This adds HardenedBSD which is a pseudo-fork of FreeBSD. It hasn't had a
release yet, but does does have active users and a community. As such
document it as a branch off of FreeBSD-stable. Ideally this adds enough
space so that future releases are easy enough to add.
Resolve a minor mismatch: TXP_CMD_READ_VERSION instead of
TXP_CMD_VERSIONS_READ.
Curiously the later is defined but not used in OpenBSD.
Obtained from: OpenBSD (CVS 1.31-1.34)
MFC after: 1 week
draft of a never-finalized standard (CHRP) and is irrelevant in practice
on FreeBSD since we load the kernel with loader(8) on Open Firmware
platforms anyway. Moreover, loader(8), which is directly loaded by Open
Firmware, has never had an equivalent note.
MFC after: 2 weeks
Fix for remainder overflow, when in rare cases adding remainder to divider
exceeded 1 and turned the total to 1000 in final formatting, taking up
the space for the unit character.
The fix continues the division of the original number if the above case
happens -- added the appropriate check to the for loop performing
the division. This lowers the value shown, to make it fit into the buffer
space provided (1.0M for 4+1 character buffer, as used by ls).
Add test case for the reported bug and extend test program to support
providing buffer length (ls -lh uses 5, tests hard-coded 4).
PR: 224498
Submitted by: Pawel Biernacki <pawel.biernacki@gmail.com>
Reported by: Masachika Ishizuka <ish@amail.plala.or.jp>
Reviewed by: cem, kib
Approved by: cem, kib
MFC after: 1 week
Sponsored by: Mysterious Code Ltd.
Differential Revision: D13578
Reviewed by: alc, markj (as part of the larger patch)
Tested by: pho (again, as part of the larger patch)
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D13671
(now: Interrupt_Index[15]) and assigned the previously reserved bits
55:48 (Interrupt_Index[14:0] goes into 63:49 while Destination Field
used 63:56 and bit 48 now is Interrupt_Format) in the IO redirection
tables (see the VT-d specification, "5.1.5.1 I/OxAPIC Programming").
Thus, when not using interrupt remapping, ensure that all previously
reserved bits in the high part of the RTEs are zero instead of doing
a read-modify-write for their Destination Field bits only.
Otherwise, on machines based on Apollo Lake and its derivatives such
as Denverton, typically some of the previously preserved bits remain
set after boot when not employing interrupt remapping. The result is
that INTx interrupts are not getting delivered.
Note: With an AMD IOMMU, interrupt remapping apparently bypasses the
IO APIC altogether.
Submitted by: loos (modulo comment)
Reviewed by: jhb (modulo comment)
In the case of a simple dtbo where fragment uses target-path and the overlay
contains no references, /__fixups__ will not be included by either our dtc
or dtc from ports, but the file still has valid fragments to be applied.
Additional testing found that /__symbols__ might also be omitted if it's
empty, which is not necessarily an error.
Reviewed by: gonzo, imp
Differential Revision: https://reviews.freebsd.org/D13663
fdt_load_dtb_overlays was written to unload previous overlay when a new
valid one is come across. fdt_apply_overlays further down is written to
iterate over all .dtbo's currently loaded and apply them one-by-one. Correct
fdt_load_dtb_overlays to stop dropping valid overlays that were previously
loaded and match expectations.
Reviewed by: gonzo, imp
Differential Revision: https://reviews.freebsd.org/D13659
This bring back r327293 from OpenBSD, with the important difference that
we are now getting it from their ip6_id.c file.
Obtained from: OpenBSD (CVS v1.3)
correct non-repetitive ID code, based on comments from niels provos.
- seed2 is necessary, but use it as "seed2 + x" not "seed2 ^ x".
- skipping number is not needed, so disable it for 16bit generator (makes
the repetition period to 30000)
Obtained from: OpenBSD (CVS rev. 1.2)
MFC after: 1 week
netinet6/ip6_id.c: niels kindly dropped clause 3/4 from the license.
I was looking at the wrong file. There is an important merge that must be
done before I can bring this change.
This file is supposed to be based on the OpenBSD CVS v1.6 but checking
the OpenBSD repository the license had already dropped the 2&3 clasues by
then. Catch up with the licensing.
Obtained from: OpenBSD (CVS 1.2)
Most notable, other than some style issues:
CVS 1.11:
do not use LOG_CONS.
CVS 1.13:
consistently use exit instead of return in main().
use LOG_WARNING instead of LOG_ERR for non critical errors.
Obtained from: NetBSD
MFC after: 2 weeks
Make it easier to identify the point where we started diverging from
NetBSD. Newer versions of this file has been updated to a new license so
this information may become useful some day.
Obtained from: NetBSD
Make it easier to identify the point where we started diverging from
NetBSD. Newer versions of these files have been updated to a new license
so this information may become useful some day.
Obtained from: NetBSD
The existing algorithm in procfs_map() to calculate count of resident
pages in an entry is too primitive, resulting in too long run time for
large sparse mapping entries. Re-use the kern_proc_vmmap_resident()
from kern_proc.c which only looks at the existing pages in the
iterations.
Also, this makes procfs to honor kern.proc_vmmap_skip_resident_count,
if user does not need this information.
Reported by: Glenn Weinberg <glenn.weinberg@intel.com>
PR: 224532
No objections from: des (procfs maintainer)
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D13595
vmmap_skip_res_cnt control check inside it.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Differential revision: https://reviews.freebsd.org/D13595
