Multicast MAC filter flag means device ops set_mc_addr_list support
or not. This patch fixes the wrong flag value in Intel driver's document.
Fixes: 9db3f52126fb ("doc: generate NIC overview table from ini files")
Fixes: cb25d4323fbf ("net/avf: enable MAC VLAN and promisc ops")
Fixes: 26e887343321 ("net/ice: support MAC ops")
Cc: stable@dpdk.org
Signed-off-by: Qiming Yang <qiming.yang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
The goal is to make the table more readable.
Mark as partially supported features that are supported in
the generic Virtio driver but not in the vectorized ones.
Suggested-by: Thomas Monjalon <thomas@monjalon.net>
Signed-off-by: Maxime Coquelin <maxime.coquelin@redhat.com>
Setup NIC to generate MSI-X interrupts.
Set the IVAR register to map interrupt causes to vectors.
Implement interrupt enable/disable functions.
Signed-off-by: Alvin Zhang <alvinx.zhang@intel.com>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
This patch added iavf_flow_create, iavf_flow_destroy,
iavf_flow_flush and iavf_flow_validate support,
these are used to handle all the generic filters.
This patch supported basic L2, L3, L4 and GTPU patterns.
Signed-off-by: Qiming Yang <qiming.yang@intel.com>
Acked-by: Qi Zhang <qi.z.zhang@intel.com>
Add Tx queue ratelimiting support. This support is mutually
exclusive with TM support i.e when TM is configured, tx queue
ratelimiting config is no more valid.
Signed-off-by: Krzysztof Kanas <kkanas@marvell.com>
Signed-off-by: Nithin Dabilpuram <ndabilpuram@marvell.com>
Acked-by: Jerin Jacob <jerinj@marvell.com>
This patch implements rx/tx checksum offload. In case of
wrong checksum received (inner/outer l3/l4) it reports the
corresponding layer which has bad checksum and also corrects
it if hw checksum is enabled on tx side.
Signed-off-by: Harman Kalra <hkalra@marvell.com>
Adding support for setting link up/down eth operation.
It is used to enable disable lmac. Also implemented a
poll function for getting the link status at regular
intervals.
Signed-off-by: Harman Kalra <hkalra@marvell.com>
Patch adds support for vlan filter offload support.
MBOX messages for vlan filter on/off and vlan filter
entry add/rm are added to configure PCAM entries to
filter out the vlan traffic on a given port.
Patch also defines rx_offload_flag for vlan filtering.
Signed-off-by: Vamsi Attunuru <vattunuru@marvell.com>
Acked-by: Harman Kalra <hkalra@marvell.com>
Adding multi segment support to the octeontx PMD. Also
adding the logic to share rx/tx ofloads with the eventdev
code.
Signed-off-by: Harman Kalra <hkalra@marvell.com>
Remove vector path feature list, if a feature only be supported
in non-vector path, use "P" to represent.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
Remove vector path feature list, if a feature only be supported
in non-vector path, use "P" to represent.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
Remove vector path feature list, if a feature only be supported
in non-vector path, use "P" to represent.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
Remove vector path feature list, if a feature only be supported
in non-vector path, use "P" to represent.
Signed-off-by: Qi Zhang <qi.z.zhang@intel.com>
Acked-by: Xiaolong Ye <xiaolong.ye@intel.com>
The PMDs bnx2x and nfp have a separate column for VF.
Such separation is unneeded because the features are the same.
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
The virtual PMDs bonding, KNI, null, ring, softnic and vdev_netvsc
have no real feature to advertise so they can be removed
from the (too) big matrix of ethdev features.
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Currently, we only support VF device is bound to vfio_pci or igb_uio and
then driven by DPDK driver when PF is driven by kernel mode hns3 ethdev
driver, VF is not supported when PF is driven by hns3 DPDK driver.
This patch adds promiscuous and allmulticast mode support for hns3 VF
PMD driver.
1) The promiscuous/allmulticast mode can be configured successfully only
based on the trusted VF device. If based on the non trusted VF
device, configuring promiscuous/allmulticast mode will fail. The hns3
VF device can be configured as trusted device by hns3 PF kernel
ethdev driver on the host by "ip link set <eth num> vf <vf id> turst
on" command.
2) After the promiscuous mode is configured successfully, hns3 VF PMD
driver can receive the ingress and outgoing traffic. In the words,
all the ingress packets, all the packets sent from the PF and other
VFs on the same physical port.
3) Note: Because of the hardware constraints, By default vlan filter is
enabled and couldn't be turned off based on VF device, so vlan filter
is still effective even in promiscuous mode. If upper applications
don't call rte_eth_dev_vlan_filter API function to set vlan based on
VF device, hns3 VF PMD driver will can't receive the packets with
vlan tag in promiscuous mode.
