Use a machdep.nirq tunable intead of compile-time constant NIRQ
as a value for maximum number of interrupts. It allows keep a system
footprint small by default with an option to increase the limit
for large systems like server-grade ARM64
Reviewd by: mhorne
Differential Revision: https://reviews.freebsd.org/D27844
Submitted by: Klara, Inc.
Sponsored by: Ampere Computing
Module name (unlike of the of driver name) must be system wide unique.
Reported by: Mark Millard(bcm_pci), andrew(mvebu_gpio)
MFC with: r362954, r362385
The AXI bridge is different between ARMADA 38x and 8K, and both platforms
needs specific setup to mitigate HW issues with accessing RTC registers.
MFC after: 2 weeks
r347343 split generic xhci driver into three files.
Include generic_xhci_fdt.c when building kernel for Armada SoCs.
This brings back XHCI support on these platforms and also
others, which use GENERIC config.
Submitted by: Kornel Duleba
Obtained from: Semihalf
MFC after: 1 week
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D24944
Name each pcib driver uniquely.
This remove the warning printed at each arm boot :
module_register: cannot register simplebus/pcib from kernel; already loaded from kernel
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked).
Use it in preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Mark all obvious cases as MPSAFE. All entries that haven't been marked
as MPSAFE before are by default marked as NEEDGIANT
Approved by: kib (mentor, blanket)
Commented by: kib, gallatin, melifaro
Differential Revision: https://reviews.freebsd.org/D23718
Delay the attachment of children, when requested, until after interrutps are
running. This is often needed to allow children to run transactions on i2c or
spi busses. It's a common enough idiom that it will be useful to have its own
wrapper.
Reviewed by: ian
Differential Revision: https://reviews.freebsd.org/D21465
While here, call device_delete_children() to detach and dealloc all the
existent children and handle the child's detach errors properly.
Reported by: jenkins, hselasky, ian
Sponsored by: Rubicon Communications, LLC (Netgate)
Interrupt based driver, implements SPI mode and clock configuration.
Tested on espressobin and SG-3200.
Sponsored by: Rubicon Communications, LLC (Netgate)
This controller is a bit tricky as the STOP condition must be indicated in
the last tranferred byte, some devices will not like the repeated start
behavior of this controller. A proper fix to this issue is in the works.
This driver works in polling mode, can be used early in the boot (required
in some cases).
Tested on espressobin/SG-1100 and the SG-3200.
Obtained from: pfSense
Sponsored by: Rubicon Communications, LLC (Netgate)
in simple multifunction driver.
- follow interrupt changes in DT. Split old ICU driver to function oriented
parts and add drivers for newly defined parts (system error interrupts).
- Many drivers are children of simple multifunction driver. But after r349596
simple MF driver doesn't longer exports memory resources, and all children
must use syscon interface to access their registers. Adapt affected
drivers to this fact.
MFC after: 3 weeks
The fdt node for this driver is a simple-mfd and syscon compatible one
meaning that simplemfd will be the driver attached for it. The gpio driver
is attached to the 'gpio' subnode so use syscon_get_handle_default to
obtain the handle of the syscon from the parent device and use this
to read/write to the memory region.
MFC after: 1 week
Since r349596 the syscon driver will map the memory. Since the gpio/pinctrl
controller wants it too set it to SHAREABLE.
This fix the gpio controller for attaching and so consumer can use it.
Now the sdhci_xenon driver can detect presence of an sdcard and attach
the mmc driver.
MFC after: 1 week
Nothing uses these anymore. They were for super small armv4 boards without
uboot. We removed armv4 support before 13.0, but neglected to garbage collect
this at the same time. Today, both flavors of armv5 kernels (mv and ralink) boot
via uboot which has its own compression scheme for boards that need it.
Note: OLDFILES has not been updated beacuse installkernel will move the whole
directory out of the way before installing the new kernel.
Differential Revision: https://reviews.freebsd.org/D21072
NANDFS has been broken for years. Remove it. The NAND drivers that
remain are for ancient parts that are no longer relevant. They are
polled, have terrible performance and just for ancient arm
hardware. NAND parts have evolved significantly from this early work
and little to none of it would be relevant should someone need to
update to support raw nand. This code has been off by default for
years and has violated the vnode protocol leading to panics since it
was committed.
