This fixes "Kernel has only x or y resolution, not both" libinput error.
Reported by: Ivan <bsd@abinet.ru>
Tested by: Ivan <bsd@abinet.ru>
Approved by: gonzo (mentor)
MFC after: 2 weeks
Both relative and absolute multitouch modes are supported.
To enable psm(4) evdev support one should:
1. Add `device evdev` and `options EVDEV_SUPPORT` to kernel config file
2. Add hw.psm.elantech_support=1 or hw.psm.synaptics_support=1 to
/boot/loader.conf for activation of absolute mode on touchpads
3. Add kern.evdev.rcpt_mask=12 to /etc/sysctl.conf to enable psm event
sourcing and disable sysmouse
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10265
Tested by: wulf, Jan Kokemueller (Lenovo devs)
Increase hw.psm.synaptics.min_pressure default value from 16 to 32
to nearly match Linux driver (30-35 hysteresis loop).
This makes libinput tap detection more reliable.
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
It is already included via sys/systm.h
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
models. This change is based on Linux driver.
Determine logical trace size. It used for calculation of touch sizes
in surface units for MT-protocol type B evdev reports.
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
Linux does. It should not affect gesture processing in current state as it
ignores finger coords on 3-finger tap detection but it should make evdev
reports looking more Linux-alike.
Reviewed by: gonzo
Approved by: gonzo
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
This is done with discarding pointer movements rather then mouse packets
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
Elan hw v.4 touchpads often sends touchpad release packet right after
touchpad touch one. Most probably this happens due to PS/2 limited bandwith.
Reducing of tap_min_queue size to 1 makes multifinger tap detection
more reliable in this case.
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
Wait for all advertised head packets after status packet have been received.
This fixes rare but quite annoying issue in Elan hw v.4 touchpads support
when triple-finger taps are reported as double-finger taps under several
circumstances.
Reviewed by: gonzo
Approved by: gonzo (mentor)
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D10266
On laptops like the ThinkPad X240, ClickPad buttons are located at the
top. The hw.psm.synaptics.softbuttons_y sysctl was supposed to allow this
by setting the value to a negative one (e.g. -1700). However, the
condition was wrong (double negative), and doing that placed the buttons
in an unreachable area.
PR: 216342
Submitted by: Greg V <greg@unrelenting.technology>
MFC after: 1 week
With guest trackpoint present trackpoint probing switched synaptics
device to absolute mode with different protocol instead of keeping it
in relative mode.
PR: 213757
Submitted by: Vladimir Kondratyev <wulf@cicgroup.ru>
MFC after: 1 week
- Replace tunables-only hw.psm.synaptics_support, hw.psm.trackpoint_support,
and hw.psm.elantech_support with respective sysctls declared with
CTLFLAG_TUN. It simplifies checking them in userland, also makes them
easier to get discovered by user
- Get rid of debug.psm.loglevel and hw.psm.tap_enabled TUNABLE_INT
declaration by adding CTLFLAG_TUN to read/write sysctls that were
already declared for these tunables.
Suggested by: jhb
Elantech trackpads are found in some laptops like the Asus UX31E. They
are "synaptics compatible" but use a slightly different protocol.
Elantech hardware support is not enabled by default and just like
Synaptic or TrackPoint devices it should be enabled by setting
tunable, in this case hw.psm.elantech_support, to non-zero value
PR: 205690
Submitted by: Vladimir Kondratyev <wulf@cicgroup.ru>
MFC after: 1 week
No functional change, only trivial cases are done in this sweep,
Drivers that can get further enhancements will be done independently.
Discussed in: freebsd-current
absolute position. This seems to be correlated with only removing a single
finger. To work around this report no movement on from the first packet
when the user exits scrolling.
There was a inconsistency which led to enable passthrough commands
being interpreted as actual touchpad commands.
Submitted by: Jan Kokemüller <jan.kokemueller at gmail.com>
MFC after: 1 week
which is default. It was broken in r281441.
