Adrian Chadd 7b1144d245 Break out the radar code into a separate source file. ...

This mirrors the internal HAL organisation and reduces the differences
between the HAL codebases slightly.

Obtained from:	Atheros

2012-02-20 03:07:07 +00:00

..

ar2133.c

Add the 11n chipset RF frontends to the linker set, even though they're not

2011-12-15 00:59:11 +00:00

ar5416_ani.c

Disable writing to the extension CYCPWR1 register.

2011-11-12 16:47:23 +00:00

ar5416_attach.c

Extend the HAL code to allow the RX and TX chainmask to be overridden

2012-02-10 09:58:20 +00:00

ar5416_beacon.c

The AR5212 setup path (also used by the AR5416 code) configures a

2011-09-28 03:03:23 +00:00

ar5416_cal_adcdc.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_cal_adcgain.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_cal_iq.c

Fix the calibration logic to correctly clamp the calculated coefficient.

2010-08-14 15:28:15 +00:00

ar5416_cal.c

Bump this up to where it used to be.

2011-11-09 23:28:47 +00:00

ar5416_cal.h

Introduce methods for the initial calibration and the new PA calibration

2011-03-11 11:35:36 +00:00

ar5416_eeprom.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_gpio.c

Port over some more GPIO fixes from the atheros reference HAL.

2011-12-23 08:53:22 +00:00

ar5416_interrupts.c

Fix the KTR option to compile by default - it was referencing

2011-11-08 22:50:28 +00:00

ar5416_keycache.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_misc.c

Break out the radar code into a separate source file.

2012-02-20 03:07:07 +00:00

ar5416_phy.c

Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,

2011-02-21 05:10:34 +00:00

ar5416_power.c

Fixes from Atheros:

2011-05-12 03:15:21 +00:00

ar5416_radar.c

Break out the radar code into a separate source file.

2012-02-20 03:07:07 +00:00

ar5416_recv.c

Remove an unused variable.

2011-10-02 14:10:25 +00:00

ar5416_reset.c

Add some (totally untested!) code to correctly set the RF half/quarter

2011-11-19 21:12:35 +00:00

ar5416_xmit.c

Add some fixes to the 11n aggregation HAL calls:

2011-10-25 23:24:05 +00:00

ar5416.h

Break out the radar code into a separate source file.

2012-02-20 03:07:07 +00:00

ar5416.ini

Fix the addac serial load register write for AR5416.

2011-09-06 10:49:05 +00:00

ar5416desc.h

Add some 11n bits from the if_ath_tx 11n branch:

2011-10-25 23:09:07 +00:00

ar5416phy.h

Disable writing to the extension CYCPWR1 register.

2011-11-12 16:47:23 +00:00

ar5416reg.h

Port over some GPIO and LED fixes.

2011-12-23 08:32:53 +00:00