Numerous posts to arch@ and other locations have found no actual users
for this software.
Relnotes: Yes
No Objection From: arch@
Differential Revision: https://reviews.freebsd.org/D20745
The A3700 has a different GPIO controller and thus, do not use the old (and
shared) code for Marvell.
The pinctrl driver, also part of the controller, is not supported yet (but
the implementation should be straightforward).
Sponsored by: Rubicon Communications, LLC (Netgate)
This allows replacing "sys/eventfilter.h" includes with "sys/_eventfilter.h"
in other header files (e.g., sys/{bus,conf,cpu}.h) and reduces header
pollution substantially.
EVENTHANDLER_DECLARE and EVENTHANDLER_LIST_DECLAREs were moved out of .c
files into appropriate headers (e.g., sys/proc.h, powernv/opal.h).
As a side effect of reduced header pollution, many .c files and headers no
longer contain needed definitions. The remainder of the patch addresses
adding appropriate includes to fix those files.
LOCK_DEBUG and LOCK_FILE_LINE_ARG are moved to sys/_lock.h, as required by
sys/mutex.h since r326106 (but silently protected by header pollution prior
to this change).
No functional change (intended). Of course, any out of tree modules that
relied on header pollution for sys/eventhandler.h, sys/lock.h, or
sys/mutex.h inclusion need to be fixed. __FreeBSD_version has been bumped.
Add parentheses to perform assignment before comparison. The prior
condition worked because fdt_parent_addr_cells returns 1 for the DTB
on which fdt_fixup_ranges is called and accidentally par_addr_cells
ends up to be set to the same value.
PR: 210705
Submitted by: David Binderman <dcb314@hotmail.com>
MFC after: 1 week
mv_pci driver reads PCI memory window layout from DTB data and if the
data is incomplete falls back to default value. The value is too small
to fit two PCI spaces for mwlwifi devices on WRT3200ACM so the resource
allocation for them fails. Increase the default to 4Mb from 1Mb so
the devices can be properly attached.
MFC after: 1 week
icu is a interrupt concentrator in the CP110 block and gicp
is a gic extension to allow interrupts in the CP block to be turned
into GIC SPI interrupts
Sponsored by: Rubicon Communications, LLC ("Netgate")
The cp110 clock controller controls the clocks and gate of the CP110
hardware block.
Every clock/gate are implemented except the NAND clock.
Sponsored by: Rubicon Communications, LLC ("Netgate")
The first two clocks are for the clusters and their frequencies can be
found reading a register. Then a fixed 1200Mhz clock is present and two
fixed clocks, 'mss' which is 1200 / 6 and 'sdio' which is 1200 / 3.
Sponsored by: Rubicon Communications, LLC ("Netgate")
Add generic implementation for bus_deactivate_resource method. Without
it bus_release_resource fails with "Failed to release active resource"
message
MFC after: 1 week
recent changes in spibus and allow the use of different SPI modes on
the same bus.
Reported by: ian
Sponsored by: Rubicon Communications, LLC (Netgate)
Marvell SoC identification function was called by SYSINIT on all armv7
platforms, which brakes platforms other than Marvell built with
GENERIC config. Fix this by shifting SoC identifying to Marvell platform
initialization.
Submitted by: Patryk Duda <pdk@semihalf.com>
Reviewed by: manu
Tested by: manu
Obtained from: Semihalf
Sponsored by: Stormshield
This patch replaces in-driver FDT parsing, which was
needed for setting initial values on GPIO pins.
Now FDT is parsed by generic kernel code, pins are set
by invoking gpio_map_gpios method.
Submitted by: Patryk Duda <pdk@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D14757
This patch implements and exports functions described
in gpio_if.m file. It also uses new gpiobus_attach_bus function
instead of adding gpioc and gpiobus as children. It removes
ulgy reading SoC ID and related if..else, so it depends only on
data read from FDT.
Submitted by: Patryk Duda <pdk@semihalf.com>
Reviewed by: manu
Obtained from: Semihalf
Sponsored by: Stormshield
Differential Revision: https://reviews.freebsd.org/D14756
