lost when the buggy code goes away completely:
- don't assume that the npx irq number is >= 8. Rev.1.73 only reversed
part of the hard-coding of it to 13 in rev.1.66.
- backed out the part of rev.1.84 that added a highly confused comment
about an enable_intr() being "highly bogus". The whole reason for
existence of npxprobe() (separate from the main probe, npxprobe1())
is to handle the complications to make this enable_intr() safe.
- backed out the part of rev.1.94 that modified npxprobe(). It mainly
broke the enable_intr() to restore_intr(). Restoring the interrupt
state in a nested way is precisely what is not wanted here. It was
harmless in practice because npxprobe() is called with interrupts
enabled, so restoring the interrupt state enables interrupts. Most
of npxprobe() is a no-op for the same reason...
argument names match those on Alpha.
o Map the fchown directly to FreeBSD. Since the old version of
fchown is also mapped to the native fchown, give the new one
type NODEF.
Tested by: Martin Blapp <mb@imp.ch>
to work, but haven't really due to subtle differences in structs etc.
This is still not perfect (some ioctls are still known not to work, while
others haven't been tested at all), but it's enough to get Debian's ifconfig
to produce relatively sane output.
More work will be needed to get all ioctls (or at least a reasonable subset)
working, and to support the Cisco Aironet config tool mentioned in the PR.
PR: 26546
Submitted by: Doug Ambrisko <ambrisko@ambrisko.com>
Firmware.
- Add a temporary disklabel header to boot off a NetBSD/sparc64
partition. This file can be deleted when we have got a FCode
bootblock.
The disklabel header was obtained from NetBSD.
- Use unsigned types for the (32-bit) Open Firmware device handles
to avoid sign extension on 64-bit architectures.
- Add a standard type definition for Open Firmware arguments.
What the heck, the OpenBSD version will benefit.
1. Add wx_txint_delay as a tunable (defaults to 5000 now, or ~5ms) and switch
to using delayed TXDW interrupts. Since the chip continues to reload the
TIDV with this value for each descriptor written back, this allows continued
deferral of the actual interrupt until the last packet completes (assuming
that 5ms between multiple packets transmitting is reasonable).
2. Add two other SYSCTL entities:
hw.wx.dump_stats
hw.wx.clear_stats
to be used, hackey hackey, to get the watchdog routine to dump/clear
the current softc statistics.
Usage would be:
sysctl -w hw.wx.dump_stats=UNIT
to cause the current stats to be dumped for UNIT.
3. Attempt to clean up wx_detach routine so we don't panic. Well, things
still panic, but given that the code is just like other NIC drivers,
I suspect it's actually something elsewhere, like e1000phy, that's actually
blowing up.
4. Skip the entire test for runt packets- after doing somet thinking
and experimenting, I believe that the chip only doesn't like it if
the whole frame to xmit is < 16 bytes- each TFD can be some fragment
of that. This should improve performance a chunk because of all of the
(14 byte ETHERHEADER + DATA) mbuf chains.
5. Keep track of total frame length. Try not to xmit an odd byte frame-
this is supposed to get around some dumb Cisco switch problems.
6. On the last packet, also set Interrupt Delay && Report Packet Sent
(see #1 above)
7. Attempt to do xmit garbage collection *first* in order to avoid setting
IFF_OACTIVE if at all possible.
MFC after: 1 week
+ Remove 'sleep' (not sure why it is so important in fix-it mode).
+ Remove ability to mount MSDOSFS as that is not a typical filesystem on an
alpha; and thus does not really add to the fix-it mix.
+ Sync style with i386.
