| .. |
|
ar2133.c
|
Implement the quarter rate fractional channel programming for the
|
2012-10-04 15:42:45 +00:00 |
|
ar5416_ani.c
|
Track the last ANI TX/RX sample correctly.
|
2012-09-27 06:05:54 +00:00 |
|
ar5416_attach.c
|
add a method to set/clear the VMF field in the TX descriptor.
|
2013-03-04 07:40:49 +00:00 |
|
ar5416_beacon.c
|
The AR5212 setup path (also used by the AR5416 code) configures a
|
2011-09-28 03:03:23 +00:00 |
|
ar5416_btcoex.c
|
Methodise the BT diversity configuration function; so the AR9285
|
2012-12-04 00:02:46 +00:00 |
|
ar5416_btcoex.h
|
Remove duplicate entries.
|
2012-06-27 03:00:29 +00:00 |
|
ar5416_cal_adcdc.c
|
|
|
|
ar5416_cal_adcgain.c
|
|
|
|
ar5416_cal_iq.c
|
Fix the calibration logic to correctly clamp the calculated coefficient.
|
2010-08-14 15:28:15 +00:00 |
|
ar5416_cal.c
|
Bump this up to where it used to be.
|
2011-11-09 23:28:47 +00:00 |
|
ar5416_cal.h
|
Introduce methods for the initial calibration and the new PA calibration
|
2011-03-11 11:35:36 +00:00 |
|
ar5416_eeprom.c
|
|
|
|
ar5416_gpio.c
|
Bring over the initial 802.11n bluetooth coexistence support code.
|
2012-06-26 22:16:53 +00:00 |
|
ar5416_interrupts.c
|
If any of the TX queues have underrun reporting enabled, enable
|
2013-02-20 11:24:11 +00:00 |
|
ar5416_keycache.c
|
|
|
|
ar5416_misc.c
|
Begin adding support to explicitly set the current chainmask.
|
2013-02-25 22:42:43 +00:00 |
|
ar5416_phy.c
|
Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,
|
2011-02-21 05:10:34 +00:00 |
|
ar5416_power.c
|
Both linux ath9k and the reference driver initialises the PLL here
|
2012-04-14 04:40:11 +00:00 |
|
ar5416_radar.c
|
Implement an API to fetch the default DFS parameters for the given chip.
|
2012-08-24 01:29:46 +00:00 |
|
ar5416_recv.c
|
Fix a subtle corner case surrounding the handling of OFDM restart along
|
2012-06-27 05:23:33 +00:00 |
|
ar5416_reset.c
|
Part #2 of the TX chainmask changes:
|
2013-02-25 22:45:02 +00:00 |
|
ar5416_spectral.c
|
Fix the short repeat option code to not flip the option to 0 when
|
2013-01-02 03:56:20 +00:00 |
|
ar5416_xmit.c
|
CABQ calculation changes to try and fix some weird corner cases leading
|
2013-03-23 23:51:11 +00:00 |
|
ar5416.h
|
add a method to set/clear the VMF field in the TX descriptor.
|
2013-03-04 07:40:49 +00:00 |
|
ar5416.ini
|
Fix the addac serial load register write for AR5416.
|
2011-09-06 10:49:05 +00:00 |
|
ar5416desc.h
|
I'm not sure why ah_desc.h was required here, but it doesn't _need_
|
2012-11-16 20:04:45 +00:00 |
|
ar5416phy.h
|
Bring over the basic spectral scan framework code from Qualcomm Atheros.
|
2013-01-02 00:38:01 +00:00 |
|
ar5416reg.h
|
Bring over some AR9271 register definitions from the QCA HAL.
|
2013-04-15 17:58:11 +00:00 |
