to
vmbus_msg_handler: the 'pfn' and 'channel' in the old name make no sense.
Submitted by: Dexuan Cui <decui microsoft com>
Reviewed by: royger
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D4596
Now vmbus_channel_on_offer() -> vmbus_channel_process_offer() can
safely run on the global hv_vmbus_g_connection.work_queue now.
We remove the per-channel control_work_queue to achieve the proper
serialization of the message handling.
I removed the bogus TODO in vmbus_channel_on_offer(): a vmbus offer
can only come from the parent partition, i.e., the host.
PR: kern/205156
Submitted by: Dexuan Cui <decui microsoft com>
Reviewed by: Howard Su <howard0su gmail com>, delphij
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D4597
coalescing and zipping multiple CQEs into a single merged CQE. The
feature is enabled by default and can be disabled by a sysctl.
Implementing this feature mlx5_cqwq_pop() has been separated from
mlx5e_get_cqe().
MFC after: 1 week
Submitted by: Mark Bloch <markb@mellanox.com>
Differential Revision: https://reviews.freebsd.org/D4598
Sponsored by: Mellanox Technologies
cperciva's libmd implementation is 5-30% faster
The same was done for SHA256 previously in r263218
cperciva's implementation was lacking SHA-384 which I implemented, validated against OpenSSL and the NIST documentation
Extend sbin/md5 to create sha384(1)
Chase dependancies on sys/crypto/sha2/sha2.{c,h} and replace them with sha512{c.c,.h}
Reviewed by: cperciva, des, delphij
Approved by: secteam, bapt (mentor)
MFC after: 2 weeks
Sponsored by: ScaleEngine Inc.
Differential Revision: https://reviews.freebsd.org/D3929
This space does not require DMA syncing. It reduces lock scope of the DMA
scratch space. It allows whole DMA scratch space to be used to I/O, so now
we can fetch up to ~1000 ports from SNS.
Due to the last fact, increase maximal number of ports from 256 to 1024.
