Currently, the trap code switches to the the temporary stack in the dbtrap
section. It works in most cases, but in the beginning of the execution, the
temp stack is being used, as starting in the powerpc_init() code.
In this current scenario, the stack is being overwritten, which causes the
return of breakpoint() to take abnormal execution.
This current patchset create a small stack to use by the dbtrap: codepath
avoiding the corruption of the temporary stack.
PR: 224872
Submitted by: breno.leitao_gmail.com
Reviewed by: jhibbits
Differential Revision: https://reviews.freebsd.org/D14484
With r319610, sesutil started twiddling the bits of every SES device.
Not everything is a disk slot, there are also fan controllers, temperature
sensors, even power supplies, among other things controlled by SES.
Add a type check to make sure we are only operating on device slot and array
device slot elements. Other type elements will be skipped, but it would be
simple to add additional cases for controlling the ident LEDs of other
element types (which are not necessarily the same bits).
Rather than doing raw bit manipulation of an unstructured byte array using
unnamed numeric constants, leverage existing code abstractions.
Submitted by: Ryan Moeller <ryan@freqlabs.com>
MFC after: 1 week
Sponsored by: iXsystems, Inc.
Differential Revision: https://reviews.freebsd.org/D19052
Otherwise the lock might recurse in faultin() if the process is
swapped out.
Reported by: zeising
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
On CPUs supporting cmpxchg8b, fetch is performed by cmpxchg8b on
corresponding CPU slot, which unconditionally write to the slot. If
for that slot, the owner CPU increments it, then both CPUs might run
the cmpxchg8b instruction concurrently and this might race and
override the incremental write. So the counter update would be lost.
Fix it by implementing fetch as IPI and accumulation of result. It is
acceptable for rare counter64 fetch operation to be more expensive.
Diagnosed and tested by: Andreas Longwitz <longwitz@incore.de>
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
This is a step towards being able to free pages without the page
lock held. The approach is simply to add an implementation of
vm_page_dequeue_deferred() which does not assert that the page
lock is held. Formally, the page lock is required to set
PGA_DEQUEUE, but in the case of vm_page_free_prep() we get the
same mutual exclusion for free by virtue of the fact that no
other references to the page may exist.
No functional change intended.
Reviewed by: kib (previous version)
MFC after: 2 weeks
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D19065
To detect the case where the page is already marked for a deferred
dequeue, we must read the "queue" and "aflags" fields in a
precise order. Otherwise, a race with a concurrent
vm_page_dequeue_complete() could leave the page with PGA_DEQUEUE
set despite it already having been dequeued. Fix the problem by
using vm_page_queue() to check the queue state, which correctly
handles the race.
Reviewed by: kib
Tested by: pho
MFC after: 3 days
Sponsored by: Netflix
Differential Revision: https://reviews.freebsd.org/D19039
This allows userspace to trace the kernel using the coverage sanitizer
found in clang. It will also allow other coverage tools to be built as
modules and attach into the same framework.
Sponsored by: DARPA, AFRL
never get here, however a test for SOLARIS, as redundant as this test is,
serves to document that this is the illumos definition. This should help
those who come after me to follow the code more easily.
MFC after: 1 month
build directory, especially those for other operating systems.
The kernel module shims for other operating systems are hereby removed.
The kernel module shim for FreeBSD, mlfk_ipl.c, is already in
sys/contrib/ipfilter/netinet. The one here is never used and should
not be in the userland build directory either.
mlfk_rule.c isn't used either however we will keep it in case someone
wishes to use this shim to load rules via a kernel module, handy for
embedded. In that case it should be copied to
sys/contrib/ipfilter/netinet and a Makefile created to employ it.
(Probably a useful documentation project when time permits.)
MFC after: 1 month
Remove #ifdefs for ancient and irrelevant operating systems from
ipfilter.
When ipfilter was written the UNIX and UNIX-like systems in use
were diverse and plentiful. IRIX, Tru64 (OSF/1) don't exist any
more. OpenBSD removed ipfilter shortly after the first time the
ipfilter license terms changed in the early 2000's. ipfilter on AIX,
HP/UX, and Linux never really caught on. Removal of code for operating
systems that ipfilter will never run on again will simplify the code
making it easier to fix bugs, complete partially implemented features,
and extend ipfilter.
Unsupported previous version FreeBSD code and some older NetBSD code
has also been removed.
What remains is supported FreeBSD, NetBSD, and illumos. FreeBSD and
NetBSD have collaborated exchanging patches, while illumos has expressed
willingness to have their ipfilter updated to 5.1.2, provided their
zone-specific updates to their ipfilter are merged (which are of interest
to FreeBSD to allow control of ipfilters in jails from the global zone).
Reviewed by: glebius@
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D19006
That should shorten 'ifconfig <wlan> list txparam' output since
unsupported modes will not be shown.
Checked with RTL8188EE, STA mode.
