Adrian Chadd 2942e03f5c Update the hardware LED blinking code to do something useful rather than ... relying on what the register defaults are. This forces the blink mode to be proportional to the TX and RX frames which match the RX filter. This (along with a few tweaks to if_ath_led.c to configure the correct GPIO pins) allows my DWA-552 AR5416 NIC to blink the LEDs in a useful fashion, however those LEDs are marked "Link" and "Act(ivity)", which don't really map well to the "power" / "network" LED interface which the MAC provides. Some further tinkering is needed to see what other useful operating modes are possible.		2011-12-26 06:07:21 +00:00
..
ar2133.c	Add the 11n chipset RF frontends to the linker set, even though they're not	2011-12-15 00:59:11 +00:00
ar5416_ani.c	Disable writing to the extension CYCPWR1 register.	2011-11-12 16:47:23 +00:00
ar5416_attach.c	Use the correct RF version probe routine.	2011-12-15 00:54:11 +00:00
ar5416_beacon.c	The AR5212 setup path (also used by the AR5416 code) configures a	2011-09-28 03:03:23 +00:00
ar5416_cal_adcdc.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_adcgain.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_cal_iq.c	Fix the calibration logic to correctly clamp the calculated coefficient.	2010-08-14 15:28:15 +00:00
ar5416_cal.c	Bump this up to where it used to be.	2011-11-09 23:28:47 +00:00
ar5416_cal.h	Introduce methods for the initial calibration and the new PA calibration	2011-03-11 11:35:36 +00:00
ar5416_eeprom.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_gpio.c	Port over some more GPIO fixes from the atheros reference HAL.	2011-12-23 08:53:22 +00:00
ar5416_interrupts.c	Fix the KTR option to compile by default - it was referencing	2011-11-08 22:50:28 +00:00
ar5416_keycache.c	Replace Id keyword with the FreeBSD keyword.	2010-01-29 10:07:17 +00:00
ar5416_misc.c	Update the hardware LED blinking code to do something useful rather than	2011-12-26 06:07:21 +00:00
ar5416_phy.c	Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,	2011-02-21 05:10:34 +00:00
ar5416_power.c	Fixes from Atheros:	2011-05-12 03:15:21 +00:00
ar5416_recv.c	Remove an unused variable.	2011-10-02 14:10:25 +00:00
ar5416_reset.c	Add some (totally untested!) code to correctly set the RF half/quarter	2011-11-19 21:12:35 +00:00
ar5416_xmit.c	Add some fixes to the 11n aggregation HAL calls:	2011-10-25 23:24:05 +00:00
ar5416.h	Port over a new routine which grabs the percentage of time spent in TX frame, RX frame,	2011-11-09 05:25:30 +00:00
ar5416.ini	Fix the addac serial load register write for AR5416.	2011-09-06 10:49:05 +00:00
ar5416desc.h	Add some 11n bits from the if_ath_tx 11n branch:	2011-10-25 23:09:07 +00:00
ar5416phy.h	Disable writing to the extension CYCPWR1 register.	2011-11-12 16:47:23 +00:00
ar5416reg.h	Port over some GPIO and LED fixes.	2011-12-23 08:32:53 +00:00