r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked).
Use it in preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Mark all obvious cases as MPSAFE. All entries that haven't been marked
as MPSAFE before are by default marked as NEEDGIANT
Approved by: kib (mentor, blanket)
Commented by: kib, gallatin, melifaro
Differential Revision: https://reviews.freebsd.org/D23718
Add support for the second channel to bcm2835_pwm driver. Configurable
parameters like mode, period, ratio are exposed as sysctls with postfix '2',
e.g.: dev.pwm.N.mode2, dev.pwm.N.period2, dev.pwm.N.ratio2
Second channel can be enabled in DTB by configuring pwn-2chan overlay
instead of pwm in config.txt. See [1]
[1] https://github.com/raspberrypi/firmware/blob/master/boot/overlays/README
Submitted by: Bob Frazier
Differential Revision: https://reviews.freebsd.org/D15769
Switch to standard FDT-base driver behavior and don't attach
if node "status" property value nn DTS is not set to "okay"
On RPi PWM by default is disabled, to enable it pwm.dtbo
from official repo[1] should be copied to overlays directory
on SD card FAT partition and "dtoverlay=pwm" line added to
config.txt. For more details see pwm overlay documentation[2]
sysutils/rpi-firmware port now includes overlays, so they
can be installed as a part of release image build.
[1] https://github.com/raspberrypi/firmware/tree/master/boot
[2] https://github.com/raspberrypi/firmware/blob/master/boot/overlays/README
No objections from: phk@
On Raspberry Pi platform GPIO controller also responsible for pins
multiplexing. Pi code predates proper FDT support in FreeBSD so a
lot of pinmux info is hardcoded. This patch:
- Implements pinctl methods in bcm2835_gpio
- Converts all devices with ad-hoc pinmux info to proper pin control
mechanisms and adds pinmux info in FreeBSD's custom dts files.
- Adds fdt_pinctrl option to RPI2 and RPI-B kernels
- Adds SPI pinmux config to FreeBSD's customization of GNU DTS.
Reviewed by: imp, manu
Differential Revision: https://reviews.freebsd.org/D14104
instead of frobbing the registers directly.
As a hack the bcm2835_pwm kmod presently ignores the 'status="disabled"'
in the RPI3 DTB, assuming that if you load the kld you probably
want the PWM to work.