MFC after: 2 weeks
For 11n / 11ac we are still using non-11n rates for management and
multicast traffic by default; check 'MCS rate' bit to determine how
to print them correctly.
PR: 161035
MFC after: 1 week
Do not try to clear 'basic rate' bit from roamRate; it cannot be here and,
actually, this operation clears 'MCS rate' bit instead, breaking comparison
for 11n / 11ac modes.
Tested with RTL8188CUS, HOSTAP mode + RTL8821AU, STA mode.
MFC after: 3 days
ifconfig(8) prints per-mode parameters if they are non-zero; since
we have 13 possible modes with 3...5 typically supported this change
should greatly reduce amount of information for 'ifconfig <wlan> list roam'
command.
While here ensure that sta_roam_check() will not use roaming parameters
for unsupported modes (it should not).
This change effectively reverts r188776.
MFC after: 2 weeks
Add SYNC_KLOOP_MODE option, and add support for direct mode, where application
executes the TXSYNC and RXSYNC in the context of the ioeventfd wake up callback.
MFC after: 5 days
When in MSI mode, the device was only being configured with one
interrupt index, but it needs two - one for the actual interrupt and
one to park the tx queue at.
Also clarified comments relating to interrupt index assignment.
Reported by: Yuri Pankov <yuripv@yuripv.net>
MFC after: 1 day
The XIVE (External Interrupt Virtualization Engine) is a new interrupt
controller present in IBM's POWER9 processor. It's a very powerful,
very complex device using queues and shared memory to improve interrupt
dispatch performance in a virtualized environment.
This yields a ~10% performance improvment over the XICS emulation mode,
measured in both buildworld, and 'dd' from nvme to /dev/null.
Currently, this only supports native access.
MFC after: 1 month
512GB of ZFS ABD ARC means abd_chunk zone of 128M 4KB items. To manage
them UMA tries to allocate 2GB hash table, which size does not fit into
the int variable, causing later allocation failure, which makes ARC shrink
back below the 512GB, not letting it to use more RAM. With this change I
easily reached >700GB ARC size on 768GB RAM machine.
MFC after: 1 week
Sponsored by: iXsystems, Inc.
With the current 24G memory limit for GENERIC, the boot time test
causes quite visible delay, amplified by the default
debug.late_console = 0.
The comment text is copied from the same setting explanation for
amd64.
Suggested by: bde
Discussed with: emaste
Sponsored by: The FreeBSD Foundation
MFC after: 2 months
CPU and buses can manage up to the limit reported by cpu_maxphyaddr,
so set mem_rman to the value returned by cpu_getmaxphyaddr(). For the
PAE mode, it was missed both when rman_res_t was increased to
uintmax_t, and from the PAE merge commit.
When importing smaps or dump_avail chunks into memory rman, do not
blindly ignore resources which ends above the limit, chomp them
instead if start is below the limit. The same change was already done
to i386 add_physmap_entry().
Based on the submission by: bde
MFC after: 2 months
"slow" interrupt handler:
- Expand the list of INT_CAUSE registers known to the driver.
- Add decode information for many more bits but decouple it from the
rest of intr_info so that it is entirely optional.
- Call t4_fatal_err exactly once, and from the top level PL intr handler.
t4_fatal_err:
- Use t4_shutdown_adapter from the common code to stop the adapter.
- Stop servicing slow interrupts after the first fatal one.
Driver/firmware interaction:
- CH_DUMP_MBOX: note whether the mailbox being dumped is a command or a
reply or something else.
- Log the raw value of pcie_fw for some errors.
- Use correct log levels (debug vs. error).
Sponsored by: Chelsio Communications
Fewer lines of code and more maintainable.
Reviewed by: brooks, kib
MFC after: 1 week
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D19053
kbd(4) (but only documented in atkbd(4)) maintains a table of strings
for 96 function keys. Using teken broke this 9+ years ago for the
most usable first 12 function keys and for 10 cursor keys, by supplying
its own non-programmable strings so that the keyboard driver's strings
are not used.
Fix this by supplying NULL in the teken layer for syscons in cons25 mode
so that the the strings are found in the kbd(4) layer.
vt needs more changes to use kbd(4)'s tables. Teken's cons25 table is
still needed to supply nonempty strings for vt in cons25 mode.
Keep using teken's xterm tables for both syscons and vt in xterm mode.
Function keys should at least default to xterm values in xterm mode,
and kbd(4) doesn't support this.
teken_set_cons25() sets a sticky flag to ask for the fix, and space is
reserved for another new flag. vt should set this flag when it uses
kbd(4)'s tables.
PR: 226553 (for vt)
consistently.
This inconsistency was observed when working on the bug reported in
PR 235256, although it does not fix the reported issue. The fix for
the PR will be a separate commit.
PR: 235256
Reviewed by: rrs@, Richard Scheffenegger
MFC after: 3 days
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D19033