Signed-off-by: Chengchang Tang <tangchengchang@huawei.com>
Signed-off-by: Wei Hu (Xavier) <xavier.huwei@huawei.com>
This patch adds TCP segment offload support for hns3 PMD driver.
Signed-off-by: Hongbo Zheng <zhenghongbo3@huawei.com>
Signed-off-by: Wei Hu (Xavier) <xavier.huwei@huawei.com>
Only the supported features are supposed to be listed
in the networking features matrix.
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Acked-by: Ferruh Yigit <ferruh.yigit@intel.com>
The dev_ops .get_module_info and .get_module_eeprom
were implemented in mlx5 in DPDK 19.11.
Fixes: 8a6a09f853a0 ("net/mlx5: support reading module EEPROM data")
Cc: stable@dpdk.org
Reported-by: Gal Cohen <galco@mellanox.com>
Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
Get a burst mode information for Rx/Tx queues in mlx5.
Provide callback functions to show this information in
a "show rxq info" and "show txq info" output.
Signed-off-by: Alexander Kozyrev <akozyrev@mellanox.com>
Acked-by: Viacheslav Ovsiienko <viacheslavo@mellanox.com>
Add support for reading the firmware version.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Add basic, per queue and extended statistics for
RX and TX, both from the adapter and the driver.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Add code to manipulate the RSS configuration
used by the adapter.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Add support for managing RX filters based on MAC and VLAN.
Hardware cannot provide the list of filters, thus we keep
a local list.
Add support for promisc and allmulticast modes.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Add support for port start/stop and handle basic features
including MTU and link up/down.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Register the Pensando ionic PMD (net_ionic) and define initial probe
and remove callbacks with adapter initialization.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
Add makefile and config file options to compile the Pensando ionic PMD.
Add feature and version map file.
Update maintainers file.
Signed-off-by: Alfredo Cardigliano <cardigliano@ntop.org>
Reviewed-by: Shannon Nelson <snelson@pensando.io>
At BGX, DMAC filter table can be enabled to allow defined hosts.
Patch implements 'mac_addr_add' and 'mac_addr_remove' ops to
add/remove MAC filters which uses BGX DMAC filter table.
Signed-off-by: Sunil Kumar Kori <skori@marvell.com>
Acked-by: Harman Kalra <hkalra@marvell.com>
This patch adds supports of receive packets through interrupt mode for
hns3 PF/VF driver. The following ops functions should be implemented
defined in the struct eth_dev_ops:
rx_queue_intr_enable
rx_queue_intr_disable
Signed-off-by: Hao Chen <chenhao164@huawei.com>
Signed-off-by: Wei Hu (Xavier) <xavier.huwei@huawei.com>
A new vDPA class was recently introduced.
IFC driver implements the vDPA operations,
hence it should be moved to the vDPA class.
Move it.
Signed-off-by: Matan Azrad <matan@mellanox.com>
Reviewed-by: Maxime Coquelin <maxime.coquelin@redhat.com>
Updating bnxt.ini file.
These features were added earlier under the following commits.
1) 94d4afd2d167 ("net/bnxt: advertise scatter Rx offload capability")
2) 57d5e5bc86e4 ("net/bnxt: add statistics")
3) 88920136688c ("net/bnxt: support xstats get by id")
Signed-off-by: Ajit Khaparde <ajit.khaparde@broadcom.com>
Retrieve burst mode information according to the selected Rx/Tx mode and
offloads.
Signed-off-by: Sunil Kumar Kori <skori@marvell.com>
Acked-by: Jerin Jacob <jerinj@marvell.com>
This patch removes feature "Free Tx mbuf" on demand from hinic.ini
because pmd driver does not support this feature.
Fixes: 1d09792a270a ("net/hinic: add build and doc files")
Cc: stable@dpdk.org
Signed-off-by: Xiaoyun Wang <cloud.wangxiaoyun@huawei.com>
This patch removes deprecated feature Flow Director from hinic.ini,
hinic.rst and release_19_11.rst, because the feature has been
removed from the feature list in the following commit:
Commit 030febb6642c ("doc: remove deprecated ethdev features"), and
adds Flow API feature which is for generic filtering to doc files.
Signed-off-by: Xiaoyun Wang <cloud.wangxiaoyun@huawei.com>
This patch removes deprecated feature 'Flow Director' from hns3.ini
and hns3_vf.ini because the feature has been removed from the
feature list in the following commit:
Commit 030febb6642c ("doc: remove deprecated ethdev features")
Signed-off-by: Wei Hu (Xavier) <xavier.huwei@huawei.com>
Signed-off-by: Chunsong Feng <fengchunsong@huawei.com>