It appears that set_trackpoint_parameters() call on resume disables the
mouse. So, we need not call it on resume if hw.psm.trackpoint_support=0.
The problem is that the probe functions are used both for probing and
for reiniting on resume. And the absense of the softc parameter is used
as a mark to distinguish reinit and probe, which is quite ugly. At the
same time the softc parameter is needed to call set_trackpoint_parameters().
o Change the arguments of probefunc_t to always supply the softc, and
use additional enum argument to tell probing from initing.
o Don't call set_trackpoint_parameters() from global doinitialize(),
instead call it from the enable_trackpoint() only.
o In enable_synaptics() call enable_trackpoint() in both probe and
reinit cases.
Together with: Jan Kokemüller <jan.kokemueller gmail.com>
Several improvements to the Synaptics driver to support
semi-multitouch trackpads and some other fixes:
- Two finger scrolling support for "semi-MT" touchpads. Those include
many of the older Synaptics touchpads before "true" multitouch support
(indicated by capMultiFinger). Semi-MT touchpads can report a second
finger position, but the X or Y coordinate may be swapped with some
coordinate of the first finger. This is a result of how the hardware
works internally. Therefore, all that can be reliably extracted is the
bounding box of the two finger positions. Semi-MT touchpads can be
recognized by the capAdvancedGestures capability bit. After setting the
mode byte, advanced gestures mode has to be enabled. Then, data packets
compatible with the capMultiFinger format are sent, so the same two
finger scrolling code can be leveraged. Enabling advanced gestures mode
on true multitouch touchpads should be harmless. Linux seems to always
enable advanced gestures mode.
- Put mode setting logic into own functions synaptics_preferred_mode()
and synaptics_set_mode() to have this in one place.
synaptics_passthrough_on() and synaptics_passthrough_off() currently
always use 0xc1 as the mode byte, which may be wrong for touchpads that
don't have capExtended.
- Expose X and Y resolution of touchpad to userland. Also expose minimum
and maximum X and Y coordinates. This is useful for programs in
userspace that read raw PSM packets (with PSM_LEVEL_NATIVE enabled) and
need to interpret the coordinates.
- Also send "extended w mode" packets (see section 3.2.9 of
511-000275-01_RevB.pdf) to userspace if PSM_LEVEL_NATIVE is enabled.
This is useful for userspace programs/drivers such as
xf86-input-synaptics that can handle these packets.
- Fix parsing of nExtendedQueries, and request extended/continued
capability bits depending on this value.
- capReportsMax, capClearPad, capAdvancedGestures and capCoveredPad must
be extracted from status[0] and not status[2], I think.
Submitted by: Jan Kokemüller jan.kokemueller at gmail.com
On trackpads that had support for both, we were sending two button
events when the trackpad was pressed.
Tested by: Jakob Alvermark <jakob at alvermark.net>
MFC after: 1 week
To accomplish this, we must put the Synaptics hardware in passthrough
mode when talking to the trackpoint.
I only performed minor style modifications.
Submitted by: Jan Kokemüller <jan.kokemueller at gmail.com>
MFC after: 1 week
Enable two finger scrolling by default and disable the edge scrolling if
the touchpad has no physical zone for it. Disable directional scrolling
by default to avoid using extended buttons as scroll buttons.
Add support for ClickPad. On Lenovo laptops, this is the button
reported when one presses the touchpad.
While there, fix a problem where the extended buttons were not reporting
the button release event correctly: we need to save the state of the
buttons and report it to sysmouse until we receive a packet from the
touchpad indicating the button has been released. This makes it
possible to use an extended button to resize a window. On Lenovo
laptops, the major buttons are actually reported as extended buttons.
Tested by: many (current@)
MFC after: 1 week
This probably supports other devices based on SeaBIOS, which need
to be added to the smbios based quirks table.
The functionality has been ported from DragonFlyBSD and adapted
to FreeBSD's more general purpose environment.
Devices not covered by a quirk shouldn't be affected at all. Thanks
to jhb and kostikbel for reviewing the code.
Reviewed by: kostikbel, jhb
Approved by: jhb, kostikbel
Differential Revision: https://reviews.freebsd.org/D1802
It turns out that synaptics_support was turned off by default
because its probing method is too intrusive not because it was unstable.
Once this is fixed it should be enabled once again.
Reported by: delphij, jkim
Starting with firmware v7.5, the "Read TouchPad Modes" ($01) and "Read
Capabilities" ($02) commands changed: previously constant bytes now
carry variable information.
We now compare those bytes to expected constants only for firmware prior
to v7.5.
Tested by: Zeus Panchenko <zeus@gnu.org.ua>
MFC after: 1 week
- Make INITAFTERSUSPEND flag independent of HOOKRESUME flag.
- Automatically set INITAFTERSUSPEND flag when ALPS GlidePoint is detected.
- Always probe Synaptics Touchpad. Allow MOUSE_SYN_GETHWINFO ioctl and
automatically set INITAFTERSUSPEND flag when a supported device is detected,
regardless of "hw.psm.synaptics_support" tunable setting.
- Update psm(4) to reflect the above changes.
- Remove long-time defunct SYNCHACK flag while I am in the neighborhood.
MFC after: 1 month
The SYSCTL_NODE macro defines a list that stores all child-elements of
that node. If there's no SYSCTL_DECL macro anywhere else, there's no
reason why it shouldn't be static.
delete the IRQ resource from the psmcpnp device completely.
- Don't allocate the IRQ resource shared. It is not a shareable interrupt
on ISA. The bus driver can set RF_SHAREABLE if the IRQ is actually
shareable on a non-ISA bus.
This tunable allows one to enable (1) or disable (0) gestures like tap
and tap-hold on Synaptics TouchPad when the Extended mode isn't enabled
(ie. "hw.psm.synaptics_support" not set).
By default, the value is -1 in order to keep the current behaviour of
not enabling/disabling gestures explicitly.
PR: kern/139272
Submitted by: David Horn <dhorn2000 AT gmail DOT com>
Reviewed by: David Horn <dhorn2000 AT gmail DOT com>
The newbus lock is responsible for protecting newbus internIal structures,
device states and devclass flags. It is necessary to hold it when all
such datas are accessed. For the other operations, softc locking should
ensure enough protection to avoid races.
Newbus lock is automatically held when virtual operations on the device
and bus are invoked when loading the driver or when the suspend/resume
take place. For other 'spourious' operations trying to access/modify
the newbus topology, newbus lock needs to be automatically acquired and
dropped.
For the moment Giant is also acquired in some key point (modules subsystem)
in order to avoid problems before the 8.0 release as module handlers could
make assumptions about it. This Giant locking should go just after
the release happens.
Please keep in mind that the public interface can be expanded in order
to provide more support, if there are really necessities at some point
and also some bugs could arise as long as the patch needs a bit of
further testing.
Bump __FreeBSD_version in order to reflect the newbus lock introduction.
Reviewed by: ed, hps, jhb, imp, mav, scottl
No answer by: ariff, thompsa, yongari
Tested by: pho,
G. Trematerra <giovanni dot trematerra at gmail dot com>,
Brandon Gooch <jamesbrandongooch at gmail dot com>
Sponsored by: Yahoo! Incorporated
Approved by: re (ksmith)
o better quality of the movement smoothing
o more features such as tap-hold and virtual scrolling
Support must still be enabled with this line in your /boot/loader.conf:
hw.psm.synaptics_support="1"
The following sysctls were removed:
hw.psm.synaptics.low_speed_threshold
hw.psm.synaptics.min_movement
hw.psm.synaptics.squelch_level
An overview of this new driver and a short documentation about the added
sysctls is available on the wiki:
http://wiki.freebsd.org/SynapticsTouchpad
